RFC042 Datasheet PDF - RFHIC
| Part Number | RFC042 | |
| Description | Mobile Radio Mini Amplifier | |
| Manufacturers | RFHIC | |
| Logo |  |
|
|
There is a preview and RFC042 download ( pdf file ) link at the bottom of this page. Total 5 Pages | ||
Preview 1 page No Preview Available !
Mobile Radio Mini Amplifier RFC042
www.DataSheet4U.com
Product Features
• GaAs MMIC
• Very Low Distortion
• Guaranteed Broadband Power Gain
• Heat Sink 99.9% Copper, Ag or Gold Plate
• Excellent Thermal Conductivity
• Single Supply Voltage @ 24V
• Low DC Power Consumption
• No External Circuit needed
Application
• Drive Amplifier
Description
The RFC042 is specifically designed for up to 800MHz in frequency as amplifiers in BTS.
This hybrid dynamic range amplifier module operates with a single voltage supply of 24V(DC).
The RFC042 is equipped with over-voltage suppressor.
Specifications
Absolute Maximum Ratings
PARAMETER
VDD / VRFOUT
RFIN
Storage Temperature
Operating Temperature
Electrical Specifications (TA = +25℃, VDD = 24V)
PARAMETER
Bandwidth (MHz)
Gain @870MHz (dB)
Gain Flatness @870MHz (dB)
S11 (dB)
S22 (dB)
400MHz
IP3 (dBm)
600MHz
800MHz
IMD3 (dBc)
Two Tone 20dBm Output
f1=400 MHz,
f1=600 MHz,
f1= 799MHz,
f2=401 MHz
f2=601 MHz
f2=800 MHz
CDMA (dBm) 29dBc@750KHz
1FA
3FA
8FA
Noise Figure (dB) @ 870MHz
Supply Current (mA)
MIN
0
-
-40
-20
MIN
400
21
-
46
48
48
54
56
56
21
21
18
380
(Operating Temperature:-40°C~+100°C)
MAX
UNITS
28
+22
+100
+100
VDC
dBm
℃
℃
RFC042
TYP
-
23
-
1.5 : 1
1.5 : 1
48
50
50
58
60
60
23
23
20
4.0
400
MAX
800
-
±0.5
2.0:1
2.0:1
-
-
6
430
▪ Tel : 82-31-250-5011
▪ All specifications may change without notice.
▪ Version 5.6
|
| |
 
Mobile Radio Mini Amplifier RFC042
www.DataSheet4U.com
ESD PROTECTION
Gallium Arsenide Integrated Circuits are sensitive to electrostatic discharge (ESD) and can be damaged by static electricity.
Proper ESD control techniques should be used when handling these devices. Some of the precautions recommended are;
- Person at a workbench should be earthed via a wrist strap and a resistor.
- All mains-powered equipment should be connected to the mains via an earth-leakage switch.
- Equipment cases should be grounded.
- Relative humidity should be maintained between 40% and 50%.
- An ionizer is recommended.
- Keep static materials, such as plastic envelopes and plastic trays etc. away from the workbench.
NOTES FOR CORRECT USE
1.
2.
3.
4.
5.
6.
7.
Package Dimensions (Type: DP-27)
On the power input port (Pin#5), 47uF/35V capacitor GND is
recommended.
The heat sink of CATV Hybrids is to be mounted in direct contact with the
metal case of the equipment. Heat conducting grease should be applied to
the module/equipment interface and the unit tightly secured.
Put the power off before adjusting in/output matching of the system.
The unit must have a common ground with the equipment and the
analyzer.
Pay close attention to the input voltage not to over power the hybrid.
The space between bottom of socket and the tip of the lead is
recommended to have space of 2mm+ to protect the pin
Do not open the plastic cover to change the matching inside the hybrid.
Once opened, RFHIC will not be responsible for the hybrid.
Pin No. Function
1
2,3,7,8
5
9
RF Input
Ground
Vcc
RF Output
RFHIC Corporation (RFHIC) reserves the right to make changes to any products herein or to discontinue any product at any time without notice. RFHIC do not
assume any liability for the suitability of its products for any particular purpose, and disclaims any and all liability, including without limitation consequential or
incidental damages. The product specifications herein expressed have been carefully checked and are assumed to be reliable. However, RFHIC disclaims liability for
inaccuracies and strongly recommends buyers to verify that the information they are using is current before placing purchase orders. RFHIC products are not
intended for use in life support equipment or application where malfunction of the product can be expected to result in personal injury or death. Buyer uses or sells
such products for any such unintended or unauthorized application, buyer shall indemnify, protect and hold RFHIC and its directors, officers, stockholders,
employees,
whatsoever
representatives and distributors harmless against any and
kind and nature which RFHIC products could cause shall
all
be
claims
limited
arising out
in amount
of such use. RFHIC’s liability
to the net purchase price of the
under or
products
arising
sold to
out of
buyer
bdyamRaFgHeIsC, c.laims
of
▪ Tel : 82-31-250-5011
▪ All specifications may change without notice.
▪ Version 5.6
Preview 5 Page |
Part DetailsOn this page, you can learn information such as the schematic, equivalent, pinout, replacement, circuit, and manual for RFC042 electronic component. |
| Information | Total 5 Pages | |
| Link URL | [ Copy URL to Clipboard ] | |
| Download | [ RFC042.PDF Datasheet ] | |
Share Link :
Electronic Components Distributor
|
An electronic components distributor is a company that sources, stocks, and sells electronic components to manufacturers, engineers, and hobbyists. |
| SparkFun Electronics | Allied Electronics | DigiKey Electronics | Arrow Electronics |
| Mouser Electronics | Adafruit | Newark | Chip One Stop |
Featured Datasheets
| Part Number | Description | MFRS |
| RFC042 | The function is Mobile Radio Mini Amplifier. RFHIC | |
Semiconductors commonly used in industry:
1N4148 |
BAW56 |
1N5400 |
NE555 | | ||
Quick jump to:
RFC0
1N4
2N2
2SA
2SC
74H
BC
HCF
IRF
KA | ||