|
|
PDF KA35S280 Data sheet ( Hoja de datos )
| Número de pieza | KA35S280 | |
| Descripción | (KA35S280 / KA35S281) Lead-Acid Battery Charger | |
| Fabricantes | Kasin | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de KA35S280 (archivo pdf) en la parte inferior de esta página. Total 19 Páginas | ||
|
No Preview Available !
Charge Control
DATA SHEET
www.DataSheet.co.kr
KA35S280;KA35S281
Lead-Acid Battery Charger
Product Specification
2011 Nov 18
Kasin
Corporation
Datasheet pdf - http://www.DataSheet4U.net/
1 page  
KA35S280/281
Lead-Acid Battery Charger
- Pin Configuration
- Mode selection pins
The KA35S28X can be programmed into 3 different charge algorithm named as 3-step
voltage, current and pulsed current by mode selection pins. Table 3 shows the relations
between MS0/MS1 selection pins and IC operation.
Table 3 – Mode Selection pins
MS1 MS0 Mode
Description
00
0 Charge is disabled
01
1 3-step voltage charge
10
2 Current charge
11
3 Pulsed current Charge
- Faster charge pin
The faster charge pin can be change internal DC voltage threshold of max current by 25%
(50mV). In normal condition it is configured to 200mV by internal voltage reference
generator unit.
Table 4 – Mode Selection pins
Faster Pin
0
1
Description
Charge current increased by 25%
Normal current charge
- Cyclic/Float use pin
Due to recent design breakthroughs, the same battery may be used in either cyclic or
standby applications and it is necessary to set the charge voltage according to it. Inaccurate
www.DataSheet.co.kr
voltage settings cause over- or under-charge. In applications where standby power is
required to operate when the power has been interrupted, continuous float charging is
recommended. Non-continuous cyclic charging is used primarily with portable equipment
where charging on an intermittent basis is appropriate.
The cyclic/float pin can be change internal charge reference voltage and method of
temperature compensation.
Table 5 – Mode Selection pins
Cyclic/Float Pin
0
1
Description
In cyclic use
In float use
- Fixed and Configurable Thresholds
The KA35S28X uses the following fixed thresholds:
VMAX High-Cutoff Voltage: VBAT rising above this level is interpreted as battery
removal, cutting off charging current. VMAX = 0.6 * VCC.
VMIN Low-Cutoff Voltage: VBAT dropping below this level is interpreted as battery
removal, cutting off charging current. VMIN = 0.2 * VCC.
VTH Minimum Voltage: Used in pre-charge qualification. VTH = 0.34 * VCC.
ICOND Conditioning Current: Used in the maintenance phase of the Current algorithm
and pre-charge qualification. ICOND = IMAX/5. IMAX is set by Equation 2.
Also the KA35S28X uses the following configurable thresholds:
VBLK Upper voltage limit during fast charge, typically specified by the battery
manufacturers to be 2.3V in float and 2.45 in cyclic applications per cell @
25°C. KA35S28X uses 2.45V for VBLK when Cyclic/Float pin is set 0.
VFLT Minimum charge voltage required to compensate for the battery’s self-discharge
rate and maintain full charge on the battery.
2011 Nov 18
© 2011 Kasin Technology Inc.
5
Datasheet pdf - http://www.DataSheet4U.net/
5 Page 
Typical Application
KA35S280/281
Lead-Acid Battery Charger
+ 7805
15 (7) - 30 V
-
Switch
Network
3300uF (50V)
1N4007 (1A)
1 VDD
2
SW
3
MS0
4
MS1
5
Faster
6
Cyclic/Float
7
TEMP
KA35S28Xwww.DataSheet.co.kr
VSS
VBAT
I BAT
LED0
LED1
LED2
LED3
14
13
12
11
10
9
1N4007 (1A)
8
BAT+
RB1
12 (6) V
RB2
BAT-
R
SNS
N
3 (6V)
6 (12V)
12 (24V)
RB1 (KΩ)
57KΩ
147KΩ
327KΩ
RB2 (KΩ)
33KΩ
33KΩ
33KΩ
IMAX
100mA
300mA
500mA
RSNS (Ω)
2Ω
0.66Ω
0.4Ω
Figure 12 – A Very Simple High Power 3-Step Voltage Lead-Acid Battery Charger
2011 Nov 18
11
© 2011 Kasin Technology Inc.
Datasheet pdf - http://www.DataSheet4U.net/
11 Page | ||
| Páginas | Total 19 Páginas | |
| PDF Descargar | [ Datasheet KA35S280.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| KA35S280 | (KA35S280 / KA35S281) Lead-Acid Battery Charger | Kasin |
| KA35S281 | (KA35S280 / KA35S281) Lead-Acid Battery Charger | Kasin |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |