DataSheetWiki


VUS11 fiches techniques PDF

ETC - Pressure Sensor

Numéro de référence VUS11
Description Pressure Sensor
Fabricant ETC 
Logo ETC 





1 Page

No Preview Available !





VUS11 fiche technique
Sensor Heads, Separate display type Pressure sensor and Vacuum switch
Small-sized 24.5-mm pressure sensors (width: 10mm
height, 10mm total length).
"Union," "Nipple," and "Male screw" are prepared.
Use of an analog output type and indicator (SED30-series)
has made a separate display system possible.
Our small-sized pressure sensors can handle "positive
pressure," "negative pressure" and "Compound pressure".
Concerning output, a total of six different specifications
are prepared.
Standard cable length is 3m.
www.DataSheet4U.com
A large 31.4mm square size indicator is used, realizing a
high level of visibility with its large-sized LED display.
All settings can be made using just three push buttons.
For indication units, you can choose from among 11
different types.
Two different kinds of output methods are offered - analog
output and switch output.
Four (4) different kinds of installation stays are available
depending on installation form. - for installation in the rear,
on a flat surface, panel-buried, and for protection of
display components.
Specification SEU 11 series VUS 11 series VUS 11-R series
Fluid admitted
Air, inert gas
Pressure detection Proliferated semiconductor pressure switch
Power requirements
DC10.8 ~ 30V (ripples included)
Power consumption
20mA or less (DC24V at no-load)
Service pressure range 0 ~ 150psi (0 ~ 1MPa) 0 ~ -30in. Hg (-100 ~ 0kPa) 89 ~ -30in. Hg (-100 ~ 300kPa)
Proof pressure 218psi (1.5MPa) 29psi (200kPa) 87psi (600kPa)
Storage temperature range -4 ~ 158°F (-20 ~ 70°C) (Atomospheric pressure, hummidity less than 60%RH)
Operating temperature range 32 ~ 140°F (0 ~ 60°C) (No freezing)
Operating hummidity range
35 ~ 85%RH (No freezing)
Protective structure
IEC standard IP40 equiv.
No. of pressure set ing
1
Switch output NPN Open collector output: 30V 80mA max. Residual voltage 0.8V max.
Display of action N.O. (red LED lights up when set pressure exceeded)
Switch output Diferentialresponse
Fixed (2%F.S. max.)
Operating accuracy ±3%F.S. max. (at Ta=25°C/77°F)
Response
Approx. 1msec
Pressuresetingrange 0 ~ 150psi (0 ~ 1MPa) 0 ~ -30in. Hg (-100 ~ 0kPa) 89 ~ -30in. Hg (-100 ~ 300kPa)
Specification SEU 11 series VUS 11 series VUS 11-R series
Fluid admitted
Air, inert gas
Pressure detection Proliferated semiconductor pressure switch
Power requirements
DC10.8 ~ 30V (ripples included)
Power consumption
20mA or less (DC24V at no-load)
Service pressure range 0 ~ 150psi (0 ~ 1MPa) 0 ~ -30in. Hg (-100 ~ 0kPa) 89 ~ -30in. Hg (-100 ~ 300kPa)
Proof pressure 218psi (1.5MPa) 29psi (200kPa) 87psi (600kPa)
Storage temperature range -4 ~ 158°F (-20 ~ 70°C) (Atomospheric pressure, hummidity less than 60%RH)
Operating temperature range 32 ~ 140°F (0 ~ 60°C) (No freezing)
Operating hummidity range
35 ~ 85%RH (No freezing)
Protective structure
IEC standard IP40 equiv.
Output voltage
1 ~ 5V
Zero-point voltage
1 ±0.1V
Analog output Max.ratedpressurevoltage
5 ±0.1V
Output current 1mA max. (Load Resistance 5kmin.)
Linearity
±0.5%F.S. max.
80

PagesPages 3
Télécharger [ VUS11 ]


Fiche technique recommandé

No Description détaillée Fabricant
VUS11 Pressure Sensor ETC
ETC

US18650VTC5A

Lithium-Ion Battery

Sony
Sony
TSPC106

PCI Bus Bridge Memory Controller

ATMEL
ATMEL
TP9380

NPN SILICON RF POWER TRANSISTOR

Advanced Semiconductor
Advanced Semiconductor


www.DataSheetWiki.com    |   2020   |   Contactez-nous  |   Recherche