DataSheetWiki


25Q80A fiches techniques PDF

EON - EN25Q80A

Numéro de référence 25Q80A
Description EN25Q80A
Fabricant EON 
Logo EON 





1 Page

No Preview Available !





25Q80A fiche technique
EN25Q80A
EN25Q80A
8 Megabit Serial Flash Memory with 4Kbyte Uniform Sector
FEATURES
Single power supply operation
- Full voltage range: 2.7-3.6 volt
Serial Interface Architecture
- SPI Compatible: Mode 0 and Mode 3
8 M-bit Serial Flash
- 8 M-bit/1024 K-byte/4096 pages
- 256 bytes per programmable page
Standard, Dual or Quad SPI
- Standard SPI: CLK, CS#, DI, DO, WP#
- Dual SPI: CLK, CS#, DQ0, DQ1, WP#
- Quad SPI: CLK, CS#, DQ0, DQ1, DQ2, DQ3
High performance
- 100MHz clock rate for one data bit
- 80MHz clock rate for two data bits
- 80MHz clock rate for four data bits
Low power consumption
- 12 mA typical active current
- 1 μA typical power down current
Uniform Sector Architecture:
- 256 sectors of 4-Kbyte
- 16 blocks of 64-Kbyte
- Any sector or block can be erased individually
Software and Hardware Write Protection:
- Write Protect all or portion of memory via
software
- Enable/Disable protection with WP# pin
High performance program/erase speed
- Page program time: 1.3ms typical
- Sector erase time: 90ms typical
- Block erase time 500ms typical
- Chip erase time: 8 seconds typical
Lockable 256 byte OTP security sector
Minimum 100K endurance cycle
Package Options
- 8 pins SOP 150mil body width
- 8 pins SOP 200mil body width
- 8 contact VDFN
- 8 pins PDIP
- All Pb-free packages are RoHS compliant
Industrial temperature Range
GENERAL DESCRIPTION
The EN25Q80A is an 8 Megabit (1024K-byte) Serial Flash memory, with advanced write protection
mechanisms. The EN25Q80A supports the standard Serial Peripheral Interface (SPI), and a high
performance Dual output as well as Quad I/O using SPI pins: Serial Clock, Chip Select, Serial DQ0(DI),
DQ1(DO), DQ2(WP#) and DQ3(NC). SPI clock frequencies of up to 80MHz are supported allowing
equivalent clock rates of 160MHz for Dual Output and 320MHz for Quad Output when using the
Dual/Quad Output Fast Read instructions. The memory can be programmed 1 to 256 bytes at a time,
using the Page Program instruction.
The EN25Q80A is designed to allow either single Sector/Block at a time or full chip erase operation. The
EN25Q80A can be configured to protect part of the memory as the software protected mode. The
device can sustain a minimum of 100K program/erase cycles on each sector or block.
This Data Sheet may be revised by subsequent versions
or modifications due to changes in technical specifications.
1
©2004 Eon Silicon Solution, Inc.,
Rev. D, Issue Date: 2009/10/13
www.eonssi.com
Free Datasheet http://www.datasheet4u.net/

PagesPages 30
Télécharger [ 25Q80A ]


Fiche technique recommandé

No Description détaillée Fabricant
25Q80A EN25Q80A EON
EON
25Q80BSIG Dual and Quad Serial Flash GigaDevice
GigaDevice
25Q80BV W25Q80BV Winbond
Winbond
25Q80BW W25Q80BW Winbond
Winbond

US18650VTC5A

Lithium-Ion Battery

Sony
Sony
TSPC106

PCI Bus Bridge Memory Controller

ATMEL
ATMEL
TP9380

NPN SILICON RF POWER TRANSISTOR

Advanced Semiconductor
Advanced Semiconductor


www.DataSheetWiki.com    |   2020   |   Contactez-nous  |   Recherche