DataSheet.es    


PDF CDP-RX-02ANP Data sheet ( Hoja de datos )

Número de pieza CDP-RX-02ANP
Descripción UHF Narrow band radio data module
Fabricantes CIRCUIT DESIGN 
Logotipo CIRCUIT DESIGN Logotipo



Hay una vista previa y un enlace de descarga de CDP-RX-02ANP (archivo pdf) en la parte inferior de esta página.


Total 23 Páginas

No Preview Available ! CDP-RX-02ANP Hoja de datos, Descripción, Manual

OPERATION GUIDE
UHF Narrow band radio data module
CDP-TX/RX-02N 434 MHz/458MHz
Operation Guide
Version 1.6 (September 2003)
OG_CDP-02N_v16e
CIRCUIT DESIGN, INC.
7557-1 Hotaka, Hotaka-machi,
Minamiazumi, Nagano 399-8303 JAPAN
Tel: + +81-(0)263-82-1024
Fax: + +81-(0)263-82-1016
http://www.circuitdesign.jp

1 page




CDP-RX-02ANP pdf
OPERATION GUIDE
CDP-RX-02N receiver module
The CDP-RX-02N is a UHF receiver for FM-narrow band modulated signals.
The receiver design is based on the double superheterodyne principle with PLL synthesize
system and micro controller enabling high signal sensitivity, high selectivity, and high
frequency stability not achieved by simple SAW resonator receivers or other low cost designs.
Extensive filtering by an integrated unique SAW filter element enables operation in hazardous
areas where interference may be expected. Steadily increasing use of the available
frequency spectrum demands the application of narrow band systems for maximum operation
reliability and consideration for other users of the ISM band.
The CDP-RX-02N receiver module is designed to match the CDP-TX-02N transmitter module,
though signals from other FM-narrow band transmitters can be received as well.
The CDP-RX-02N is designed for mounting on a PCB. A simple wire can be soldered to the
antenna input or the antenna can be printed on the PC board. Better performance is attained
with commercial antennas for the 433 MHz (458MHz) ISM band.
The receiver modules have two different outputs and an RSSI field power output which
indicates the power of the incoming RF signal.
The AF output is the analog output from the FM detector circuit. Voltage level, DC-offset and
AF noise depend directly on the receiver-input signal. This output can be connected to an
MSK decoder circuit if a transmitter with an additional MSK encoder is used*1. For simple
FSK modulation of digital data, the DATA OUT terminal can be used. It contains a band-pass
filter and comparator with digital output (open collector).
To achieve high signal sensitivity and a short receiver response time no internal muting is
applied. Valid data signals can be detected by utilizing the RSSI output.
*1 The data input of the CDP-TX-02N is for digital signals. If the output of the MSK encoder is input in
DATA IN of the CDP-TX-02N, please make sure to input a digitalized signal in DATA IN by saturating
the signal beforehand.
OG_CDP-02N_v16e
5 Circuit Design, Inc.

5 Page





CDP-RX-02ANP arduino
SPECIFICATIONS
OPERATION GUIDE
CDP-TX-02(A)NP/CDP-RX-02(A)NP
COMMON SPECIFICATIONS:
COMMUNICATION TYPE
OSCILLATION SYSTEM
FREQUENCY 433 MHZ
458 MHz
NUMBER OF RF CHANNELS
CHANNEL STEP
FREQUENCY STABILITY
FREQUENCY RESPONSE
BAUD RATE
OPERATING TEMPERATURE RANGE
One way
PLL controlled VCO
433.875 MHz to 434.650 MHz
458.525 MHz to 458.775 MHz
32 channels (EU type), 11 channels (UK type)
25 kHz
+/-2.5 kHz (-10 to 55C)
150 Hz to 2.4 kHz
300 to 4,800 bps
-10 to +60C
TRANSMITTER :
TRANSMITTER TYPE
RF OUTPUT POWER
TRANSMITTER START UP TIME
MODULATION
DATA INPUT LEVEL
INPUT SIGNAL
DEVIATION
SPURIOUS EMISSION
ADJACENT CHANNEL POWER
SUPPLY VOLTAGE
SUPPLY CURRENT
DIMENSIONS
WEIGHT
PLL Synthesizer
10 mW/5 mW
About 80 mS (EU type); 90 mS (UK type)
FM narrow
2.2 to 12 V
Digital
2 KHz +/-300 Hz
<-60 dBm (<862 MHz)
<-46 dBm (862 MHz or higher)
<200 nW
2.4 to 10 V
30 mA
36 x 26 x 10 mm
12.5 g
RECEIVER :
RECEIVER TYPE
SENSITIVITY
SELECTIVITY
DEMODULATION
DISTORTION
S/N RATIO
DATA OUTPUT LEVEL
OTHER OUTPUT
SUPPLY VOLTAGE
SUPPLY CURRENT
DIMENSIONS
WEIGHT
Double superheterodyne PLL synthesizer
-120 dBm (12 dB/ SINAD, CCITT filter)
+/-7.5 KHz at -6 dB point
FM narrow
<3 % at 1 KHz
35 dB overall (AF OUT)
Open collector (digital)
RSSI and AF
3.6 to 12 V
26 mA
50 x 30 x 9 mm
19 g
OG_CDP-02N_v16e
11 Circuit Design, Inc.

11 Page







PáginasTotal 23 Páginas
PDF Descargar[ Datasheet CDP-RX-02ANP.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
CDP-RX-02ANUHF Narrow band radio data moduleCIRCUIT DESIGN
CIRCUIT DESIGN
CDP-RX-02ANPUHF Narrow band radio data moduleCIRCUIT DESIGN
CIRCUIT DESIGN

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar