DataSheet.es    


PDF NL10276BC20-18 Data sheet ( Hoja de datos )

Número de pieza NL10276BC20-18
Descripción Display Module
Fabricantes NEC 
Logotipo NEC Logotipo



Hay una vista previa y un enlace de descarga de NL10276BC20-18 (archivo pdf) en la parte inferior de esta página.


Total 34 Páginas

No Preview Available ! NL10276BC20-18 Hoja de datos, Descripción, Manual

www.DataSheet.co.kr
TFT COLOR LCD MODULE
NL10276BC20-18
26cm (10.4 Type)
XGA
LVDS interface (1port)
PRELIMINARY DATA SHEET
DOD-PP-0728 (2nd edition)
This PRELIMINARY DATA SHEET is updated
document from DOD-PP-0598(1).
All information is subject to change without notice.
Please confirm the sales representative before
starting to design your system.
Document Number: DOD-PP-0728 (2nd edition) 1 © NEC LCD Technologies, Ltd.
Published date: February 2009 CP(N)
2008-2009 All rights reserved.
Datasheet pdf - http://www.DataSheet4U.net/

1 page




NL10276BC20-18 pdf
www.DataSheet.co.kr
NL10276BC20-18
2. GENERAL SPECIFICATIONS
Display area
Diagonal size of display
Drive system
Display color
Pixel
Pixel arrangement
Dot pitch
Pixel pitch
Module size
Weight
Contrast ratio
Viewing angle
Designed viewing direction
Polarizer surface
Polarizer pencil-hardness
Color gamut
Response time
Luminance
Signal system
Power supply voltage
210.432 (H) × 157.824 (V) mm
26cm (10.4 inches)
a-Si TFT active matrix
16,777,216 colors (At 8-bit input, FRC terminal= High)
262,144 colors (At 6-bit input, FRC terminal= Low or Open)
1,024 (H) × 768 (V) pixels
RGB (Red dot, Green dot, Blue dot) vertical stripe
0.0685 (H) × 0.2055 (V) mm
0.2055 (H) × 0.2055 (V) mm
228.0 (W) × 178.5 (H) × 8.7 (D) mm (typ.)
380 g (typ.)
(1,000: 1) (typ.)
At the contrast ratio 10:1
Horizontal: Right side 80° (typ.), Left side 80° (typ.)
Vertical: Up side 80° (typ.), Down side 80° (typ.)
At DPS= Low or Open: Normal scan
Viewing direction without image reversal: up side (12 o'clock)
Viewing direction with contrast peak: down side (6 o'clock)
Viewing angle with optimum grayscale (γ2.2): normal axis
(perpendicular)
Clear
3H (min.) [by JIS K5400]
At LCD panel center
40 % (typ.) [against NTSC color space]
Ton+Toff (10%←→ 90%)
18 ms (typ.)
At IL= 60mA/ one circuit
(400) cd/m2 (typ.)
LVDS 1port
(Receiver: THC63LVDF84B, THine Electronics Inc. or equivalent)
8bit/6bit digital signals for data of RGB colors, Dot clock (CLK),
Data enable (DE)
LCD panel signal processing board: 3.3V
LED backlight type:
Backlight
Replaceable part
Lamp holder set: Type No. TBD
Power consumption
At IL= 60mA/ one circuit, Checkered flag pattern
5.0 W (typ.)
2
2
2
2
PRELIMINARY DATA SHEET DOD-PP-0728 (2nd edition)
5
Datasheet pdf - http://www.DataSheet4U.net/

5 Page





NL10276BC20-18 arduino
www.DataSheet.co.kr
4.4 POWER SUPPLY VOLTAGE SEQUENCE
4.4.1 LCD panel signal processing board
VCC
Note1
0V
ON
3.0V
10μsTr < 50ms
Display signals*,
Function signals
Note2
0V
0ms < t < 35ms
VALID period
NL10276BC20-18
OFF
ON
0.3V
Toff 50ms
0ms < t < 35ms
* These signals should be measured at the terminal of 100Ω resistance.
Note1: In terms of voltage variation (voltage drop) while VCC rising edge is below 3.0V, a protection
circuit may work, and then this product may not work.
Note2: Display signals (D0+/-, D1+/-, D2+/-, D3+/-, CLK+/-) and function signals (DPS, FRC, MSL)
must be Low or High-impedance, exclude the VALID period (See above sequence diagram),
in order to avoid that internal circuits is damaged.
If some of display and function signals of this product are cut while this product is working,
even if the signal input to it once again, it might not work normally. If customer stops the
display and function signals, they should be cut VCC.
4.4.2 LED lighting circuit
Display and
function signals
Note1
Note2
VALID period
LED backlight: ON
Note1: These are the display and function signals for LCD panel signal processing board.
Note2: The backlight should be turned on within the valid period of display and function signals, in
order to avoid unstable data display.
PRELIMINARY DATA SHEET DOD-PP-0728 (2nd edition)
11
Datasheet pdf - http://www.DataSheet4U.net/

11 Page







PáginasTotal 34 Páginas
PDF Descargar[ Datasheet NL10276BC20-18.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
NL10276BC20-10TFT COLOR LCD MODULENEC
NEC
NL10276BC20-12TFT Color LCD ModuleNEC
NEC
NL10276BC20-18Display ModuleNEC
NEC
NL10276BC20-18CTFT Color LCD ModuleNLT
NLT

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar