DataSheetWiki


HD74HC191 fiches techniques PDF

Hitachi Semiconductor - Synchronous Up/Down Decade/4-bit Binary Counter(Single Clock Line)

Numéro de référence HD74HC191
Description Synchronous Up/Down Decade/4-bit Binary Counter(Single Clock Line)
Fabricant Hitachi Semiconductor 
Logo Hitachi Semiconductor 





1 Page

No Preview Available !





HD74HC191 fiche technique
HD74HC190/HD74HC191
Synchronous Up/Down Decade Counter (Single Clock Line)
Synchronous Up/Donw 4-bit Binary Counter (Single Clock Line)
Description
The HD74HC190 and HD74HC191 are synchronous, reverside up/down counters. The HD74HC190 is a
4-bit decade counter and the HD74HC191 is a 4-bit binary counter. Synchronous counting operation is
provided by having all flip-flops clocked simultaneously so that the outputs change coincident with each
other when so instructed by the steering logic. This mode of operation eliminates the output counting
spikes normally associated with asynchronous (ripple clock) counters.
The outputs of the four flip-flops are triggered on a low-to-high-level transition of the clock input if the
Enable G input is low. A high at Enable G inhibits counting. The direction of the count is determined by
the level of the Down/ Up (D/U) input. When D/U is low, the counter counts up and when D/U is high, it
counts down.
These counters feature a fully independent clock circuit. Changes at the control inputs (D/U) that will
modify the operating mode have no effect on the contents of the counter until clocking occurs. The
function of the counter will be dictated solely by the condition meeting the stable setup and hold times.
These counters are fully programmable; that is, the outputs may each be preset to either level by placing a
low on the load input and entering the desired data at the data inputs. The output will change to agree with
the data inputs independently of the level of the clock input. This feature allows the counters to be used as
modulo-N dividers by simply modifying the count length with the preset inputs.
Two outputs have been made available to perform the cascading function. Ripple clock and
maximum/minimum count. The latter output produces a high-level output pulse with a duration
approximately qual to one complete cycle of the clock while the count is zero (all outputs low) counting
down or maximum (9 or 15) counting up. The ripple clock output produces a low-level output pulse under
those same conditions but only while the clock input is low. The counters can be easily cascaded by
feeding the ripple clock output to the enable input of the succeeding counter if parallel clocking is used, or
to the clock input if paralle enabling is used. The maximum/minimum count output can be used to
accomplish look-ahead for high-speed operation.

PagesPages 13
Télécharger [ HD74HC191 ]


Fiche technique recommandé

No Description détaillée Fabricant
HD74HC190 Synchronous Up/Down Decade/4-bit Binary Counter(Single Clock Line) Hitachi Semiconductor
Hitachi Semiconductor
HD74HC191 Synchronous Up/Down Decade/4-bit Binary Counter(Single Clock Line) Hitachi Semiconductor
Hitachi Semiconductor
HD74HC192 Synchronous Up/Down Decade/4-bit Binary Counter(Dual Clock Line) Hitachi Semiconductor
Hitachi Semiconductor
HD74HC193 Synchronous Up/Down Decade/4-bit Binary Counter(Dual Clock Line) Hitachi Semiconductor
Hitachi Semiconductor

US18650VTC5A

Lithium-Ion Battery

Sony
Sony
TSPC106

PCI Bus Bridge Memory Controller

ATMEL
ATMEL
TP9380

NPN SILICON RF POWER TRANSISTOR

Advanced Semiconductor
Advanced Semiconductor


www.DataSheetWiki.com    |   2020   |   Contactez-nous  |   Recherche