DataSheet.es    


PDF NL6448BC33-70D Data sheet ( Hoja de datos )

Número de pieza NL6448BC33-70D
Descripción Display Module
Fabricantes NEC 
Logotipo NEC Logotipo



Hay una vista previa y un enlace de descarga de NL6448BC33-70D (archivo pdf) en la parte inferior de esta página.


Total 29 Páginas

No Preview Available ! NL6448BC33-70D Hoja de datos, Descripción, Manual

www.DataSheet.co.kr
TFT COLOR LCD MODULE
NL6448BC33-70D
26cm (10.4 Type)
VGA
DATA SHEET
DOD-PP-0955 (1st edition)
This DATA SHEET is updated document from
PRELIMINARY DATA SHEET DOD-PP-0914(2).
All information is subject to change without notice.
Please confirm the sales representative before
starting to design your system.
Document Number: DOD-PP-0955 (1st edition)
Published date: March 2010 CP(N)
1 © NEC LCD Technologies, Ltd.
2010 All rights reserved.
Datasheet pdf - http://www.DataSheet4U.net/

1 page




NL6448BC33-70D pdf
www.DataSheet.co.kr
NL6448BC33-70D
2. GENERAL SPECIFICATIONS
Display area
Diagonal size of display
Drive system
Display color
Pixel
Pixel arrangement
Dot pitch
Pixel pitch
Module size
Weight
Contrast ratio
Viewing angle
Designed viewing direction
Polarizer surface
Polarizer pencil-hardness
Color gamut
Response time
Luminance
Signal system
Power supply voltage
211.2 (H) × 158.4 (V) mm
26cm (10.4 inches)
a-Si TFT active matrix
262,144 colors
640 (H) × 480 (V) pixels
RGB (Red dot, Green dot, Blue dot) vertical stripe
0.11 (H) × 0.33 (V) mm
0.33 (H) × 0.33 (V) mm
243.0 (W) × 185.1 (H) × 10.5 (D) mm (typ.)
475g (typ.)
900:1 (typ.)
At the contrast ratio 10:1
Horizontal: Right side 80° (typ.), Left side 80° (typ.)
Vertical: Up side 80° (typ.), Down side 80° (typ.)
At DPS= Low or Open: Normal scan
Viewing direction without image reversal: Up side (12 o'clock)
Viewing direction with contrast peak: Down side (6 o'clock)
Viewing angle with optimum grayscale (γ2.2): Normal axis
(perpendicular)
Antiglare
3H (min.) [by JIS K5400]
At LCD panel center
40% (typ.) [against NTSC color space]
Ton+Toff (10%←→ 90%)
18ms (typ.)
At IL= 50mA/One circuit
450cd/m2 (typ.)
6-bit digital signals for data of RGB colors,
Dot clock (CLK), Data enable (DE),
Horizontal synchronous signal (Hsync),
Vertical synchronous signal (Vsync)
LCD panel signal processing board: 3.3V or 5.0V
LED backlight type:
Backlight
Replaceable part
Lamp holder set: Type No. 104LHS56
Power consumption
Recommended LED driver board (Option)
LED driver board :Type No. 104PW03F
At IL= 50mA/One circuit, Checkered flag pattern
3.7W (typ.)
DATA SHEET DOD-PP-0955 (1st edition)
5
Datasheet pdf - http://www.DataSheet4U.net/

5 Page





NL6448BC33-70D arduino
www.DataSheet.co.kr
4.4 POWER SUPPLY VOLTAGE SEQUENCE
4.4.1 LCD panel signal processing board
VCC
Note1
3.0V or 4.75V
0V
ON
10μsTr < 30ms
Display signals
Function signal
Note2
0V
0ms < t < 35ms
VALID period
NL6448BC33-70D
OFF ON
Toff > 50ms
0ms < t < 35ms
Note1: If there is a voltage variation (voltage drop) at the rising edge of VCC below 3.0V in "VCC =
3.3V" or 4.75V in "VCC = 5.0V", there is a possibility that a product does not work due to a
protection circuit.
Note2: Display signals (CLK, Hsync, Vsync, DE, DATA (R0 to R5, G0 to G5, B0 to B5)) and
function signal (DPS) must be set to Low or High-impedance, except the VALID period (See
above sequence diagram), in order to avoid the circuitry damage.
If some of display and function signals of this product are cut while this product is working,
even if the signal input to it once again, it might not work normally. If a customer stops the
display and function signals, VCC also must be shut down.
4.4.2 LED Driver board (Option)
Display signals
Function signal
Note1
Note2
VALID period
LED backlight: ON
Note1: These are the display and function signals for LCD panel signal processing board.
Note2: The backlight should be turned on within the valid period of display and function signals, in
order to avoid unstable data display.
DATA SHEET DOD-PP-0955 (1st edition)
11
Datasheet pdf - http://www.DataSheet4U.net/

11 Page







PáginasTotal 29 Páginas
PDF Descargar[ Datasheet NL6448BC33-70D.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
NL6448BC33-70LCD ModuleNEC
NEC
NL6448BC33-70CDisplay ModuleNEC
NEC
NL6448BC33-70DDisplay ModuleNEC
NEC
NL6448BC33-70FDisplay ModuleNEC
NEC

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar