|
|
Número de pieza | HBD-E570 | |
Descripción | BLU-RAY DISC/DVD RECEIVER SERVICE MANUAL | |
Fabricantes | Sony | |
Logotipo | ||
Hay una vista previa y un enlace de descarga de HBD-E570 (archivo pdf) en la parte inferior de esta página. Total 30 Páginas | ||
No Preview Available ! SERVICE MANUAL
Ver. 1.0 2010.02
HBD-E370/E470/
E570/E870/T57
US Model
HBD-E370/E570/T57
Canadian Model
HBD-E370/E470/E870
AEP Model
UK Model
HBD-E370/E870
Photo: HBD-E370
• HBD-E370 is the amplifier, video, BD/DVD/Super Audio CD/CD
system, USB, LAN and tuner section in BDV-E370.
• HBD-E470 is the amplifier, video, BD/DVD/Super Audio CD/CD
system, USB, LAN and tuner section in BDV-E470.
• HBD-E570 is the amplifier, video, BD/DVD/Super Audio CD/CD
system, USB, LAN and tuner section in BDV-E570.
• HBD-E870 is the amplifier, video, BD/DVD/Super Audio CD/CD
system, USB, LAN and tuner section in BDV-E870.
• HBD-T57 is the amplifier, video, BD/DVD/Super Audio CD/CD
system, USB, LAN and tuner section in BDV-T57.
Model Name Using Similar Mechanism
Mechanism Type
Optical Pick-up Block Name
BDP-S370
BPX-5
KEM-460AAA
Amplifier Section
U.S. models:
POWER OUTPUT AND TOTAL HARMONIC
DISTORTION:
(FTC)
Front L + Front R:
With 3 ohms loads, both
channels driven, from 180
- 20,000 Hz; rated 60 watts
per channel minimum
RMS power, with no more
than 1% total harmonic
distortion from 250 milli
watts to rated output.
Other models:
POWER OUTPUT (rated)
Front L/Front R:
108 W + 108 W (at 3 ohms,
1 kHz, 1% THD)
HBD-E370:
POWER OUTPUT (reference)
Front L/Front R/Center/Surround L/Surround R:
142 W (per channel at 3
ohms, 1 kHz)
Subwoofer:
140 W (at 3 ohms, 80 Hz)
HBD-E870/HBD-E570/HBD-E470/HBD-T57:
POWER OUTPUT (reference)
Front L/Front R/Center/Surround L/Surround R:
167 W (per channel at 3
ohms, 1 kHz)
SPECIFICATIONS
Subwoofer:
165 W (at 3 ohms, 80 Hz)
Inputs (Analog)
AUDIO (AUDIO IN) Sensitivity: 450/250 mV
Inputs (Digital)
SAT/CABLE (COAXIAL), TV (OPTICAL)
Supported formats: LPCM
2CH (up to 48 kHz), Dolby
Digital, DTS
Video Section
Outputs
VIDEO: 1 Vp-p 75 ohms
COMPONENT:
Y: 1 Vp-p 75 ohms
PB/CB, PR/CR: 0.7 Vp-p
75 ohms
HDMI OUT: Type A (19
pin)
BD/DVD/Super Audio CD/CD System
Signal format system NTSC (US and
Canadian models)
PAL/NTSC (AEP and
UK models)
USB Section
(USB) port:
Type A (For connecting
USB memory, memory
card reader, digital still
Maximum current:
camera, and digital video
camera)
500 mA
LAN Section
LAN (100) terminal
100BASE-TX Terminal
Tuner Section
System
PLL quartz-locked digital
synthesizer
FM tuner section
Tuning range
North American models: 87.5 MHz - 108.0 MHz
(100 kHz step)
Other models:
87.5 MHz - 108.0 MHz
(50 kHz step)
Antenna (aerial)
FM wire antenna (aerial)
Antenna (aerial) terminals 75 ohms, unbalanced
Intermediate frequency 10.7 MHz
General
Power requirements
North American model:
Other models:
Power consumption
Dimensions (approx.)
Mass (approx.)
120 V AC, 60 Hz
220 - 240 V AC,
50/60 Hz
On: 170 W
Standby: 0.3 W (at the
Power Saving mode)
430 mm × 85 mm × 335
mm (17 in × 3 3/8 in ×
13 1/4 in) (w/h/d) incl.
projecting parts
4.8 kg (10 lb 10 oz)
Design and specifications are subject to change
without notice.
BLU-RAY DISC/DVD RECEIVER
9-889-770-01
2010B05-1
© 2010.02
Sony Corporation
Audio&Video Business Group
Published by Sony Techno Create Corporation
1 page HBD-E370/E470/E570/E870/T57
CAPACITOR ELECTRICAL DISCHARGE PROCESSING
When checking the board, the electrical discharge is necessary for
the electric shock prevention.
Connect the resistors referring to the figure below.
• MAIN board (C3115, C3125, C3215, C3315, C3415, C3425)
Both ends of CN3001.
– MAIN Board (Conductor Side) –
800 :/2 W
4
1
CN3001
C3415 C3215 C3115
C3425
C3315 C3125
• POWER board (C903, C932, C933)
Both ends of respective capacitors.
– POWER Board (Conductor Side) –
800 :/2 W
C903
800 :/2 W
C932 C933
800 :/2 W
NOTE OF REPLACING THE OPTICAL DEVICE (KEM-
460AAA) OR MB-134 BOARD
Optical device (KEM-460AAA) for BD requires precise read out
functions and secure contents protection system for more than past
DVD/CD.
Therefore, in the case repaired as follows, the writing work of the
OP data is necessary.
• When the optical device (KEM-460AAA) is replaced (The
MB-134 board doesn’t replace).
• When both the optical device (KEM-460AAA) and MB-134
board are replaced.
• When the MB-134 board is replaced (The optical device
(KEM-460AAA) doesn’t replace) (In this case, do the work of
“3. Optical device (KEM-460AAA) replacement” other than
the replacement of new optical device).
Note: The servo adjustment is done while writing the OP data. The manual
adjustment is unnecessary.
LD ON TIME history doesn’t carry over.
Do not touch any optical block parts, turn table and during replac-
ing. BD laser diode is very sensitive.
1. Preparation
1-1. ESD Countermeasure
It is necessary to confirm the state of static electricity in the work
space before the repair is started.
The static electricity resistance of the BD laser is weaker than that
of the DVD/CD laser.
Do work space and worker’s ESD countermeasures to prevent de-
struction by ESD.
1-2. Jig
• Digital camera (Recommend with macro mode)
• USB memory
• PC
• Barcode decoder (Refer to “1-3. Barcode decoder
(BDBUDEC)”)
1-3. Barcode decoder (BDBUDEC)
Part No. : J-6090-212-A
Jig name : BDBUDec.exe
Release : 2009.02.19
Version : 1.0.0.0
Software contents :
• BDBUDec.exe : Barcode decoder software
• SavePath.ini : Decoded file destination setting file (Ini-
tial destination is “C:\BuData.txt”)
• TasmanBars.dll : Decode dll
• Uninst.exe
: Uninstall the “BDBUDec.exe” from PC
Install procedure:
1. Unzip the barcode decoder files to any PC folder.
2. Check the taken barcode photo click & drop onto “BDBUDec.
exe”.
When the barcode decoder is used for the first time, the pass-
word is necessary. It is unnecessary since the second times.
Note 1: The password will be supplied to only service headquarters, and
service center name/q’ty/all of software registered information
should be maintained by service headquarters.
Note 2: Do not change the decoded file name “BuData.txt”.
3. When “.NET frame work requirements” is displayed, down-
load following applications from Microsoft download site.
• Microsoft .NET Framework Version 2.0 Redistributable Pack-
age (x86)
http://www.microsoft.com/downloads/details.aspx?displaylan
g=en&FamilyID=0856eacb-4362-4b0d-8edd-aab15c5e04f5
• Microsoft .NET Framework 2.0 Service Pack 1 (x86)
http://www.microsoft.com/downloads/details.aspx?displaylan
g=en&FamilyID=79bc3b77-e02c-4ad3-aacf-a7633f706ba5
5
5 Page HBD-E370/E470/E570/E870/T57
SECTION 2
DISASSEMBLY
• This set can be disassembled in the order shown below.
2-1. DISASSEMBLY FLOW
SET
2-2. CASE (EZ)
(Page 11)
2-3. MB-134 BOARD
(Page 12)
2-4. BRACKET (MB) BLOCK
(Page 13)
2-6. FRONT PANEL BLOCK
(Page 14)
2-7. CONNECT BOARD
(Page 14)
2-8. BD DRIVE (BPX-5)
(Page 15)
2-12. OPTICAL DEVICE
(KEM-460AAA),
WIRE (FLAT TYPE)
(Page 17)
2-5. FUSE (F901),
POWER BOARD
(Page 13)
2-9. BACK PANEL BLOCK
(Page 15)
2-10. MAIN BOARD
(Page 16)
2-11. AUDIO BOARD
(Page 16)
Note: Follow the disassembly procedure in the numerical order given.
2-2. CASE (EZ)
6 case (EZ)
3
2 five screws
(BV/RING)
1 four screws
(BV3)
5 seven hooks
4
3
– Bottom view –
11
11 Page |
Páginas | Total 30 Páginas | |
PDF Descargar | [ Datasheet HBD-E570.PDF ] |
Número de pieza | Descripción | Fabricantes |
HBD-E570 | BLU-RAY DISC/DVD RECEIVER SERVICE MANUAL | Sony |
Número de pieza | Descripción | Fabricantes |
SLA6805M | High Voltage 3 phase Motor Driver IC. |
Sanken |
SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
Analog Devices |
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |