DataSheetWiki


LM1292N fiches techniques PDF

National Semiconductor - Video PLL System for Continuous-Sync Monitors

Numéro de référence LM1292N
Description Video PLL System for Continuous-Sync Monitors
Fabricant National Semiconductor 
Logo National Semiconductor 





1 Page

No Preview Available !





LM1292N fiche technique
April 1999
LM1292
Video PLL System for Continuous-Sync Monitors
General Description
The LM1292 is a very low jitter, integrated horizontal time
base solution specifically designed to operate in high perfor-
mance, continuous-sync video monitors. It automatically
synchronizes to any H frequency from 22 kHz to 125 kHz
and provides the drive pulse to the high power deflection cir-
cuit.
Available sync processing includes a vertical sync separator
and a composite video sync stripper. An internal sync selec-
tion scheme gives highest priority to separate H and V sync,
then composite sync, and finally sync on video; no external
switching between sync sources is necessary. The LM1292
provides polarity-normalized H/HV and V sync outputs.
The LM1292 design uses an on-chip FVC
(Frequency-to-Voltage Converter) to set the center fre-
quency of the VCO (Voltage-Controlled Oscillator). This
technique allows autosync operation over the entire fre-
quency range using just one optimized set of external com-
ponents.
The system includes a second phase detector which com-
pensates for storage time variation in the horizontal output
transistor; the picture’s horizontal position is thus indepen-
dent of temperature and component variance.
The LM1292 provides DC control pins for H Drive duty cycle
and flyback phase.
Features
n Wide continuous autosync range — 22 kHz–125 kHz
(1:5.7) with no component switching or external
adjustments
n No manufacturing trims required — internal VCO
capacitor trimmed on chip
n No costly high-precision components needed
n Very low phase jitter (below 800 ps at 125 kHz)
n DC controlled H phase and duty cycle
n Video mute pulse for blanking during H frequency
transitions
n Input sync prioritization
n Clamp pulse position and width control
n Continuous clamp pulse output, even with no sync input
n Resistor-programmable minimum and maximum VCO
frequency
n X-ray input disables H drive and mutes video until VCC
powered down
n H drive disabled for VCC < 9.5V
n Horizontal output transistor protected against accidental
turn-on during flyback
n Capacitor-programmable frequency ramping, df vco/dt,
protects H output transistor during scanning mode
changes
Connection Diagram
DS012844-1
FIGURE 1. Order Number LM1292N
See NS Package Number N28B
© 1999 National Semiconductor Corporation DS012844
www.national.com

PagesPages 10
Télécharger [ LM1292N ]


Fiche technique recommandé

No Description détaillée Fabricant
LM1292 Video PLL System for Continuous-Sync Monitors National Semiconductor
National Semiconductor
LM1292 LM1292 Video PLL System for Continuous-Sync Monitors Texas Instruments
Texas Instruments
LM1292N Video PLL System for Continuous-Sync Monitors National Semiconductor
National Semiconductor

US18650VTC5A

Lithium-Ion Battery

Sony
Sony
TSPC106

PCI Bus Bridge Memory Controller

ATMEL
ATMEL
TP9380

NPN SILICON RF POWER TRANSISTOR

Advanced Semiconductor
Advanced Semiconductor


www.DataSheetWiki.com    |   2020   |   Contactez-nous  |   Recherche