DataSheetWiki


HCNW4504 fiches techniques PDF

AVAGO - High Speed Optocouplers

Numéro de référence HCNW4504
Description High Speed Optocouplers
Fabricant AVAGO 
Logo AVAGO 





1 Page

No Preview Available !





HCNW4504 fiche technique
HCPL-4504/J454/0454, HCNW4504
High CMR, High Speed Optocouplers
Data Sheet
Lead (Pb) Free
RoHS 6 fully
compliant
RoHS 6 fully compliant options available;
-xxxE denotes a lead-free product
Description
The HCPL-4504 and HCPL-0454 contain a GaAsP LED
while the HCPL-J454 and HCNW4504 contain an AlGaAs
LED. The LED is optically coupled to an integrated high
gain photo detector.
The HCPL-4504 series has short propagation delays and
high CTR. The HCPL-4504 series also has a guaranteed
propagation delay difference (tPLH-tPHL). These features
make the HCPL-4504 series an excellent solution to IPM
inverter dead time and other switching problems. The
CTR, propagation delay, and CMR are specified both for
TTL and IPM conditions which are provided for ease of
application. These single channel, diode-transistor opto-
couplers are available in 8-Pin DIP, SO-8, and Widebody
package configurations. An insulating layer between a
LED and an integrated photodetector provide electrical
insulation between input and output. Separate connec-
tions for the photodiode bias and output-transistor col-
lector increase the speed up to a hundred times that of
a conventional phototransistor coupler by reducing the
base collector capacitance.
Functional Diagram
NC 1
ANODE 2
CATHODE 3
NC 4
8 VCC
7 NC
6 VO
5 GND
TRUTH TABLE
LED
ON
OFF
VO
LOW
HIGH
A 0.1 μF bypass capacitor between pins 5 and 8 is recommended.
Schematic
ICC 8
VCC
+
ANODE
2
VF
CATHODE
3
IF
SHIELD
IO 6
VO
5
GND
Features
Short propagation delays for TTL and IPM applications
15 kV/μs minimum Common Mode Transient immu-
nity at VCM = 1500 V for TTL/load drive
High CTR at TA = 25°C
>25% for HCPL-4504/0454
>23% for HCNW4504
>19% for HCPL-J454
Electrical specifications for common IPM applications
TTL compatible
Open collector output
Safety approval:
UL recognized
– 3750 V rms/1min. for HCPL-4504/0454/J454
– 5000 V rms/1min. for HCPL-4504 Option 020 and
HCNW4504
CSA approved
IEC/EN/DIN EN 60747-5-2 approved
– VIORM = 560 Vpeak for HCPL-0454 Option 060
– VIORM = 630 Vpeak for HCPL-4504 Option 060
– VIORM = 891 Vpeak for HCPL-J454
– VIORM = 1414 Vpeak for HCNW4504
Applications
Inverter circuits and Intelligent Power Module (IPM)
interfacing: High Common Mode Transient immunity
(> 10 kV/μs for an IPM load/drive) and (tPLH - tPHL)
Specified (see Power Inverter Dead Time section)
Line receivers: Short propagation delays and low in-
put-output capacitance
High speed logic ground isolation: TTL/TTL, TTL/
CMOS, TTL/LSTTL
Replaces pulse transformers: Save board space and
weight
Analog signal ground isolation: Integrated photode-
tector provides improved linearity over phototransis-
tors
CAUTION: It is advised that normal static precautions be taken in handling and assembly
of this component to prevent damage and/or degradation which may be induced by ESD.

PagesPages 19
Télécharger [ HCNW4504 ]


Fiche technique recommandé

No Description détaillée Fabricant
HCNW4502 Single Channel/ High Speed Optocouplers Agilent(Hewlett-Packard)
Agilent(Hewlett-Packard)
HCNW4502 High Speed Optocouplers Avago
Avago
HCNW4503 Single Channel/ High Speed Optocouplers Agilent(Hewlett-Packard)
Agilent(Hewlett-Packard)
HCNW4503 High Speed Optocouplers Avago
Avago

US18650VTC5A

Lithium-Ion Battery

Sony
Sony
TSPC106

PCI Bus Bridge Memory Controller

ATMEL
ATMEL
TP9380

NPN SILICON RF POWER TRANSISTOR

Advanced Semiconductor
Advanced Semiconductor


www.DataSheetWiki.com    |   2020   |   Contactez-nous  |   Recherche