DataSheetWiki


OPL583 fiches techniques PDF

OPTEK Technologies - Dual Channel Photologic Encoder Detector

Numéro de référence OPL583
Description Dual Channel Photologic Encoder Detector
Fabricant OPTEK Technologies 
Logo OPTEK Technologies 





1 Page

No Preview Available !





OPL583 fiche technique
Product Bulletin OPL583
August 1996
Dual Channel Photologic® Encoder Detector
Type OPL583
www.DataSheet4U.com
Features
Two matched detectors with photo-
lithographic control of relative position
Dual Photologic® circuitry in single
package provides reduced component
count
Open collector inverter output for flexi-
bility of circuit interface
Low cost plastic housing
Description
The OPL583 contains a monolithic
integrated circuit which incorporates two
independent photodiodes, linear
amplifiers, Schmitt trigger circuits, and
output transistors served by a common
voltage regulator. The outputs are
TTL/LSTTL compatible and can drive 8
TTL loads over a voltage range from 4.5
to 16 V. Applications include linear and
rotary encoders with resolutions
determined by external apertures. The
fixed relative position of the two
photodiodes and the matched
characteristics of the two channels allow
considerable design flexibility.
Absolute Maximum Ratings (TA = 25o C unless otherwise noted)
Supply Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 18 V(5)
Storage Temperature . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -40o C to +100o C
Operate Temperature. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -40o C to +85o C
Lead Solder Temperature [1/16 inch (1.6 mm) from case for 5 sec. with soldering iron]
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 260o C(2)
Power Dissipation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 200 mW(1)
Duration of Output Short to VCC . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1.00 sec.
Voltage At Output . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 18 V
Low Level Output Current (sinking) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 40 mA
Notes:
(1) Derate
linearly
2.67
mW/o
C
above
25o
C.
(2) RMA flux is recommended. Duration can be extended to 10 sec. max when flow soldering.
Max 20 grams force may be applied to leads when flow soldering.
(3) A 0.01 µF capacitor should be used across the VCC and GND leads to stabilize the power
supply line.
(4) Irradiance measurements are made with λ= 940 nm.
(5) Derate linearly 0.37 V/o C above 58o C.
Schematic
VREG
AMP
4 VCC
3 OUT B
AMP
2 OUT A
1 GND
Optek Technology, Inc.
1215 W. Crosby Road
Carrollton, Texas 75006
4-16
(972) 323-2200
Fax (972) 323-2396

PagesPages 3
Télécharger [ OPL583 ]


Fiche technique recommandé

No Description détaillée Fabricant
OPL583 Dual Channel Photologic Encoder Detector OPTEK Technologies
OPTEK Technologies

US18650VTC5A

Lithium-Ion Battery

Sony
Sony
TSPC106

PCI Bus Bridge Memory Controller

ATMEL
ATMEL
TP9380

NPN SILICON RF POWER TRANSISTOR

Advanced Semiconductor
Advanced Semiconductor


www.DataSheetWiki.com    |   2020   |   Contactez-nous  |   Recherche