|
|
PDF M255UW02-V0 Data sheet ( Hoja de datos )
| Número de pieza | M255UW02-V0 | |
| Descripción | WUXGA Color TFT-LCD | |
| Fabricantes | AUO | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de M255UW02-V0 (archivo pdf) en la parte inferior de esta página. Total 30 Páginas | ||
|
No Preview Available !
Global LCD Panel Exchange Center
www.panelook.com
Product Specification
AU OPTRONICS CORPORATION
M255UW02 V0
( V ) Preliminary Specification
( ) Final Specification
Module
Model Name
25.5” WUXGA Color TFT-LCD
M255UW02 V0
Customer
Date
Checked &
Approved by
-: /LQ
Date
2007/9/11
Approved by
Prepared by
+DQQLH <HK
2007/9/11
Note: This Specification is subject to change without
notice.
Desktop Display Business Group /
AU Optronics corporation
document version 0.2
NUMPAGES |29}
1
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
1 page  
Global LCD Panel Exchange Center
www.panelook.com
Product Specification
AU OPTRONICS CORPORATION
M255UW02 V0
1. Handling Precautions
1) Since front polarizer is easily damaged, pay attention not to scratch it.
2) Be sure to turn off power supply when inserting or disconnecting from input connector.
3) Wipe off water drop immediately. Long contact with water may cause discoloration or spots.
4) When the panel surface is soiled, wipe it with absorbent cotton or other soft cloth.
5) Since the panel is made of glass, it may break or crack if dropped or bumped on hard surface.
6) Since CMOS LSI is used in this module, take care of static electricity and insure human earth when
handling.
7) Do not open or modify the Module Assembly.
8) Do not press the reflector sheet at the back of the module to any directions.
9) In case if a Module has to be put back into the packing container slot after once it was taken out from the
container, do not press the center of the CCFL reflector edge. Instead, press at the far ends of the CCFL
Reflector edge softly. Otherwise the TFT Module may be damaged.
10) At the insertion or removal of the Signal Interface Connector, be sure not to rotate nor tilt the Interface
Connector of the TFT Module.
11) After installation of the TFT Module into an enclosure, do not twist nor bend the TFT Module even
momentary. At designing the enclosure, it should be taken into consideration that no bending/twisting forces
are applied to the TFT Module from outside. Otherwise the TFT Module may be damaged.
12) Cold cathode fluorescent lamp in LCD contains a small amount of mercury. Please follow local ordinances or
regulations for disposal.
13) Small amount of materials having no flammability grade is used in the LCD module. The LCD module should be
supplied by power complied with requirements of Limited Power Source (IEC60950 or UL1950), or be applied
exemption.
14) The LCD module is designed so that the CCFL in it is supplied by Limited Current Circuit (IEC60950 or UL1950).
Do not connect the CCFL in Hazardous Voltage Circuit.
document version 0.2
NUMPAGES |29}
5
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
5 Page 
Global LCD Panel Exchange Center
www.panelook.com
Product Specification
AU OPTRONICS CORPORATION
M255UW02 V0
Note 8: SPD Measurement is defined as below (measured by Otsuka MPRT-1000).
MPRT(Moving Picture Response Time) is the average value of BET measured from 72 combinations of different gray
levels.
We divide the measurement base on each 32 grey level. Because the brightness between L0 & L32 is so slight and it
will cause noise to influence the outcome, we set L42 instead of L32. We can get 72 combination data as the table
below.
MPRT (seconds) = BET1 + BET2 + ... + BET72
72
1
BET = BEW ×
scrolling speed × frame rate
BEW: Blur Edge Width (LCD pixel). The width is defined to be used for the values 10%~90% of luminance.
Note: scrolling speed=8ppf (LCD pixel/frame rate) ; frame rate=60Hz
document version 0.2
NUMPAGES |29}
11
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
11 Page | ||
| Páginas | Total 30 Páginas | |
| PDF Descargar | [ Datasheet M255UW02-V0.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| M255UW02-V0 | WUXGA Color TFT-LCD | AUO |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |