|
|
PDF ADA4692-2 Data sheet ( Hoja de datos )
| Número de pieza | ADA4692-2 | |
| Descripción | Operational Amplifiers | |
| Fabricantes | Analog Devices | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de ADA4692-2 (archivo pdf) en la parte inferior de esta página. Total 20 Páginas | ||
|
No Preview Available !
Low Power, 3.6 MHz, Low Noise, Rail-to-
Rail Output, Operational Amplifiers
ADA4691-2/ADA4691-4/ADA4692-2/ADA4692-4
FEATURES
Low power: 180 μA typical
Very low input bias currents: 0.5 pA typical
Low noise: 16 nV/√Hz typical
3.6 MHz bandwidth
Offset voltage: 500 μV typical
Low offset voltage drift: 4 μV/°C maximum
Low distortion: 0.003% THD + N
2.7 V to 5 V single supply or ±1.35 V to ±2.5 V dual supply
Available in very small 2 mm × 2 mm LFCSP packages
APPLICATIONS
Photodiode amplifiers
Sensor amplifiers
Portable medical and instrumentation
Portable audio: MP3s, PDAs, and smartphones
Communications
Low-side current sense
ADC drivers
Active filters
Sample-and-hold
GENERAL DESCRIPTION
The ADA4691-2/ADA4692-2 are dual and the ADA4691-4/
ADA4692-4 are the quad rail-to-rail output, single-supply
amplifiers featuring low power, wide bandwidth, and low noise.
The ADA4691-2 has two independent shutdown pins, allowing
further reduction in supply current. The ADA4691-4 is a quad
with dual shutdown pins each controlling a pair of amplifiers
and is available in the 16-lead LFCSP. The ADA4692-4 is a quad
version without shutdown.
These amplifiers are ideal for a wide variety of applications.
Audio, filters, photodiode amplifiers, and charge amplifiers, all
benefit from this combination of performance and features.
Additional applications for these amplifiers include portable
consumer audio players with low noise and low distortion that
provide high gain and slew rate response over the audio band at
low power. Industrial applications with high impedance sensors,
such as pyroelectric and IR sensors, benefit from the high
impedance and low 0.5 pA input bias, low offset drift, and
enough bandwidth and response for low gain applications.
The ADA4691/ADA4692 family is fully specified over the extended
industrial temperature range (−40°C to +125°C). The ADA4691-2
is available in a 10-lead LFCSP and a 9-ball WLCSP. The ADA4692-2
is available in an 8-lead SOIC and 8-lead LFCSP. The ADA4691-4 is
available in a 16-lead LFCSP. The ADA4692-4 is available in a 14-lead
TSSOP. For pin configurations, see the Pin Configurations section.
1
ADA4692-2
VSY = ±2.5V
AV = –1
TA = 25°C
0.1
0.01
RL = 600Ω
RL = 2kΩ
0.001
10
100 1k
FREQUENCY (Hz)
Figure 1. THD + Noise vs. Frequency
–80
–90
–100
ADA4692-2
VSY = ±2.5V
VIN = 2.8V p-p
AV = +1
TA = 25°C
10k 20k
–110
–120
–130
–140
100
1k 10k
FREQUENCY (Hz)
Figure 2. Channel Separation vs. Frequency
100k
Table 1.
Micropower
Single AD8613
Dual AD8617
Quad AD8619
Low Power
ADA4692-2
ADA4692-4
Low Power with Shutdown
ADA4691-2
ADA4691-4
Standard Op Amp With Shutdown
AD8591
AD8592
AD8594
High Bandwidth
AD8691
AD8692
AD8694
Rev. D
Information furnished by Analog Devices is believed to be accurate and reliable. However, no
responsibility is assumed by Analog Devices for its use, nor for any infringements of patents or other
rights of third parties that may result from its use. Specifications subject to change without notice. No
license is granted by implication or otherwise under any patent or patent rights of Analog Devices.
Trademarksandregisteredtrademarksarethepropertyoftheirrespectiveowners.
One Technology Way, P.O. Box 9106, Norwood, MA 02062-9106, U.S.A.
Tel: 781.329.4700
www.analog.com
Fax: 781.461.3113 ©2009–2010 Analog Devices, Inc. All rights reserved.
1 page  
ADA4691-2/ADA4691-4/ADA4692-2/ADA4692-4
Parameter
OUTPUT CHARACTERISTICS
Output Voltage High
Output Voltage Low
Short-Circuit Limit
Closed-Loop Output Impedance
Output Pin Leakage Current
POWER SUPPLY
Power Supply Rejection Ratio
Supply Current Per Amplifier
Supply Current Shutdown Mode
DYNAMIC PERFORMANCE
Slew Rate
Settling Time to 0.1%
Gain Bandwidth Product
Phase Margin
Turn-On/Turn-Off Time
NOISE PERFORMANCE
Distortion
Voltage Noise
Voltage Noise Density
Symbol Test Conditions/Comments
VOH RL = 2 kΩ
−40°C ≤ TA ≤ +125°C
RL = 600 Ω to GND
−40°C ≤ TA ≤ +125°C
VOL RL = 2 kΩ
−40°C ≤ TA ≤ +125°C
RL = 600 Ω
−40°C ≤ TA ≤ +125°C
ISC VOUT = VSY or GND
ZOUT ADA4691-2, f = 1 MHz, AV = −100
ADA4691-2, f = 1 MHz, AV = −100
−40°C < TA < +125°C, shutdown active, VSD = VSS
PSRR
ISY
ISD
VSY = 2.7 V to 5.5 V
−40°C ≤ TA ≤ +125°C
VOUT = VSY/2
−40°C ≤ TA ≤ +125°C
All amplifiers shut down, VSD = VSS
−40°C ≤ TA ≤ +125°C
SR RL = 2 kΩ, 600 Ω, CL = 20 pF, AV = +1
tS VIN = 2 V step, RL = 2 kΩ or 600 Ω
GBP RL = 1 MΩ, CL = 35 pF, AV = +1
ΦM RL = 1 MΩ, CL = 35 pF, AV = +1
RL = 600 Ω
THD + N
en p-p
en
en
AV = −1, RL = 2 kΩ, f = 1 kHz, VIN rms = 0.8 V rms
AV = −1, RL = 600 Ω, f = 1 kHz, VIN rms = 0.8 V rms
AV = +1, RL = 2 kΩ, f = 1 kHz, VIN rms = 0.8 V rms
AV = +1, RL = 600 Ω, f = 1 kHz, VIN rms = 0.8 V rms
f = 0.1 Hz to 10 Hz
f = 1 kHz
f = 10 kHz
Min Typ Max Unit
4.95 4.97
V
4.90 V
4.85 4.88
V
4.80 V
30 35 mV
50 mV
100 110 mV
155 mV
±55 mA
364 Ω
246 Ω
10 nA
80 90
dB
75 dB
180 225 μA
275 μA
10 nA
2 μA
1.3 V/μs
1.5 μs
3.6 MHz
52 Degrees
1 μs
0.006
0.008
0.001
0.003
3.2
16
13
%
%
%
%
μV p-p
nV/√Hz
nV/√Hz
Rev. D | Page 5 of 20
5 Page 
ADA4691-2/ADA4691-4/ADA4692-2/ADA4692-4
1k 1k
100
AV = –100
10
AV = –10
1
0.1
0.01
100
AV = –1
ADA4692-2
VSY = ±1.35V
TA = 25°C
1k 10k 100k 1M 10M
FREQUENCY (Hz)
Figure 27. Output Impedance vs. Frequency
120
100
80
60
40
20 ADA4692-2
VSY = ±1.35V
TA = 25°C
0
100 1k
10k 100k
FREQUENCY (Hz)
1M
Figure 28. CMRR vs. Frequency
10M
100
80
PSRR+
60
PSRR–
40
20
0
ADA4692-2
VSY = ±1.35V
TA = 25°C
–20
100 1k
10k 100k
FREQUENCY (Hz)
1M
Figure 29. PSRR vs. Frequency
10M
100
AV = –100
10
AV = –10
1
AV = –1
0.1
0.01
100
ADA4692-2
VSY = ±2.5V
TA = 25°C
1k 10k 100k 1M 10M
FREQUENCY (Hz)
Figure 30. Output Impedance vs. Frequency
120
100
80
60
40
20 ADA4692-2
VSY = ±2.5V
TA = 25°C
0
100 1k
10k 100k
FREQUENCY (Hz)
1M
Figure 31. CMRR vs. Frequency
10M
100
PSRR+
80
PSRR–
60
40
20
0
ADA4692-2
VSY = ±2.5V
TA = 25°C
–20
100 1k
10k 100k
FREQUENCY (Hz)
1M
Figure 32. PSRR vs. Frequency
10M
Rev. D | Page 11 of 20
11 Page | ||
| Páginas | Total 20 Páginas | |
| PDF Descargar | [ Datasheet ADA4692-2.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| ADA4692-2 | Operational Amplifiers | Analog Devices |
| ADA4692-4 | Operational Amplifiers | Analog Devices |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |