|
|
PDF CLAA315WA01 Data sheet ( Hoja de datos )
| Número de pieza | CLAA315WA01 | |
| Descripción | Display Module | |
| Fabricantes | CHUNGHWA PICTURE TUBES | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de CLAA315WA01 (archivo pdf) en la parte inferior de esta página. Total 26 Páginas | ||
|
No Preview Available !
Chunghwa Picture Tubes, Ltd.
Technical Specification
To : AMCOM TECHNOLOGY INC.
Date : 2009.11.11
CPT TFT-LCD
CLAA315WA01
ACCEPTED BY:
APPROVED BY
周廷縣
CHECKED BY
林永池
PREPARED BY
Product Planning
Management
General Division
Prepared by : Design General Division
CHUNGHWA PICTUER TUBES, LTD.
1127 Hopin Rd., Padeh, Taoyuan, Taiwan 334, R.O.C.
TEL: +886-3-3675151 FAX: +886-3-377-3001
Doc. No: CLAA315WA01-SPEC-Eternal-V1-20091111 Issue Date: 2009.11.11
1 page  
CHUNGHWA PICTUER TUBES, LTD.
TECHNICAL SPECIFICATION
Title：CLAA315WA01 Technical Specification
Doc. No：
Version：
A
2. ABSOLUTE MAXIMUM RATINGS
The following are maximum values which, if exceeded, may cause faulty operation or damage to the
Unit.
Item
Power Supply Voltage For LCD
Input voltage of inverter
Inverter dimming
Backlight on/off
ESD for Connector
ESD for Module
Operation Ambient Temperature
Storage Temperature
Symbol
VCC
VBL
VDIM
VBLON
VESD
VESD
Top
Tstg
Min.
-0.3
-0.3
-0.3
-0.3
-250
-15
0
-20
Max.
14.0
27
3.5
5.5
250
15
50
60
Unit Note
V
V
Vdc
Vdc
V
KV
℃ *1) *2) *3)
℃ *1) *2)
[Note 1] The relative temperature and humidity range are as below sketch
Humidity≦85%RH without condensation .Relative
Humidity ≦90% (Ta≦ 40℃) , Wet Bulb Temperature ≦39℃(Ta≧40℃)
[Note 2] If you use the product in an environment which’s over the definition of temperature and
humidity too long , it will effect the result of visual inspection.
[Note 3] If you operate the product in normal temperature range, the center surface of panel should be
under 60℃.
CPT Confidential
5/26 CLAA315WA01- SPEC-AMCOM-Ver1.0-20091111
5 Page 
CHUNGHWA PICTUER TUBES, LTD.
TECHNICAL SPECIFICATION
Title：CLAA315WA01 Technical Specification
Doc. No：
Version：
A
[Note 2] Ripple voltage that occur at the instant of power-on can’t exceed 27V.
[Note 3] 25℃; IPW=3.3V(Max.), after power on for 30 Minutes；Max value of the power
consumption and input current is measured at initial turn on of the backlight.
[Note 4] Internal PWM control with Analog input voltage.
Brightness is the darkest when IPW = 0V ;
Brightness is the brightest when IPW = 3.3V .
CPT Confidential
11/26 CLAA315WA01- SPEC-AMCOM-Ver1.0-20091111
11 Page | ||
| Páginas | Total 26 Páginas | |
| PDF Descargar | [ Datasheet CLAA315WA01.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| CLAA315WA01 | Display Module | CHUNGHWA PICTURE TUBES |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |