|
|
PDF NL10276BC24-14 Data sheet ( Hoja de datos )
| Número de pieza | NL10276BC24-14 | |
| Descripción | TFT COLOR LCD MODULE | |
| Fabricantes | NEC | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de NL10276BC24-14 (archivo pdf) en la parte inferior de esta página. Total 28 Páginas | ||
|
No Preview Available !
TFT COLOR LCD MODULE
NL10276BC24-14
31cm (12.1 Type)
XGA
LVDS interface (1port)
PRELIMINARY DATA SHEET
DOD-PP-0048 (1st edition)
All information is subject to change without notice.
Please confirm the sales representative before
starting to design your system.
Document Number: DOD-PP-0048 (1st edition)
Published date: October 2006 CP(N)
1 © NEC LCD Technologies, Ltd.
2006 All rights reserved.
1 page  
NL10276BC24-14
2. GENERAL SPECIFICATIONS
Display area
Diagonal size of display
Drive system
Display color
Pixel
Pixel arrangement
Dot pitch
Pixel pitch
Module size
Weight
Contrast ratio
Viewing angle
Designed viewing direction
Polarizer surface
Polarizer pencil-hardness
245.76 (H) × 184.32 (V) mm
31cm (12.1 inches)
a-Si TFT active matrix
262,144 colors
1,024 (H) × 768 (V) pixels
BGR(Blue dot, Green dot, Red dot) vertical stripe
0.08 (H) × 0.24 (V) mm
0.24 (H) × 0.24 (V) mm
260.0 (W) × 200.0 (H) ×6.5 (D) mm (typ.)
285 g (typ.)
600:1 (typ.)
At the contrast ratio ≥10:1
• Horizontal: Right side 45° (typ.), Left side 45° (typ.)
• Vertical: Up side 20° (typ.), Down side 40° (typ.)
At DPS= Low or open: normal scan
• Viewing direction without image reversal: up side (12 o'clock)
• Viewing direction with contrast peak: down side (6 o'clock)
• Viewing angle with optimum grayscale (γ=2.2): normal axis
(Perpendicular)
Clear
3H (min.) [by JIS K5400]
Color gamut
At LCD panel center
40 % (typ.) [against NTSC color space]
Response time
Ton+Toff (10%←→ 90%)
25 ms (typ.)
Luminance
Signal system
Power supply voltage
Backlight
At IL=20mA
300 cd/m2 (typ.)
LVDS 1port (Receiver: THC63LVDF84B, THine Electronics Inc. or
equivalent)
6bit digital signals for data of RGB colors, Dot clock (CLK),
Data enable (DE)
LCD panel signal processing board: 3.3V
LED backlight type:
Power consumption
At IL=20mA, Checkered flag pattern
4.5 W (typ.)
DATA SHEET DOD-PP-0048 (1st edition)
5
5 Page 
4.4 POWER SUPPLY VOLTAGE SEQUENCE
VCC
Note1
0V
ON
3.0V
10μs≤ Tr < 50ms
Display signals*
Function signals
Note2
0V
0ms < t < 35ms
VALID period
NL10276BC24-14
OFF
ON
0.3V
Toff ≥ 50ms
0ms < t < 35ms
* These signals should be measured at the terminal of 100Ω resistance.
Note1: In terms of voltage variation (voltage drop) while VCC rising edge is below 3.0V, a protection
circuit may work, and then this product may not work.
Note2: Display signals (D0+/-, D1+/-, D2+/- and CLK+/-) and function signals (DPS) must be Low
or High-impedance, exclude the VALID period (See above sequence diagram), in order to
avoid that internal circuits is damaged.
If some of display and function signals of this product are cut while this product is working,
even if the signal input to it once again, it might not work normally. If customer stops the
display and function signals, they should be cut VCC.
Note3: The backlight should be turned on within the valid period of display and function signals, in
order to avoid unstable data display.
DATA SHEET DOD-PP-0048 (1st edition)
11
11 Page | ||
| Páginas | Total 28 Páginas | |
| PDF Descargar | [ Datasheet NL10276BC24-14.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| nl10276bc24-13 | TFT COLOR LCD MODULE | NEC |
| NL10276BC24-13C | Display Module | NEC |
| NL10276BC24-14 | Display Module | NEC |
| NL10276BC24-14 | TFT COLOR LCD MODULE | NEC |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |