|
|
PDF LM130SS1T611 Data sheet ( Hoja de datos )
| Número de pieza | LM130SS1T611 | |
| Descripción | LCD Module | |
| Fabricantes | Sharp | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de LM130SS1T611 (archivo pdf) en la parte inferior de esta página. Total 30 Páginas | ||
|
No Preview Available !
Global LCD Panel Exchange Center
www.panelook.com
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
1 page  
Global LCD Panel Exchange Center
www.panelook.com
SPEC No.
LC00303
MODEL No.
LM130SS1T611
PAGE
3
12) Disassembling the LCD module can cause permanent damage and should be strictly avoided.
Procedure insert mating connector
When the mating connector is inserted, it should be parallel to the used connector of LCD module and it
should be inserted on horizontal firm base. When the mating connector is attempted to be fixed to LCD
connector, it should be inserted properly in order not to create a gap as shown “A”.
Please insert the connector as both edge is placed to the connect position of LCD connector.
1)Method of correct insert
Stress is dispersed
Base (horizontal film base) is required
2)Method of wrong insert
Stress is dispersed
Base (horizontal film base) is required
14) This specification describes display quality in case of no gray scale. Since display quality can be
affected by gray scale methods, display quality shall be carefully evaluated for the usability of LCD
module in case gray scale is displayed on the LCD module.
15) The module should be driven according to the specified ratings to avoid permanent damage.
DC voltage drive leads to rapid deterioration of LC, so ensure that the drive is alternating waveform by
continuous application of the signal M. Especially the power ON/OFF sequence shown on Page 26
should be kept to avoid latch-up of drive LSI and application of DC voltage to LCD panel
16) It is a characteristic of LCD to maintain the displaying pattern when the pattern is applied for a long
time.(Image retention) To prevent image retention, please do not apply the fixed pattern for along time by
pre-installing such programs at your side.
17) This phenomena (image retention) is not deterioration of LCD. If it happens, you can remove it by
applying different patterns.
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
5 Page 
Global LCD Panel Exchange Center
www.panelook.com
SPEC No.
LC00303
MODEL No.
LM130SS1T611
PAGE
9
5. Electrical Specifications
5-1. Electrical characteristics
ǛTable 5-1 Ta=25 VDD= 3.3 V±0.3 V 1/tFRM=150 Hz (Note 4)
Parameter
Supply voltage (Logic)
Symbol
VDD-VSS
Contrast adjust voltage
(Note 4)
Vcon -VSS
Conditions
ǛTa = 0 40 (Note 1)
ǛTa=0
ǛTa=25
ǛTa=40
Min. Typ. Max. Unit
3.0 3.3 3.6 V
1.0 -
-V
- 1.9 - V
- - 2.5 V
Input signal voltage
VIN
Supply current
Rush current (Logic)
Ripple current (Logic)
IDD(TYP.)
IDD(MAX.)
Irush
Irip
“H” level
“L” level
ǛTa = 0
40
VDD=3.3 V, Note 2)
VDD=3.3 V, Note 3)
ǛTa =25 (Note 1)
ǛTa =25 (Note 1)
0.8 VDD
-
VDD
0 - 0.2VDD
- 190 270
- 350 490
Ǘ2 A(pk) 50 ms
Ǘ 1.5 A(pk) 100 s
V
V
mA
mA
Power consumption
Pd(TYP)
Pd(MAX)
VDD=3.3 V,Note 2)
VDD=3.3 V, Note 3)
- 630 980 mW
- 1 160 1 770 mW
Note 1)
Under the following conditions.;
(1) Immediately after the rise of VDD .
(2) Under the situation that internal DISP signal is on and kept steady
Ǘ: 2 A(pk) 50 ms
Ǘ : 1.5 A(pk) 100 s
Note 2) Frame Frequency = 150 Hz , Vcon - Vss = 1.9 V
Display pattern = all digits ON (DU0-7, DL0-7 = “H” )
Display Pattern
Note 3)
Frame Frequency = 150 Hz , Vcon - Vss = 1.9 V
Display pattern = black/white stripe pattern
Display Pattern
Note 4)
The shadowing is adjusted on this module to the following conditions. When LCD module is
operated in the other conditions, that should be informed in advance because display quality may
be deteriorated in this case.
Frame frequency : 150 Hz
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
11 Page | ||
| Páginas | Total 30 Páginas | |
| PDF Descargar | [ Datasheet LM130SS1T611.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| LM130SS1T611 | Color STN-LCD Module |  Sharp Electrionic Components |
| LM130SS1T611 | LCD Module | Sharp |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |