DataSheet.es    


PDF TA8221AHQ Data sheet ( Hoja de datos )

Número de pieza TA8221AHQ
Descripción 30W BTL X 2Ch Audio Power Amplifier
Fabricantes Toshiba 
Logotipo Toshiba Logotipo



Hay una vista previa y un enlace de descarga de TA8221AHQ (archivo pdf) en la parte inferior de esta página.


Total 14 Páginas

No Preview Available ! TA8221AHQ Hoja de datos, Descripción, Manual

TA8221AHQ / ALQ
TOSHIBA Bipolar Linear Integrated Circuit Silicon Monolithic
TA8221AHQ,TA8221ALQ
30W BTL × 2Ch Audio Power Amplifier
The thermal resistance θjT of TA8221AHQ, TA8221ALQ
package designed for low thermal resistance, has a high efficiency
of heat radiation.
The temperature rise of chip can be reduced, and the influence
from the degradation of the features due to the temperature rise
at the high output can also be reduced.
This stereo audio power IC, designed for car audio use, has two
builtin channels to reduce the characteristic difference between
L and R channels.
It also contains various kind of protection.
TA8221AHQ
TA8221ALQ
Features
Low thermal resistance
: θjT = 1.5°C / W (infinite heat sink)
High power
: POUT (1) = 30W (typ.) / channel
(VCC = 14.4V, f = 1kHz, THD = 10%, RL =2)
POUT (2) = 26W (typ.) / channel
(VCC = 13.2V, f = 1kHz, THD = 10%, RL = 2)
POUT (3) = 19W (typ.) / channel
Weight
HZIP17P2.00 : 9.8g (typ.)
HSIP17P2.00 : 9.8g (typ.)
(VCC = 13.2V, f = 1kHz, THD = 10%, RL = 4)
Low distortion ratio: THD = 0.04% (typ.) (VCC = 13.2V, f = 1kHz, POUT = 1W, RL = 4, GV = 50dB)
Low noise: VNO = 0.30mVrms (typ.) (VCC = 13.2V, RL = 4, GV 50dB, Rg = 0, BW = 20Hz~20kHz)
Builtin standby function (with pin(4) set at low, power is turned off.): ISB = 100µA (typ.)
Builtin muting function (with pin(1) set at low, power is turned off.)
Builtin various protection circuits
Protection circuits: Thermal shut down, Over voltage, OutVCC short, OutGND short and OutOut short.
Operating supply voltage: VCC (opr) = 9~18V
1 2004-09-28
Free Datasheet http://www.Datasheet4U.com

1 page




TA8221AHQ pdf
TA8221AHQ / ALQ
5. Muting function
Through setting pin(1) (mute terminal) at about 1V or less, muting
becomes possible.
The interval circuit of IC is shown in Fig.5.
When pin(1) is set to low, Q1 and Q2 are turned to on, the charge
of the ripple condenser is discharged and the bias is cut. The mute
amount of 60dB or over can be obtained.
Since this muting function rapidly discharge the charge of the ripple
filter capacitor of pin(8), the pop noise is generated by the DC
fluctuation of the bias section.
Therefore, this muting function is not appropriate to the audio muting but it
is effective in muting at VCCon.
6. Rapid ripple discharging circuit at the time of VCC off
This circuit is effective in such a mode where the VCC and the standby terminals become high / low
simultaneously ; for instance, for a pop noise produced when the power is turned on / off repeatedly by operating
the ignition key.
If VCC is off, VCC7V is detected internally on IC and
(1) The power stage bias circuit is cut, and
(2) Pin(8) : Ripple capacitor is rapidly discharged by turning Q3 on and then Q1 and Q2 on.
(Precaution 1)
When the standby terminal was put to the low level after the ripple rapid
discharging circuit was operated (VCC7V) at the time when VCC was turned
off, a pop noise may be generated. Therefore, VCC which makes the standby
terminal low shall be set at 8V or above so that (1) the standby terminal is
put at the low level and (2) the ripple rapid discharging circuit is turned on
when VCC is turned off (in order of (1) and (2)).
An example of application is shown in (Fig.7).
5 2004-09-28
Free Datasheet http://www.Datasheet4U.com

5 Page





TA8221AHQ arduino
TA8221AHQ / ALQ
11
2004-09-28
Free Datasheet http://www.Datasheet4U.com

11 Page







PáginasTotal 14 Páginas
PDF Descargar[ Datasheet TA8221AHQ.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
TA8221AH30W BTL x 2CH AUDIO POWER AMPLIFIERToshiba Semiconductor
Toshiba Semiconductor
TA8221AHQ30W BTL X 2Ch Audio Power AmplifierToshiba
Toshiba

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar