DataSheet.es    


PDF LV5710V Data sheet ( Hoja de datos )

Número de pieza LV5710V
Descripción Power supply
Fabricantes Sanyo Semicon Device 
Logotipo Sanyo Semicon Device Logotipo



Hay una vista previa y un enlace de descarga de LV5710V (archivo pdf) en la parte inferior de esta página.


Total 6 Páginas

No Preview Available ! LV5710V Hoja de datos, Descripción, Manual

www.DataSheet.co.kr
Ordering number : ENA1117
LV5710V
Bi-CMOS LSI
For camera sensor
Power supply for charge pump
Overview
The LV5710V is power supply for charge pump for camera sensor.
Functions
Regulating the 5V input by boosting it three-fold with the charge pump to the specified voltage.
Output voltage variable with external resistor.
Soft start function incorporated, which reduces the rush current at start of charge pump.
Timer-latch type short-circuit protective function incorporated.
Specifications
Absolute Maximum Ratings at Ta = 25°C
Parameter
Maximum supply voltage
Allowable power dissipation
Operating temperature
Storage temperature
Symbol
VDD max
Pd max
Topr
Tstg
Conditions
with specified substrate *
* : Specified substrate : 114.3mm×76.1mm×1.6mm, glass epoxy board
Allowable Operating Ratings at Ta = 25°C
Parameter
Supply voltage
Input “H” voltage
Input “L” voltage
Symbol
VDD
VINH
VINL
EN pin
EN pin
Conditions
Ratings
6.0
0.55
-20 to +80
-40 to +125
min
4.5
1.5
-0.1
Ratings
typ
max
5.5
VDD
0.4
Unit
V
W
°C
°C
Unit
V
V
V
Any and all SANYO Semiconductor products described or contained herein do not have specifications
that can handle applications that require extremely high levels of reliability, such as life-support systems,
aircraft's control systems, or other applications whose failure can be reasonably expected to result in
serious physical and/or material damage. Consult with your SANYO Semiconductor representative
nearest you before using any SANYO Semiconductor products described or contained herein in such
applications.
SANYO Semiconductor assumes no responsibility for equipment failures that result from using products
at values that exceed, even momentarily, rated values (such as maximum ratings, operating condition
ranges, or other parameters) listed in products specifications of any and all SANYO Semiconductor
products described or contained herein.
31908 MS PC 20080226-S00011 No.A1117-1/6
Datasheet pdf - http://www.DataSheet4U.net/

1 page




LV5710V pdf
www.DataSheet.co.kr
LV5710V
Output Voltage Setting Method
The output voltage of IC-incorporated LDO can be determined as follows :
VH =
R1+R2
R2
× VREF
For example, to set the output voltage to 12V, set the resistance
Value to R1 = 1070kΩ/R2 = 130kΩ.
CPO
RO
R1
VREF = 1.3V FB
R2
Short-circuit Protective Operation
The RO output pin has the short-circuit protective function.
The over-current detector circuit outputs the detection signal when the output current of 50mA (typ) or more flows or
when the output voltage drops below 87.5% (typ). When this detection signal is output continuously for 18ms (typ) or
more, IC determines that there is over-current and stops the output. To reset from the stop state, set the EN pin to “L”,
then set the EN pin to “H” again.
CPO
RO
Output voltage
FB
- detection comparator
+
0.875
× VREF
+
Short-circuit
detection signal
- Output current
detection comparator
VREF
Equivalent circuit of the over-current detection circuit
Selecting the Frequency
According to the logic of S0 and S1, the charge pump operation frequency can be changed.
In the case of light load, the reactive power can be reduced by decreasing the operating frequency.
S0 S1
CP operating frequency
LL
1MHz
HL
500kHz
LH
250kHz
HH
125kHz
No.A1117-5/6
Datasheet pdf - http://www.DataSheet4U.net/

5 Page










PáginasTotal 6 Páginas
PDF Descargar[ Datasheet LV5710V.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
LV5710GPPower supplySanyo Semicon Device
Sanyo Semicon Device
LV5710GPPower Supply for Charge PumpON Semiconductor
ON Semiconductor
LV5710VPower supplySanyo Semicon Device
Sanyo Semicon Device

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar