|
|
Número de pieza | M68ICS08MR | |
Descripción | In-Circuit Simulator | |
Fabricantes | Motorola Semiconductors | |
Logotipo | ||
Hay una vista previa y un enlace de descarga de M68ICS08MR (archivo pdf) en la parte inferior de esta página. Total 30 Páginas | ||
No Preview Available ! www.DataSheet4U.com
M68ICS08MRUM/D
M68ICS08MR
In-Circuit Simulator
User’s Manual
1 page www.DataSheet4U.com
User’s Manual — M68ICS08MR In-Circuit Simulator
List of Figures
2-1 . MR16/32 Clock Source Selection Jumper (W1) . . . . . . . . . . . . . . . 21
2-2 . Reset Source Selection Jumper (W2) . . . . . . . . . . . . . . . . . . . . . . . . 21
2-3 . MR16/32 I/O Baud Rate Selection Jumper (W3) . . . . . . . . . . . . . . . 22
2-4 . MCU Emulation Selection Jumper (W4) . . . . . . . . . . . . . . . . . . . . . 22
2-5 . MRICS XTAL Clock Enable Jumper (W5) . . . . . . . . . . . . . . . . . . . 23
2-6 . MR4/8 Clock Source Selection Jumper (W6) . . . . . . . . . . . . . . . . . 23
2-7 . Board Reset Selection Jumper (W7). . . . . . . . . . . . . . . . . . . . . . . . . 24
2-8 . J2 Pin Assignments; MR16/32 Target Interface. . . . . . . . . . . . . . . . 26
2-9 . J3 Pin Assignments; MR16/32 Target Interface. . . . . . . . . . . . . . . . 27
2-10 . J5 Pin Assignments; MR4/8 Target Interface. . . . . . . . . . . . . . . . . . 28
2-11 . J6 Pin Assignments; MR4/8 Target Interface. . . . . . . . . . . . . . . . . . 29
2-12 . J7 Pin Assignments; MR16/32 MON08 Cable Connectors. . . . . . . 30
2-13 . J8 Pin Assignments; MR4/8 MON08 Cable Connectors . . . . . . . . . 31
2-14 . J1 Pin Assignments; MR16/32 Target Connector . . . . . . . . . . . . . . 32
2-15 . J11 Pin Assignments; MR4/8 DIP Target Connector . . . . . . . . . . . . 33
2-16 . J12 Pin Assignments; RS232 Connector . . . . . . . . . . . . . . . . . . . . . 34
2-17 . J4 Pin Assignment; +5Vdc Power Connector. . . . . . . . . . . . . . . . . . 34
M68ICS08MR In-Circuit Simulator
MOTOROLA
User’s Manual
5
5 Page www.DataSheet4U.com
General Information
Introduction
Functions of the MRICS vary depending upon which software you choose:
• With the WinIDE, CASM08W, editor, simulator, and assembler
software - the function is as a limited real-time emulator.
• With the PROG08SW software - the function is to program MCU
FLASH memory. (This function is not available on the MC68HC08MR4
MCU, which does not have FLASH). Only one part may be programmed
at a time. The MRICS also supports in-circuit programming of either
version of the part through either MON08 cable.
• With the ICS08MRZ simulation software, the MCU provides the
required input/output information that lets the host computer simulate
code, performing all functions except for maintaining port values. (The
internal FLASH memory on the device is downloaded with a program
that generates the appropriate port values.) The ICS08MRZ software on
the host computer lets the host computer become a simulator.
• With using the ICD08SZ debugging software, code can be run directly
out of the MCU’s internal FLASH at real-time speeds.
• The MRICS board also provides +5 Vdc power, +8.6 Vdc power for the
VTST voltage required to enter monitor mode, either a 4.0000-MHz or
4.9152-MHz clock signal, and host PC RS-232 level translation, when it
is supplied an active DTR signal.
NOTE: The simulation speed will be slower than this rate because the host computer is
the simulator.
M68ICS08MR In-Circuit Simulator
MOTOROLA
General Information
User’s Manual
11
11 Page |
Páginas | Total 30 Páginas | |
PDF Descargar | [ Datasheet M68ICS08MR.PDF ] |
Número de pieza | Descripción | Fabricantes |
M68ICS08MR | In-Circuit Simulator | Motorola Semiconductors |
Número de pieza | Descripción | Fabricantes |
SLA6805M | High Voltage 3 phase Motor Driver IC. |
Sanken |
SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
Analog Devices |
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |