|
|
PDF V296W1-L02 Data sheet ( Hoja de datos )
| Número de pieza | V296W1-L02 | |
| Descripción | TFT LCD Module | |
| Fabricantes | CHI MEI | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de V296W1-L02 (archivo pdf) en la parte inferior de esta página. Total 29 Páginas | ||
|
No Preview Available !
Global LCD Panel Exchange Center
www.panelook.com
Issued Date: Oct. 17, 2003
Model No.: V296W1 - L02
Approval
TFT LCD Approval Specification
MODEL NO.: V296W1
Customer:
Approved by:
Note:
- L02
LCD TV Head Division
Director
Liquid Crystal Display Division
QRA Dept.
DDIII
DDII
DDI
Approval
Approval Approval Approval
LCD TV Marketing and Project Management Dept.
Project Manager
1-
The information described in this technical specification is tentative and it is possible to be changed without prior notice.
Please contact CMO ’s representative while your product design is based on this specification. Version 2.0
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
1 page  
Global LCD Panel Exchange Center
www.panelook.com
Issued Date: Oct. 17, 2003
Model No.: V296W1 - L02
Approval
Note(1) add “Viewing angles are measured by EZ-Contrast 160R
(Eldim)”
21 7.2 Note(4) add “The driving signal means the signal of gray level 0, 63,
127, 191, 255.”
22 7.2 Note(7) The warm up time is changed from 30 minutes to 1 hour.
The measuring machine “TOPCON BM-5A” is replaced by
“Minolta CA210”.
23 8 Add PACKAGING
25 9 Add DEFINITION OF LABLES
26 10 Remove PRECAUTIONS from section 8 to section 10
27 11 Remove MECHANICAL CHARACTERISTICS from section 10 to section
11
5-
The information described in this technical specification is tentative and it is possible to be changed without prior notice.
Please contact CMO ’s representative while your product design is based on this specification. Version 2.0
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
5 Page 
Global LCD Panel Exchange Center
www.panelook.com
Issued Date: Oct. 17, 2003
Model No.: V296W1 - L02
Approval
Note (2) The voltage shown above should be applied to the lamp for more than 1 second after startup.
Otherwise the lamp may not be turned on.
Note (3) The lamp frequency may produce interference with horizontal synchronous frequency from the
display, and this may cause line flow on the display. In order to avoid interference, the lamp
frequency should be detached from the horizontal synchronous frequency and its harmonics as far
as possible.
Note (4) PL =( lamp1-lamp16 IL VL )/0.8, PL is based on the inverter efficiency, which is 80%.
Note (5) The lifetime of a lamp is defined as the time in which it continues to operate under the condition Ta =
25 2 oC and IL = (4.2) ~ (4.8) mArms until one of the following events occurs:
(a) When the brightness becomes equal or less than 50% of its original value.
(b) When the effective discharge length becomes equal or lower than 80% of its original value.
(Effective discharge length is defined as an area that has equal or more than 70% brightness
compared to the brightness at the center point.)
Note (6) The waveform of the voltage output of inverter must be area-symmetric and the design of the
inverter must have specifications for the modularized lamp. The performance of the Backlight, such
as lifetime or brightness, is greatly influenced by the characteristics of the DC-AC inverter for the
lamp. All the parameters of an inverter should be carefully designed to avoid producing too much
current leakage from high voltage output of the inverter. When designing or ordering the inverter
please make sure that a poor lighting caused by the mismatch of the Backlight and the inverter
(miss-lighting, flicker, etc.) never occurs. If the above situation is confirmed, the module should be
operated in the same manners when it is installed in your instrument.
11-
The information described in this technical specification is tentative and it is possible to be changed without prior notice.
Please contact CMO ’s representative while your product design is based on this specification. Version 2.0
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
11 Page | ||
| Páginas | Total 29 Páginas | |
| PDF Descargar | [ Datasheet V296W1-L02.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| V296W1-L01 | LCD_Module |  CHIMEI |
| V296W1-L02 | TFT LCD Module | CHI MEI |
| V296W1-L06 | TFT LCD Module | CHI MEI |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |