DataSheetWiki


PCU9655 fiches techniques PDF

NXP Semiconductors - 16-channel UFm 5MHz bus 100mA 40V LED driver

Numéro de référence PCU9655
Description 16-channel UFm 5MHz bus 100mA 40V LED driver
Fabricant NXP Semiconductors 
Logo NXP Semiconductors 





1 Page

No Preview Available !





PCU9655 fiche technique
PCU9655
16-channel UFm 5 MHz bus 100 mA 40 V LED driver
Rev. 2 — 2 October 2012
Product data sheet
1. General description
The PCU9655 is a UFm I2C-bus controlled 16-channel LED driver optimized for voltage
switch dimming and blinking 100 mA Red/Green/Blue/Amber (RGBA) LEDs. Each LED
output has its own 8-bit resolution (256 steps) fixed frequency individual PWM controller
that operates at approximately 31.25 kHz with a duty cycle that is adjustable from 0 % to
99.6 % to allow the LED to be set to a specific brightness value. An additional 8-bit
resolution (256 steps) group PWM controller has both a fixed frequency of about 122 Hz
and an adjustable frequency roughly between 15 Hz to once every 16.8 seconds with a
duty cycle that is adjustable from 0 % to 99.6 % that is used to either dim or blink all LEDs
with the same value.
Each LED output can be off, on (no PWM control), set at its individual PWM controller
value or at both individual and group PWM controller values. The PCU9655 operates with
a supply voltage range of 3 V to 5.5 V and the 100 mA open-drain outputs allow voltages
up to 40 V.
The PCU9655 is one of the first LED controller devices in a new Ultra Fast mode (UFm)
family. UFm devices offer higher frequency (up to 5 MHz).
Software programmable LED Group and three Sub Call I2C-bus addresses allow all or
defined groups of PCU9655 devices to respond to a common I2C-bus address, allowing
for example, all red LEDs to be turned on or off at the same time, thus minimizing I2C-bus
commands. On power-up, PCU9655 will have a unique Sub Call address to identify it as a
16-channel LED driver. This allows mixing of devices with different channel widths. Five
hardware address pins on PCU9655 allow up to 32 devices on the same bus.
The Software Reset (SWRST) function allows the master to perform a reset of the
PCU9655 through the I2C-bus, identical to the Power-On Reset (POR) that initializes the
registers to their default state causing the output voltage switches to be OFF (LED off).
This allows an easy and quick way to reconfigure all device registers to the same
condition.
Additionally, a thermal shutdown feature protects the device when the internal junction
temperature exceeds the overtemperature threshold.

PagesPages 30
Télécharger [ PCU9655 ]


Fiche technique recommandé

No Description détaillée Fabricant
PCU9654 8-bit UFm 5MHz I2C-bus 100mA 40V LED driver NXP Semiconductors
NXP Semiconductors
PCU9655 16-channel UFm 5MHz bus 100mA 40V LED driver NXP Semiconductors
NXP Semiconductors
PCU9656 24-bit UFm 5MHz I2C-bus 100mA 40V LED driver NXP Semiconductors
NXP Semiconductors

US18650VTC5A

Lithium-Ion Battery

Sony
Sony
TSPC106

PCI Bus Bridge Memory Controller

ATMEL
ATMEL
TP9380

NPN SILICON RF POWER TRANSISTOR

Advanced Semiconductor
Advanced Semiconductor


www.DataSheetWiki.com    |   2020   |   Contactez-nous  |   Recherche