|
|
Número de pieza | NL8060BC21-06 | |
Descripción | Display Module | |
Fabricantes | NEC | |
Logotipo | ||
Hay una vista previa y un enlace de descarga de NL8060BC21-06 (archivo pdf) en la parte inferior de esta página. Total 30 Páginas | ||
No Preview Available ! www.DataSheet.co.kr
TFT COLOR LCD MODULE
NL8060BC21-06
21cm (8.4 Type)
SVGA
LVDS interface (1port)
DATA SHEET
DOD-PP-0338 (1st edition)
All information is subject to change without notice.
Please confirm the sales representative before
starting to design your system.
Document Number: DOD-PP-0338 (1st edition)
Published date: August 2007 CP(N)
1 © NEC LCD Technologies, Ltd.
2007 All rights reserved.
Datasheet pdf - http://www.DataSheet4U.net/
1 page www.DataSheet.co.kr
NL8060BC21-06
2. GENERAL SPECIFICATIONS
Display area
170.4 (H) × 127.8 (V) mm
Diagonal size of display 21cm (8.4 inches)
Drive system
Display color
Pixel
a-Si TFT active matrix
16,777,216 colors (At 8-bit input, FRC terminal= High)
262,144 colors (At 6-bit input, FRC terminal= Low or Open)
800 (H) × 600 (V) pixels
Pixel arrangement
RGB (Red dot, Green dot, Blue dot) vertical stripe
Dot pitch
0.071 (H) × 0.213 (V) mm
Pixel pitch
0.213 (H) × 0.213 (V) mm
Module size
200.0 (W) × 152.0 (H) × 10.5 (D) mm (typ.)
Weight
330g (typ.)
Contrast ratio
Viewing angle
Designed viewing direction
Polarizer surface
600:1 (typ.)
At the contrast ratio ≥10:1
• Horizontal: Right side 80° (typ.), Left side 80° (typ.)
• Vertical: Up side 80° (typ.), Down side 60° (typ.)
At DPS terminal= Low or Open: Normal scan
• Viewing direction without image reversal: up side (12 o'clock)
• Viewing direction with contrast peak: down side (6 o'clock)
• Viewing angle with optimum grayscale (γ=2.2): normal axis
(perpendicular)
Clear
Polarizer pencil-hardness
Color gamut
Response time
Luminance
Signal system
Power supply voltage
3H (min.) [by JIS K5400]
At LCD panel center
40% (typ.) [against NTSC color space]
Ton+Toff (10%←→ 90%)
25ms (typ.)
At IBL= 5.0mArms/lamp
650cd/m2 (typ.)
LVDS 1port (Receiver: THC63LVDF84B, THine Electronics Inc. or
equivalent)
[8bit/6bit digital signals for data of RGB colors, Dot clock (CLK),
Data enable (DE)]
LCD panel signal processing board: 3.3V
Edge light type: 2 cold cathode fluorescent lamps
Backlight
Replaceable part
• Lamp holder set: Type No. 84LHS06
Power consumption
Recommended inverter (Option)
• Inverter: Type No. 84PW031, 84PW041
At IBL=5.0mArms / lamp, Checkered flag pattern
5.5W (typ., Power dissipation of the inverter is not included.)
DATA SHEET DOD-PP-0338 (1st edition)
5
Datasheet pdf - http://www.DataSheet4U.net/
5 Page www.DataSheet.co.kr
4.4 POWER SUPPLY VOLTAGE SEQUENCE
4.4.1 LCD panel signal processing board
VCC
Note1
0V
ON
3.0V
10μs ≤Tr< 50ms
Display signals*
Function signals
Note2
0V
0ms <t< 35ms
VALID period
NL8060BC21-06
OFF ON
0.3V
Toff≥ 50ms
0ms <t< 35ms
* These signals should be measured at the terminal of 100Ω resistance.
Note1: In terms of voltage variation (voltage drop) while VCC rising edge is below 3.0V, a protection
circuit may work, and then this product may not work.
Note2: Display signals (D0+/-, D1+/-, D2+/-, D3+/- and CLK+/-) and function signals (DPS and
FRC) must be Low or High-impedance, exclude the VALID period (See above sequence
diagram), in order to avoid that internal circuits is damaged.
If some of display and function signals of this product are cut while this product is working,
even if the signal input to it once again, it might not work normally. VCC should be cut when
the display and function signals are stopped.
4.4.2 Inverter (Option)
Display signals
Function signals
Note1
Note2
VALID period
VDDB
Note1: These are the display and function signals for LCD panel signal processing board.
Note2: The backlight should be turned on within the valid period of display and function signals, in
order to avoid unstable data display.
DATA SHEET DOD-PP-0338 (1st edition)
11
Datasheet pdf - http://www.DataSheet4U.net/
11 Page |
Páginas | Total 30 Páginas | |
PDF Descargar | [ Datasheet NL8060BC21-06.PDF ] |
Número de pieza | Descripción | Fabricantes |
NL8060BC21-02 | Display Module | NEC |
NL8060BC21-03 | Display Module | NEC |
NL8060BC21-04 | LCD Module | NEC |
NL8060BC21-06 | Display Module | NEC |
Número de pieza | Descripción | Fabricantes |
SLA6805M | High Voltage 3 phase Motor Driver IC. |
Sanken |
SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
Analog Devices |
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |