DataSheet.es    


PDF LK600D3LA5S Data sheet ( Hoja de datos )

Número de pieza LK600D3LA5S
Descripción TFT LCD Module
Fabricantes Sharp 
Logotipo Sharp Logotipo



Hay una vista previa y un enlace de descarga de LK600D3LA5S (archivo pdf) en la parte inferior de esta página.


Total 24 Páginas

No Preview Available ! LK600D3LA5S Hoja de datos, Descripción, Manual

1. Application
This specification applies to the color 60.0” TFT-LCD module LK600D3LA5S
LD-K21Y33-1
* This specification is proprietary products of SHARP CORPORATION (“SHARP”) and includes materials protected
under copyright of SHARP. Do not reproduce or cause any third party to reproduce them in any form or by any
means, electronic or mechanical, for any purpose, in whole or in part, without the express written permission of
SHARP.
* In case of using the device for applications such as control and safety equipment for transportation (aircraft, trains,
automobiles, etc.), rescue and security equipment and various safety related equipment which require higher
reliability and safety, take into consideration that appropriate measures such as fail-safe functions and redundant
system design should be taken.
* Do not use the device for equipment that requires an extreme level of reliability, such as aerospace applications,
telecommunication equipment (trunk lines), nuclear power control equipment and medical or other equipment for
life support.
* SHARP assumes no responsibility for any damage resulting from the use of the device that does not comply with
the instructions and the precautions specified in these specification.
* Contact and consult with a SHARP sales representative for any questions about this device.
2. Overview
This module is a color active matrix LCD module incorporating amorphous silicon TFT (Thin Film Transistor). It is
composed of a color TFT-LCD panel, driver ICs, control circuit, power supply circuit, LED drive circuit and back
light system etc. Graphics and texts can be displayed on a 1920˜RGB˜1080 dots panel with one billion colors by
using 10bit LVDS (Low Voltage Differential Signaling) to interface, +12V of DC supply voltages.
This module also includes the LED-PWB module to drive the LED. (r120mA of DC supply current)
And in order to improve the response time of LCD, this module applies the Over Shoot driving (O/S driving)
technology for the control circuit .In the O/S driving technology, signals are being applied to the Liquid Crystal
according to a pre-fixed process as an image signal of the present frame when a difference is found between image
signal of the previous frame and that of the current frame after comparing them.
With this technology, image signals can be set so that liquid crystal response completes within one frame. As a
result, motion blur reduces and clearer display performance can be realized.
This LCD module also adopts Double Frame Rate driving method including FRC (Frame Rate Control) function
on the control circuit. Therefore the input signal to this LCD module is Single Frame Rate, but the output is
Double-Frame Rate picture (inserting the intermediate image which is generated by the FRC).
With combination of these technologies, motion blur can be reduced and clearer display performance can be
realized.
3. Mechanical Specifications
Parameter
Display size
Active area
Pixel Format
Pixel pitch
Pixel configuration
Display mode
Unit Outline Dimensions
Mass
Surface treatment
Specifications
152.496 (Diagonal)
60.0 Diagonal
1329.12(H) x 747.63 (V)
1920(H) x 1080(V)
1pixel = R + G + B dot
0.69225(H) x 0.69225 (V)
R, G, B vertical stripe
Normally black
1406 (W) x 843 (H) x 14.5(D)
22.2
Anti glare(Haze:7.3%)
Hard coating: 3H
Unit
cm
inch
mm
pixel
mm
mm
kg

1 page




LK600D3LA5S pdf
4.3. LVDS Mapping
ACK+,BCK+
ACK,BCK
1 cycle
LD-K21Y33-5
AIN0+,BIN0+
AIN0,BIN0
R5 R4 G4
R9 R8 R7 R6 R5 R4 G4
AIN1+,BIN1+
AIN1,BIN1
G6 G5 B5
B4 G9 G8 G7 G6 G5 B5
AIN2+,BIN2+
AIN2,BIN2
AIN3+,BIN3+
AIN3,BIN3
AIN4+,BIN4+
AIN4,BIN4
B7 B6 DE Vsync Hsync B9 B8 B7 B6 DE
R3 R2 NA B3 B2 G3 G2 R3 R2 NA
R1 R0 NA B1 B0 G1 G0
R1 R0
NA
DE: Display Enable, NA: Not Available (Fixed Low)
Fig.2 LVDS Mapping

5 Page





LK600D3LA5S arduino
[Note 3]
*CK-,*IN-
*CK+,*IN+
GND
[Note 4]
LD-K21Y33-11
|VID|
|VID|
Fig.6 mini-LVDS Amplitude voltage
VCM
500μS
8.6A
Vcc
Irush
Fig.7 Inrush current
[Note 5] I2C_SCL,I2C_SDA,B_INT,PANEL_SEL,FRC_PWR_CTRL
SA_MODE,PANEL_ON,FRC_RST,TCON_RDY

11 Page







PáginasTotal 24 Páginas
PDF Descargar[ Datasheet LK600D3LA5S.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
LK600D3LA5STFT LCD ModuleSharp
Sharp

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar