DataSheet.es    


PDF CLAA215FA01-V2 Data sheet ( Hoja de datos )

Número de pieza CLAA215FA01-V2
Descripción Display Module
Fabricantes CHUNGHWA PICTURE TUBES 
Logotipo CHUNGHWA PICTURE TUBES Logotipo



Hay una vista previa y un enlace de descarga de CLAA215FA01-V2 (archivo pdf) en la parte inferior de esta página.


Total 24 Páginas

No Preview Available ! CLAA215FA01-V2 Hoja de datos, Descripción, Manual

Chunghwa Picture Tubes, Ltd.
Technical Specification
To : Qisda (for Philips)
Date : 2011/01/14
CPT TFT-LCD
CLAA 215FA01
V2
ACCEPTED BY
APPROVED BY
Kevin Chen
CHECKED BY
Lawrence Lai
PREPARED BY
General Design
Division
VD Business Unit
Prepared by: General Design Division VD Business Unit
CHUNGHWA PICTUER TUBES, LTD.
No. 1, Huaying Rd., Sanho Tsun, Lungtan Shiang, Taoyuan, Taiwan, 325, R.O.C.
TEL: +886-3-4805678 FAX: +886-3-4800589
Doc. No: CLAA215FA01-Qisda-Ver.1-20110114
Issue Date: 2011/01/14

1 page




CLAA215FA01-V2 pdf
CPT
CHUNGHWA PICTURES TUBES, LTD.,
2. ABSOLUTE MAXIMUM RATINGS
ITEM
SYMBOL MIN. MAX.
UNIT REMARK
Power Supply Voltage for LCD VCC
0
6
V
Lamp Voltage
VL 760 950 Vrms
Lamp Current
ILO 3
8 mArms
Lamp Frequency
static electricity
FL
VESDt
VESDc
40
-200
-8000
80
200
8000
kHz
V
V
*5)
Operation Temperature Top 0
50
*1). 2). 3). 6)
Storage Temperature
Tstg -20
60
*1). 2). 3)
Delayed Discharge Time
TD
--
1
sec *8)
[Note]
1).The relative temperature and humidity range are as below sketch, 90%RHMax.(Ta 40 ).
2).The maximum wet bulb temperature 39 (Ta40 ) and without dewing.
3).If you use the product in an environment which over the definition of temperature and humidity too
long to effect the result of eye-etching.
4).The life time of the lamp is related to the current of the lamp, so please according to the description
of the “(b) backlight” on page 7.
5).Test Condition: IEC 1000-4-2 VESDt: Contact discharge to input connector; VESDC: Contact
discharge to module
6).If you operate the product in normal temperature range, the center surface of panel should be under
60 .
7).When lamp current is out of the absolute maximum range, the life will fall rapidly or shown
unusual sign.
IL min 2mA only for test only, but we can’t guarantee the lifetime and performance.
8).Delay lighting testing needs the volt above start voltage Vrms. Before the procedure tube needs
typical lighting for 1 minute and stay in the temperature 25±2 for 24 hours and then testing in the
same condition in dark room.
Relative humidity(%RH)
90 Operating Range
(40,90)
80
Storage Range
60
(50,50.4)
40
(60,27.7)
20
5
-20
0 20 40 50 60
Temperature (°C)
CPT Confidential
5/24 CLAA215FA01-Qisda-Ver.1-20110114

5 Page





CLAA215FA01-V2 arduino
CPT
CHUNGHWA PICTURES TUBES, LTD.,
16 RXE1+ plus signal of even channel 1(LVDS)
17 GND GND
18 RXE2- minus signal of even channel 2(LVDS)
19 RXE2+ plus signal of even channel 2(LVDS)
20 RXEC- minus signal of even clock channel (LVDS)
21 RXEC+ plus signal of even clock channel (LVDS)
22 RXE3- minus signal of even channel 3(LVDS)
23 RXE3+ plus signal of even channel 3(LVDS)
24 GND GND
25 NC NC
26 NC Test pin (Can’t connect to GND)
27 NC NC
28 VCC Power supply input voltage(5.0 V)
29 VCC Power supply input voltage(5.0 V)
30 VCC Power supply input voltage(5.0 V)
1) Keep the NC Pin and don’t connect it to GND or other signals.
2) GND Pin must connect to the ground, don’t let it be a vacant pin.
(2) CN2, 3, 4, 5 (BACKLIGHT)
CN2CN3CN4CN535001HS-02L (YEONHO)
<Mating connector: 35002WR-02L (YEONHO)>
No. Pin Symbol
Description
1 HV
CN2
2 LV
High Voltage Output for CCFL Lamp 1
Low Voltage Output for CCFL Lamp 1
1 HV
CN3
2 LV
High Voltage Output for CCFL Lamp 2
Low Voltage Output for CCFL Lamp 2
1 HV
CN4
2 LV
High Voltage Output for CCFL Lamp 3
Low Voltage Output for CCFL Lamp 3
1 HV
CN5
2 LV
High Voltage Output for CCFL Lamp 4
Low Voltage Output for CCFL Lamp 4
CPT Confidential
11/24
CLAA215FA01-Qisda-Ver.1-20110114

11 Page







PáginasTotal 24 Páginas
PDF Descargar[ Datasheet CLAA215FA01-V2.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
CLAA215FA01-V2Display ModuleCHUNGHWA PICTURE TUBES
CHUNGHWA PICTURE TUBES

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar