24LC21 Datasheet PDF - MicrochipTechnology
| Part Number | 24LC21 | |
| Description | 1K2.5VDualModeI2CSerialEEPROM | |
| Manufacturers | MicrochipTechnology | |
| Logo |  |
|
|
There is a preview and 24LC21 download ( pdf file ) link at the bottom of this page. Total 24 Pages | ||
Preview 1 page No Preview Available !
Not recommended for new designs –
Please use 24LCS21A.
24LC21
1K 2.5V Dual Mode I2C™ Serial EEPROM
Features:
• Single supply with operation down to 2.5V
• Completely implements DDC1™/DDC2™ interface
for monitor identification
• Low-power CMOS technology:
- 1 mA active current typical
- 10 µA standby current typical at 5.5V
• 2-wire serial interface bus, I2C™ compatible
• Self-timed write cycle (including auto-erase)
• Page-write buffer for up to 8 bytes
• 100 kHz (2.5V) and 400 kHz (5V) compatibility
• Factory programming (QTP) available
• 1,000,000 erase/write cycles ensured
• Data retention > 200 years
• 8-pin PDIP and SOIC package
• Available for extended temperature ranges
Commercial (C):
Industrial (I):
0°C to +70°C
-40°C to +85°C
Description:
The Microchip Technology Inc. 24LC21 is a 128 x 8 bit
Electrically Erasable PROM. This device is designed
for use in applications requiring storage and serial
transmission of configuration and control information.
Two modes of operation have been implemented:
Transmit-only mode and Bidirectional mode. Upon
power-up, the device will be in the Transmit-only mode,
sending a serial bit stream of the entire memory array
contents, clocked by the VCLK pin. A valid high-to-low
transition on the SCL pin will cause the device to enter
the Bidirectional mode, with byte selectable read/write
capability of the memory array. The 24LC21 is available
in a standard 8-pin PDIP and SOIC package, in both
commercial and industrial temperature ranges.
Package Types
PDIP
NC 1
NC 2
NC 3
VSS 4
SOIC
NC 1
NC 2
NC 3
VSS
4
8 VCC
7 VCLK
6 SCL
5 SDA
8 VCC
7 VCLK
5 SCL
5 SDA
Block Diagram
VCLK
I/O
Control
Logic
Memory
Control
Logic
XDEC
SDA SCL
VCC
VSS
HV Generator
EEPROM
Array
Page Latches
YDEC
Sense Amp
R/W Control
I2C is a trademark of Philips Corporation.
DDC is a trademark of the Video Electronics Standards Association.
2004 Microchip Technology Inc.
DS21095J-page 1
|
| |
 
24LC21
3.0 BIDIRECTIONAL MODE
The 24LC21 can be switched into the Bidirectional
mode (see Figure 3-1) by applying a valid high-to-low
transition on the Bidirectional mode clock (SCL). When
the device has been switched into the Bidirectional
mode, the VCLK input is disregarded, with the exception
that a logic high level is required to enable write capa-
bility. This mode supports a two wire bidirectional data
transmission protocol. In this protocol, a device that
sends data on the bus is defined to be the transmitter,
and a device that receives data from the bus is defined
to be the receiver. The bus must be controlled by a
master device that generates the Bidirectional mode
clock (SCL), controls access to the bus and generates
the Start and Stop conditions, while the 24LC21 acts as
the slave. Both master and slave can operate as
transmitter or receiver, but the master device
determines which mode is activated.
3.1 Bidirectional Mode Bus
Characteristics
The following bus protocol has been defined:
• Data transfer may be initiated only when the bus
is not busy.
• During data transfer, the data line must remain
stable whenever the clock line is high. Changes in
the data line while the clock line is high will be
interpreted as a Start or Stop condition.
Accordingly, the following bus conditions have been
defined (see Figure 3-2).
3.1.1 BUS NOT BUSY (A)
Both data and clock lines remain high.
3.1.2 START DATA TRANSFER (B)
A high-to-low transition of the SDA line while the clock
(SCL) is high determines a Start condition. All
commands must be preceded by a Start condition.
3.1.3 STOP DATA TRANSFER (C)
A low-to-high transition of the SDA line while the clock
(SCL) is high determines a Stop condition. All
operations must be ended with a Stop condition.
FIGURE 3-1:
SCL
MODE TRANSITION
Transmit-only mode
Bidirectional mode
TVHZ
SDA
VCLK
FIGURE 3-2:
(A)
SCL
DATA TRANSFER SEQUENCE ON THE SERIAL BUS
(B) (D)
(D)
(C) (A)
SDA
Start
Condition
Address or
Acknowledge
Valid
Data
Allowed
to Change
Stop
Condition
2004 Microchip Technology Inc.
DS21095J-page 5
Preview 5 Page |
Part DetailsOn this page, you can learn information such as the schematic, equivalent, pinout, replacement, circuit, and manual for 24LC21 electronic component. |
| Information | Total 24 Pages | |
| Link URL | [ Copy URL to Clipboard ] | |
| Download | [ 24LC21.PDF Datasheet ] | |
Share Link :
Electronic Components Distributor
|
An electronic components distributor is a company that sources, stocks, and sells electronic components to manufacturers, engineers, and hobbyists. |
| SparkFun Electronics | Allied Electronics | DigiKey Electronics | Arrow Electronics |
| Mouser Electronics | Adafruit | Newark | Chip One Stop |
Featured Datasheets
| Part Number | Description | MFRS |
| 24LC21 | The function is 1K2.5VDualModeI2CSerialEEPROM. MicrochipTechnology | |
| 24LC21 | The function is 1K2.5VDualModeI2CSerialEEPROM. MicrochipTechnology | |
| 24LC21-IP | The function is 1K2.5VDualModeI2CSerialEEPROM. MicrochipTechnology | |
Semiconductors commonly used in industry:
1N4148 |
BAW56 |
1N5400 |
NE555 | | ||
Quick jump to:
24LC
1N4
2N2
2SA
2SC
74H
BC
HCF
IRF
KA | ||