DataSheet.es    


PDF LV5856MX Data sheet ( Hoja de datos )

Número de pieza LV5856MX
Descripción Step-down Switching Regulator
Fabricantes Sanyo Semicon Device 
Logotipo Sanyo Semicon Device Logotipo



Hay una vista previa y un enlace de descarga de LV5856MX (archivo pdf) en la parte inferior de esta página.


Total 5 Páginas

No Preview Available ! LV5856MX Hoja de datos, Descripción, Manual

www.DataSheet.co.kr
Ordering number : ENA1639
Bi-CMOS IC
LV5856MX Step-down Switching Regulator
Overview
LV5856MX is a 1ch step-down switching regulator. With built-in two 0.13Ω power MOSFET switch, it achieves high
output current and high efficiency. With low-heat resistance, miniature package MFP8 (200mil) with heat-sink is adopted.
Since it is Current mode control type, it has good load current response, and phase compensation is easy. With ON/OFF pin,
operating can be less than 60μA at stand-by mode. It has cycle-by-cycle over current protection for load devices. With
external capacitor, it achieves soft start.
Functions
3A 1ch step-down
Small package: MFP8 (200mil) with heat sink
High efficiency (93% IOUT = 1A, VIN = 12V, VO = 5V)
Standby mode
Over-current protection(HICCUP)
Thermal shutdown protection
Reference voltage: 0.923V
Fixed frequency: 340kHz
Soft start / Soft stop
Specifications
Maximum Ratings at Ta = 25°C
Parameter
Maximum input VIN voltage
BOOT pin maximum voltage
SW pin maximum voltage
BOOT pin-SW pin maximum voltage
EN Maximum Voltage
FB, COMP, SS pin maximum voltage
Allowable power dissipation
Symbol
VIN max
VBT max
VSW max
VBS-SW max
VEN max
Vfs max
Pd max
Conditions
Mount on a specified board *
Ratings
20
25
VIN max
7
20
7
2.05
Junction temperature
Tj max
150
Operating temperature
Topr
-20 to 80
Storage temperature
Tstg
-40 to 150
Specified substrate : 46.0mm х 32.0mm х 1.6mm glass epoxy substrate.
Note: Plan the maximum voltage while including coil and surge voltages, so that the maximum voltage is not exceeded even for an instant.
Unit
V
V
V
V
V
V
W
°C
°C
°C
Any and all SANYO Semiconductor Co.,Ltd. products described or contained herein are, with regard to
"standard application", intended for the use as general electronics equipment (home appliances, AV equipment,
communication device, office equipment, industrial equipment etc.). The products mentioned herein shall not be
intended for use for any "special application" (medical equipment whose purpose is to sustain life, aerospace
instrument, nuclear control device, burning appliances, transportation machine, traffic signal system, safety
equipment etc.) that shall require extremely high level of reliability and can directly threaten human lives in case
of failure or malfunction of the product or may cause harm to human bodies, nor shall they grant any guarantee
thereof. If you should intend to use our products for applications outside the standard applications of our
customer who is considering such use and/or outside the scope of our intended standard applications, please
consult with us prior to the intended use. If there is no consultation or inquiry before the intended use, our
customer shall be solely responsible for the use.
Specifications of any and all SANYO Semiconductor Co.,Ltd. products described or contained herein stipulate
the performance, characteristics, and functions of the described products in the independent state, and are not
guarantees of the performance, characteristics, and functions of the described products as mounted in the
customer's products or equipment. To verify symptoms and states that cannot be evaluated in an independent
device, the customer should always evaluate and test devices mounted in the customer's products or
equipment.
12910 SY 20091216-S00006 No.A1639-1/5
Datasheet pdf - http://www.DataSheet4U.net/

1 page




LV5856MX pdf
www.DataSheet.co.kr
LV5856MX
SANYO Semiconductor Co.,Ltd. assumes no responsibility for equipment failures that result from using
products at values that exceed, even momentarily, rated values (such as maximum ratings, operating condition
ranges, or other parameters) listed in products specifications of any and all SANYO Semiconductor Co.,Ltd.
products described or contained herein.
SANYO Semiconductor Co.,Ltd. strives to supply high-quality high-reliability products, however, any and all
semiconductor products fail or malfunction with some probability. It is possible that these probabilistic failures or
malfunction could give rise to accidents or events that could endanger human lives, trouble that could give rise
to smoke or fire, or accidents that could cause damage to other property. When designing equipment, adopt
safety measures so that these kinds of accidents or events cannot occur. Such measures include but are not
limited to protective circuits and error prevention circuits for safe design, redundant design, and structural
design.
In the event that any or all SANYO Semiconductor Co.,Ltd. products described or contained herein are
controlled under any of applicable local export control laws and regulations, such products may require the
export license from the authorities concerned in accordance with the above law.
No part of this publication may be reproduced or transmitted in any form or by any means, electronic or
mechanical, including photocopying and recording, or any information storage or retrieval system, or otherwise,
without the prior written consent of SANYO Semiconductor Co.,Ltd.
Any and all information described or contained herein are subject to change without notice due to
product/technology improvement, etc. When designing equipment, refer to the "Delivery Specification" for the
SANYO Semiconductor Co.,Ltd. product that you intend to use.
Information (including circuit diagrams and circuit parameters) herein is for example only; it is not guaranteed
for volume production.
Upon using the technical information or products described herein, neither warranty nor license shall be granted
with regard to intellectual property rights or any other rights of SANYO Semiconductor Co.,Ltd. or any third
party. SANYO Semiconductor Co.,Ltd. shall not be liable for any claim or suits with regard to a third party's
intellctual property rights which has resulted from the use of the technical information and products mentioned
above.
This catalog provides information as of January, 2010. Specifications and information herein are subject
to change without notice.
PS No.A1639-5/5
Datasheet pdf - http://www.DataSheet4U.net/

5 Page










PáginasTotal 5 Páginas
PDF Descargar[ Datasheet LV5856MX.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
LV5856MXStep-down Switching RegulatorSanyo Semicon Device
Sanyo Semicon Device

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar