DataSheetWiki


XRT83VL38 fiches techniques PDF

Exar Corporation - Short-Haul Transceiver

Numéro de référence XRT83VL38
Description Short-Haul Transceiver
Fabricant Exar Corporation 
Logo Exar Corporation 





1 Page

No Preview Available !





XRT83VL38 fiche technique
www.DataShAePeRt4IUL .2c0o0m9
XRT83VL38
OCTAL T1/E1/J1 LH/SH TRANSCEIVER WITH CLOCK RECOVERY AND JITTER ATTENUATOR
REV. 1.0.0
GENERAL DESCRIPTION
The XRT83VL38 is a fully integrated Octal (eight
channel) long-haul and short-haul line interface unit
for T1 (1.544Mbps) 100, E1 (2.048Mbps) 75or
120 or J1 110applications.
In long-haul applications the XRT83VL38 accepts
signals that have been attenuated from 0 to 36dB at
772kHz in T1 mode (equivalent of 0 to 6000 feet of
cable loss) or 0 to 43dB at 1024kHz in E1 mode.
In T1 applications, the XRT83VL38 can generate five
transmit pulse shapes to meet the short-haul Digital
Cross-Connect (DSX-1) template requirements as
well as for Channel Service Units (CSU) Line Build
Out (LBO) filters of 0dB, -7.5dB -15dB and -22.5dB
as required by FCC rules. It also provides
programmable transmit pulse generators for each
channel that can be used for output pulse shaping
allowing performance improvement over a wide
variety of conditions (The arbitrary pulse generators
are available in both T1 and E1 modes).
The XRT83VL38 provides both a parallel/serial Host
microprocessor interface as well as a Hardware
mode for programming and control.
Both the B8ZS and HDB3 encoding and decoding
functions are selectable as well as AMI. Two on-chip
crystal-less jitter attenuators with a 32 or 64 bit FIFO
can be placed in the receive and the transmit paths
with loop bandwidths of less than 3Hz. The
XRT83VL38 provides a variety of loop-back and
diagnostic features as well as transmit driver short
circuit detection and receive loss of signal monitoring.
It supports internal impedance matching for 75
100 110 and 120for both transmitter and
receiver. In the absence of the power supply, the
transmit outputs and receive inputs are tri-stated
allowing for redundancy applications The chip
includes an integrated programmable clock multiplier
that can synthesize T1 or E1 master.
APPLICATIONS
T1 Digital Cross-Connects (DSX-1)
ISDN Primary Rate Interface
CSU/DSU E1/T1/J1 Interface
T1/E1/J1 LAN/WAN Routers
Public switching Systems and PBX Interfaces
T1/E1/J1 Multiplexer and Channel Banks
Features (See Page 2)
FIGURE 1. BLOCK DIAGRAM OF THE XRT83VL38 T1/E1/J1 LIU (HOST MODE)
MCLKE1
MCLKT1
TPOS_n/TDATA_n
TNEG_n/CODES_n
TCLK_n
RCLK_n
RNEG_n/LCV_n
RPOS_n/RDATA_n
RLOS_n
HW/HOST
WR_R/W
RD_DS
ALE_AS
CS
RDY_DTACK
INT
MASTER CLOCK SYNTHESIZER
One of Eight channels, CHANNEL_n - (n= 0:7)
QRSS
PATTERN
GENERATOR
HDB3/
B8ZS
ENCODER
TX/RX JITTER
ATTENUATOR
TAOS
ENABLE
TIMING
CONTROL
DFM
DRIVE
MONITOR
TX FILTER
& PULSE
SHAPER
LINE
DRIVER
QRSS ENABLE
QRSS
DETECTOR
NETWORK
LOOP
DETECTOR
REMOTE
LOOPBACK
DIGITAL
LOOPBACK
LOOPBACK
ENABLE
HDB3/
B8ZS
DECODER
TX/RX JITTER
ATTENUATOR
TIMING &
DATA
RECOVERY
LBO[3:0]
PEAK
DETECTOR
& SLICER
NLCD ENABLE
LOS
DETECTOR
AIS
DETECTOR
EQUALIZER
CONTROL
LOCAL
ANALOG
LOOPBACK
RX
EQUALIZER
TEST
MICROPROCESSOR CONTROLLER
MCLKOUT
DMO_n
TTIP_n
TRING_n
TXON_n
RTIP_n
RRING_n
ICT
PTS1
PTS2
D[7:0]
PCLK
A[7:0]
RESET
Exar Corporation 48720 Kato Road, Fremont CA, 94538 (510) 668-7000 FAX (510) 668-7017 www.exar.com

PagesPages 30
Télécharger [ XRT83VL38 ]


Fiche technique recommandé

No Description détaillée Fabricant
XRT83VL38 Short-Haul Transceiver Exar Corporation
Exar Corporation

US18650VTC5A

Lithium-Ion Battery

Sony
Sony
TSPC106

PCI Bus Bridge Memory Controller

ATMEL
ATMEL
TP9380

NPN SILICON RF POWER TRANSISTOR

Advanced Semiconductor
Advanced Semiconductor


www.DataSheetWiki.com    |   2020   |   Contactez-nous  |   Recherche