DataSheetWiki


LM317 fiches techniques PDF

Estek Electronics - 3-terminal positive voltage regulators

Numéro de référence LM317
Description 3-terminal positive voltage regulators
Fabricant Estek Electronics 
Logo Estek Electronics 





1 Page

No Preview Available !





LM317 fiche technique
Description
The 3 1 7 are adjustable 3 - terminal positive -voltage regulators capable of supplying 1.5A over a differential voltage range of 3Vto
40V. They are exceptionally easy to use and require only two external resistors to set the output voltage.
Both input and output regulation are better than standard fixed regulators.In addition to higher performance than fixed regulators,
these regulators offer full overload protection available only in integrated circuits. Included on the chip are current limit,
thermal overload protection, and safe-area protection. All overload protection circuitry remains fully functional even if
the adjustment terminal is disconnected. Normally, no capacitors are needed unless the device is situated far from
the input filter capacitors in which case an input bypass is needed. An optional output capacitor can be added to improve transient
response.The primary applications of each of these regulators is that of a programmable output regulator, but by
connecting a fixed resistor between adjustment terminal and the output terminal, each device can be used as a
precision current regulator. Even though the regulator is floating and sees only the input-to-output differential voltage,
www.DautasSeheoef t4thUe.cseomdevices to regulate output voltages that would cause the maximum-rated differential voltage to be exceeded if
the output became shorted to ground is not recommended.
Features
•Output Voltage Range Adjustable from 1.2 V to 37 V
• Output Current Capability of 1.5 A Max
• Input Regulation Typically 0.01 % Per Input - Volt Change
• Output Regulation Typically 0.1 %
• Peak Output Current Constant Over Temperature
Range of Regulator
• Popular 3-Lead TO-220 Package
• Ripple Rejection Typically 80 dB
Typical application data
V
I
3 IN
317
ADJ
OUT
2
R1
1 240
V
0
(see Note C)
C1 = 0.1 Fµ
(see Note A)
C2 = 1
(see Note B)
R2
Note A: Use of an input bypass capacitor is recommended if regulator is far from filter capacitors.
Note B: Use of an output capacitor improves transient response but is optional.
Note C: Output voltage is calculated from the equation:
0 = Vref V
R
+1R1
Vref equals the difference between the output and adjustment terminal
BEIJING ESTEK ELECTRONICS CO.,LTD
1

PagesPages 3
Télécharger [ LM317 ]


Fiche technique recommandé

No Description détaillée Fabricant
LM310 Voltage Follower National Semiconductor
National Semiconductor
LM3100 LM3100 SIMPLE SWITCHER Synchronous 1MHz 1.5A Step-Down Voltage Regulator (Rev. G) Texas Instruments
Texas Instruments
LM3100 Voltage Regulator National Semiconductor
National Semiconductor
LM3102 LM3102/-Q1 SIMPLE SWITCHER Synchronous 1-MHz 2.5-A Step-Down Voltage Regulator (Rev. H) Texas Instruments
Texas Instruments

US18650VTC5A

Lithium-Ion Battery

Sony
Sony
TSPC106

PCI Bus Bridge Memory Controller

ATMEL
ATMEL
TP9380

NPN SILICON RF POWER TRANSISTOR

Advanced Semiconductor
Advanced Semiconductor


www.DataSheetWiki.com    |   2020   |   Contactez-nous  |   Recherche