35N15E Datasheet PDF - Motorola Semiconductors
| Part Number | 35N15E | |
| Description | MTW35N15E | |
| Manufacturers | Motorola Semiconductors | |
| Logo |  |
|
|
There is a preview and 35N15E download ( pdf file ) link at the bottom of this page. Total 8 Pages | ||
Preview 1 page No Preview Available !
MOTOROLA
SEMICONDUCTOR TECHNICAL DATA
Order this document
by MTW35N15E/D
Designer's
™ Data Sheet
TMOS E-FET .™
Power Field Effect Transistor
TO-247 with Isolated Mounting Hole
N–Channel Enhancement–Mode Silicon Gate
This advanced TMOS E–FET is designed to withstand high
energy in the avalanche and commutation modes. The new energy
efficient design also offers a drain–to–source diode with a fast
recovery time. Designed for low voltage, high speed switching
applications in power supplies, converters and PWM motor
controls, these devices are particularly well suited for bridge circuits
where diode speed and commutating safe operating areas are
critical and offer additional safety margin against unexpected
voltage transients.
• Avalanche Energy Specified
• Source–to–Drain Diode Recovery Time Comparable to a
Discrete Fast Recovery Diode
• Diode is Characterized for Use in Bridge Circuits
• IDSS and VDS(on) Specified at Elevated Temperature
• Isolated Mounting Hole Reduces Mounting Hardware
G
®
D
S
MTW35N15E
Motorola Preferred Device
TMOS POWER FET
35 AMPERES
150 VOLTS
RDS(on) = 0.05 OHM
CASE 340K–01, Style 1
TO–247AE
MAXIMUM RATINGS (TC = 25°C unless otherwise noted)
Rating
Drain–Source Voltage
Drain–Gate Voltage (RGS = 1.0 MΩ)
Gate–Source Voltage — Continuous
Gate–Source Voltage — Non–Repetitive (tp ≤ 10 ms)
Symbol
VDSS
VDGR
VGS
VGSM
Value
150
150
± 20
± 40
Unit
Vdc
Vdc
Vdc
Vpk
Drain Current — Continuous
Drain Current — Continuous @ 100°C
Drain Current — Single Pulse (tp ≤ 10 µs)
Total Power Dissipation
Derate above 25°C
ID 35 Adc
ID 26.9
IDM 105 Apk
PD 180 Watts
1.45 W/°C
Operating and Storage Temperature Range
TJ, Tstg – 55 to 150
°C
Single Pulse Drain–to–Source Avalanche Energy — Starting TJ = 25°C
(VDD = 80 Vdc, VGS = 10 Vdc, IL = 20 Apk, L = 3.0 mH, RG = 25 Ω)
EAS 600 mJ
Thermal Resistance — Junction to Case
Thermal Resistance — Junction to Ambient
RθJC
RθJA
0.70 °C/W
62.5
Maximum Lead Temperature for Soldering Purposes, 1/8″ from case for 10 seconds
TL 260 °C
Designer’s Data for “Worst Case” Conditions — The Designer’s Data Sheet permits the design of most circuits entirely from the information presented. SOA Limit
curves — representing boundaries on device characteristics — are given to facilitate “worst case” design.
E–FET and Designer’s are trademarks of Motorola, Inc. TMOS is a registered trademark of Motorola, Inc.
Preferred devices are Motorola recommended choices for future use and best overall value.
REV 3
© MMoototororloa,laIncT.M19O96S Power MOSFET Transistor Device Data
1
Free Datasheet http://www.datasheet4u.com/
|
| |
 
12
10
8.0 Q1
120
QT
100
VGS
Q2 80
6.0 60
4.0 TJ = 25°C 40
ID = 35 A
2.0 20
Q3 VDS
00
0 20 40 60 80 100
QT, TOTAL CHARGE (nC)
Figure 8. Gate–To–Source and Drain–To–Source
Voltage versus Total Charge
1000
VDD = 75 V
ID = 35 A
VGS = 10 V
TJ = 25°C
tr
100 tf
td(off)
MTW35N15E
td(on)
10
0 10 100
RG, GATE RESISTANCE (OHMS)
Figure 9. Resistive Switching Time
Variation versus Gate Resistance
DRAIN–TO–SOURCE DIODE CHARACTERISTICS
35
VGS = 0 V
30 TJ = 25°C
25
20
15
10
5
0
0.5 0.55 0.6 0.65 0.7 0.75 0.8 0.85 0.9
VSD, SOURCE–TO–DRAIN VOLTAGE (VOLTS)
0.95
Figure 10. Diode Forward Voltage versus Current
SAFE OPERATING AREA
The Forward Biased Safe Operating Area curves define
the maximum simultaneous drain–to–source voltage and
drain current that a transistor can handle safely when it is for-
ward biased. Curves are based upon maximum peak junc-
tion temperature and a case temperature (TC) of 25°C. Peak
repetitive pulsed power limits are determined by using the
thermal response data in conjunction with the procedures
discussed in AN569, “Transient Thermal Resistance–General
Data and Its Use.”
Switching between the off–state and the on–state may tra-
verse any load line provided neither rated peak current (IDM)
nor rated voltage (VDSS) is exceeded and the transition time
(tr,tf) do not exceed 10 µs. In addition the total power aver-
aged over a complete switching cycle must not exceed
(TJ(MAX) – TC)/(RθJC).
A Power MOSFET designated E–FET can be safely used
in switching circuits with unclamped inductive loads. For reli-
able operation, the stored energy from circuit inductance dis-
sipated in the transistor while in avalanche must be less than
the rated limit and adjusted for operating conditions differing
from those specified. Although industry practice is to rate in
terms of energy, avalanche energy capability is not a con-
stant. The energy rating decreases non–linearly with an in-
crease of peak current in avalanche and peak junction
temperature.
Although many E–FETs can withstand the stress of drain–
to–source avalanche at currents up to rated pulsed current
(IDM), the energy rating is specified at rated continuous cur-
rent (ID), in accordance with industry custom. The energy rat-
ing must be derated for temperature as shown in the
accompanying graph (Figure 12). Maximum energy at cur-
rents below rated continuous ID can safely be assumed to
equal the values indicated.
Motorola TMOS Power MOSFET Transistor Device Data
5
Free Datasheet http://www.datasheet4u.com/
Preview 5 Page |
Part DetailsOn this page, you can learn information such as the schematic, equivalent, pinout, replacement, circuit, and manual for 35N15E electronic component. |
| Information | Total 8 Pages | |
| Link URL | [ Copy URL to Clipboard ] | |
| Download | [ 35N15E.PDF Datasheet ] | |
Share Link :
Electronic Components Distributor
|
An electronic components distributor is a company that sources, stocks, and sells electronic components to manufacturers, engineers, and hobbyists. |
| SparkFun Electronics | Allied Electronics | DigiKey Electronics | Arrow Electronics |
| Mouser Electronics | Adafruit | Newark | Chip One Stop |
Featured Datasheets
| Part Number | Description | MFRS |
| 35N15E | The function is MTW35N15E. Motorola Semiconductors | |
Semiconductors commonly used in industry:
1N4148 |
BAW56 |
1N5400 |
NE555 | | ||
Quick jump to:
35N1
1N4
2N2
2SA
2SC
74H
BC
HCF
IRF
KA | ||