DataSheetWiki


EN29LV010 fiches techniques PDF

Eon Silicon Solution - CMOS 3.0 Volt-only Flash Memory

Numéro de référence EN29LV010
Description CMOS 3.0 Volt-only Flash Memory
Fabricant Eon Silicon Solution 
Logo Eon Silicon Solution 





1 Page

No Preview Available !





EN29LV010 fiche technique
www.DataSheet4U.com
E1dNMa20e9g.LaVbi0t1(0128K x 8-bit ) Uniform Sector,
CMOS 3.0 Volt-only Flash Memory
EN29LV010
FEATURES
Single power supply operation
- Full voltage range: 2.7-3.6 volt read and write
operations for battery-powered applications.
- Regulated voltage range: 3.0-3.6 volt read
and write operations for high performance
3.3 volt microprocessors.
High performance
- Full voltage range: access times as fast as 55
ns
- Regulated voltage range: access times as fast
as 45ns
Low power consumption (typical values at 5
MHz)
- 7 mA typical active read current
- 15 mA typical program/erase current
- 1 µA typical standby current (standard access
time to active mode)
Flexible Sector Architecture:
- Eight 16 Kbyte sectors
- Supports full chip erase
- Individual sector erase supported
- Sector protection and unprotection:
Hardware locking of sectors to prevent
program or erase operations within individual
sectors
High performance program/erase speed
- Byte program time: 8µs typical
- Sector erase time: 500ms typical
JEDEC Standard program and erase
commands
JEDEC standard DATA polling and toggle bits
feature
Single Sector and Chip Erase
Embedded Erase and Program Algorithms
Erase Suspend / Resume modes:
Read or program another Sector during
Erase Suspend Mode
triple-metal double-poly triple-well CMOS Flash
Technology
Low Vcc write inhibit < 2.5V
>100K program/erase endurance cycle
Package options
- 8mm x 20mm 32-pin TSOP (Type 1)
- 8mm x 14mm 32-pin TSOP (Type 1)
- 32-pin PLCC
-
Commercial and industrial Temperature Range
GENERAL DESCRIPTION
The EN29LV010 is a 1-Megabit, electrically erasable, read/write non-volatile flash memory,
organized as 131,072 bytes. Any byte can be programmed typically in 8µs. The EN29LV010
features 3.0V voltage read and write operation, with access times as fast as 45ns to eliminate the
need for WAIT states in high-performance microprocessor systems.
The EN29LV010 has separate Output Enable ( OE ), Chip Enable ( CE ), and Write Enable (WE)
controls, which eliminate bus contention issues. This device is designed to allow either single
Sector or full chip erase operation, where each Sector can be individually protected against
program/erase operations or temporarily unprotected to erase or program. The device can sustain a
minimum of 100K program/erase cycles on each Sector.
This Data Sheet may be revised by subsequent versions 1
or modifications due to changes in technical specifications.
©2003 Eon Silicon Solution, Inc., www.essi.com.tw
Rev. B, Issue Date: 2004/01/05

PagesPages 30
Télécharger [ EN29LV010 ]


Fiche technique recommandé

No Description détaillée Fabricant
EN29LV010 CMOS 3.0 Volt-only Flash Memory Eon Silicon Solution
Eon Silicon Solution

US18650VTC5A

Lithium-Ion Battery

Sony
Sony
TSPC106

PCI Bus Bridge Memory Controller

ATMEL
ATMEL
TP9380

NPN SILICON RF POWER TRANSISTOR

Advanced Semiconductor
Advanced Semiconductor


www.DataSheetWiki.com    |   2020   |   Contactez-nous  |   Recherche