DataSheetWiki


A1360 fiches techniques PDF

Allegro - Low-Noise Programmable Linear Hall Effect Sensor ICs

Numéro de référence A1360
Description Low-Noise Programmable Linear Hall Effect Sensor ICs
Fabricant Allegro 
Logo Allegro 





1 Page

No Preview Available !





A1360 fiche technique
A1360, A1361, and A1362
Low-Noise Programmable Linear Hall Effect Sensor ICs with
Adjustable Bandwidth (50 kHz Maximum) and Analog Output
Features and Benefits
1 mm case thickness provides greater coupling for current
sensing applications
Customer programmable offset and sensitivity
Factory programmed 0% / °C sensitivity temperature coefficient
Programmability at end-of-line
Selectable unipolar or bipolar quiescent voltage levels
Selectable sensitivity ranges between 0.7 and 1.4 mV/G (A1360),
1.4 to 4.5 mV/G (A1361) and 4.5 to 16 mV/G (A1362)
Device bandwidth selectable under 50 kHz, via capacitor on
FILTER pin
Ratiometric sensitivity, quiescent voltage output, and clamps for
interfacing with application DAC
Temperature-stable quiescent voltage output and sensitivity
Precise recoverability after temperature cycling
Output voltage clamps provide short circuit diagnostic capabilities
Wide ambient temperature range: – 40°C to 150°C
Resistant to mechanical stress
Package: 4 pin SIP (suffix KT)
1 mm case thickness
Not to scale
Description
New applications for linear output Hall effect sensing, such
as current measurement, require both high accuracy and
increased sensor bandwidth. The Allegro® A1360, A1361,
and A1362 programmable linear Hall effect sensor ICs are
designed specifically to achieve both goals. Available in a
through-hole SIP (single in-line package), the A136x Hall
effect sensor ICs are sensitive and temperature-stable. The
accuracy of these devices is enhanced via programmability on
the device VOUT pin. A capacitor to ground on the FILTER
pin on the A136x can be used to tune the device bandwidth in
a range less than 50 kHz.
These ratiometric Hall effect sensor ICs provide a voltage
output that is proportional to the applied magnetic field. The
quiescent output voltage is user-adjustable around either
50% (bidirectional configuration) or 10% (unidirectional
configuration) of the supply voltage,VCC.The device sensitivity
is adjustable within three guaranteed ranges: 0.7 to 1.4 mV/G
(A1360), 1.4 to 4.5 mV/G (A1361), and 4.5 to 16 mV/G
(A1362).
Each BiCMOS monolithic circuit integrates a Hall element,
temperature-compensation circuitry to reduce the intrinsic
sensitivity drift of the Hall element, a small-signal high-gain
amplifier, a clamped low-impedance output stage, and a
proprietary dynamic offset cancellation technique.
Continued on the next page…
V+
VCC
Ratiometric
Hall Drive
C.BYPASS
Functional Block Diagram
Sensitivity
Program/Lock
Trim Control
Sensitivity
Temperature
Coefficient
Offset
To subcircuits
Signal Recovery
+
+
FILTER
VOUT
(Programming)
A1360-DS, Rev. 3
GND

PagesPages 25
Télécharger [ A1360 ]


Fiche technique recommandé

No Description détaillée Fabricant
A1360 PNP Transistor - 2SA1360 Toshiba
Toshiba
A1360 Low-Noise Programmable Linear Hall Effect Sensor ICs Allegro
Allegro
A1361 Low-Noise Programmable Linear Hall Effect Sensor ICs Allegro
Allegro
A1362 Low-Noise Programmable Linear Hall Effect Sensor ICs Allegro
Allegro

US18650VTC5A

Lithium-Ion Battery

Sony
Sony
TSPC106

PCI Bus Bridge Memory Controller

ATMEL
ATMEL
TP9380

NPN SILICON RF POWER TRANSISTOR

Advanced Semiconductor
Advanced Semiconductor


www.DataSheetWiki.com    |   2020   |   Contactez-nous  |   Recherche