DataSheetWiki


LX2201 fiches techniques PDF

Microsemi Corporation - USB Li-Ion Battery Charger

Numéro de référence LX2201
Description USB Li-Ion Battery Charger
Fabricant Microsemi Corporation 
Logo Microsemi Corporation 





1 Page

No Preview Available !





LX2201 fiche technique
LX2201
www.DataSheet4U.com
TM ® USB Li-Ion Battery Charger
PRODUCTION DATA SHEET
DESCRIPTION
The LX2201 Linear Battery Charger is a
multi-state (2 stage) Li-Ion battery charger
(Constant current / Constant voltage) that
can supply up to 2A of charging current into
a single cell Li-Ion battery.
LX2201 is a cost effective , high perfor-
mance USB battery charger. The LX2201
features a 2A high charge current, with
automatic power savings using isolated
battery topology, user programmability in
USB charging, and an extended battery life
with low RdsON in discharge.
In USB mode, the LX2201 has
advantages over competition chargers with
the USB Limit Control circuit and low
RdsON in discharge mode. The USB limit
Control circuit allows simultaneous battery
charging while the device is in operation.
The VDD to supply load is independent of
the VBAT charging logic. In discharge mode
a low RdsON provides low loss and heavy
transient.
The LX2201 is a low cost, highly
integrated battery charger solution. . It only
requires three external resistors: one for
setting the constant charge current level, one
for setting the termination charge current,
and one for setting VIN . It also has a built
in thermostat that will throttle back the
charge current to keep the die temperature
from exceeding 150°C; this feature insures
the LX2201 delivers the maximum charge
rate for a given thermal environment.
LX2201 support two types of Li-Ion
battery chemistry; 4.1V and 4.2V through
logical input (VM pin).. A high accuracy
current sensing circuit allows batteries to
be fully charged before terminating the
charge cycle. The LX2201 design
enhances system battery life by avoiding
premature discharge of Li-Ion battery with
a separate battery terminal voltage from
system load when adaptor charging is used,
i.e. trickle charge.
The LX2201 provides a charging status
indicator. The integrated PMOS pass element
features low drop out voltage while providing
an inherent load disconnect with virtually no
drain on the battery when disabled or when
the input power is removed. Additionally a
battery load disconnect switch has been
integrated which provides seamless power
switching when transitioning between charge
and discharge modes.
The LX2201 features a pre-charge
conditioning mode for batteries that have
been deeply discharged and also has a top off
charge mode for batteries that are left on the
charger for extended periods.
The LX2201 is available in a high power
4mm x 4mm, 20-pin MLP, surface mount
package.
IMPORTANT: For the most current data, consult MICROSEMI’s website: http://www.microsemi.com
KEY FEATURES
ƒ 2A Charge Current
ƒ USB Compliant Charging States
ƒ Low RdsON in Discharge Mode
ƒ Power Saving and Conditional
Mode for Deep Discharge
ƒ Selectable Li-Ion Battery for 4.1V
or 4.2V Applications
ƒ Internal Pass Element Can
Function as a Reverse Direction
Load Switch
ƒ No Sense Resistor Required
ƒ Full Capacity Charging
ƒ True Charge Indicator
ƒ Wall Supply Regulator Tolerance
5V + 10%
ƒ Built In MOSFET Driver For Easy
AC Adapter/USB Implementation
ƒ Topping Charge with Voltage
Monitoring Mode
ƒ Inherent Load Disconnect
ƒ Small, High Power 20-lead MLP
package
APPLICATIONS
ƒ Batteries with 350mAH to 2AH
Ratings
ƒ Cell Phones
ƒ PDAs
ƒ Charging Cradles
ƒ Digital Cameras
ƒ Low Cost Single Li-Ion Cell
Chargers
USB Lo / Hi
To System
Regulator
AC/DC Adapter
USB POWER
VDD
BAT
VDD
BAT
VDD LX2201 BAT
VDD
BAT
VIN CMP
PRODUCT HIGHLIGHT
VID0
0
0
1
1
VID1
0
1
0
1
State Select Truth Table
VDD > VBAT
Switch open – charging
VBAT > VDD
Switch open – discharge
disabled.
disabled.
Charging – USB high level if Switch open – discharge
using VIN.
disabled.
Charging – USB low level if
using VIN.
Charging – USB high level if
using VIN.
Battery Discharging. MOSFET
fully enhanced with current
flow VBAT to VDD.
Battery Discharging. MOSFET
fully enhanced with current
flow VBAT to VDD.
Copyright © 2000
Rev. 1.2b, 2005-04-13
PACKAGE ORDER INFO
TA(°C)
Plastic MLP
LQ 4x4mm 20-Pin
RoHS Complaint / Pb-free
0 to 70
LX2201CLQ
Note: Available in Tape & Reel.
Append the letters “TR” to the part number.
(i.e. LX2201CLQ-TR)
Microsemi
Integrated Products Division
11861 Western Avenue, Garden Grove, CA. 92841, 714-898-8121, Fax: 714-893-2570
Page 1

PagesPages 11
Télécharger [ LX2201 ]


Fiche technique recommandé

No Description détaillée Fabricant
LX2201 USB Li-Ion Battery Charger Microsemi Corporation
Microsemi Corporation
LX2202 2A Li-Ion Linear Charger and Power Control Microsemi Corporation
Microsemi Corporation
LX2203 Li-Ion Battery Charger Microsemi Corporation
Microsemi Corporation
LX2203A Li-Ion Battery Charger Microsemi Corporation
Microsemi Corporation

US18650VTC5A

Lithium-Ion Battery

Sony
Sony
TSPC106

PCI Bus Bridge Memory Controller

ATMEL
ATMEL
TP9380

NPN SILICON RF POWER TRANSISTOR

Advanced Semiconductor
Advanced Semiconductor


www.DataSheetWiki.com    |   2020   |   Contactez-nous  |   Recherche