DataSheetWiki


IR5001 fiches techniques PDF

International Rectifier - UNIVERSAL ACTIVE ORING CONTROLLER

Numéro de référence IR5001
Description UNIVERSAL ACTIVE ORING CONTROLLER
Fabricant International Rectifier 
Logo International Rectifier 





1 Page

No Preview Available !





IR5001 fiche technique
Data Sheet No.PD60229
IR5001
UNIVERSAL ACTIVE ORING CONTROLLER
DESCRIPTION
The IR5001 is a universal high-speed controller and
N-channel power MOSFET driver for Active ORing and
reverse polarity protection applications. The output voltage
of the IR5001 is determined based on the polarity of the
voltage difference on its input terminals. In particular, if the
current flow through an N-channel ORing FET is from
source to drain, the output of the IR5001 will be pulled
high to Vcc, thus turning the Active ORing FET on. If the
current reverses direction and flows from drain to source
(due to a short-circuit failure of the source, for example),
the IC will quickly switch the Active ORing FET off. Typical
turn-off delay for the IR5001 is only 130nS, which helps to
minimize voltage sags on the redundant dc voltage.
Both inputs to the IC (INN and INP) as well as Vline
input contain integrated high voltage resistors and internal
clamps. This makes the IR5001 suitable for applications at
voltages up to 100V, and with a minimum number of
external components.
FEATURES
  Controller / driver IC in an SO-8 package for
implementation of Active ORing / reverse polarity
protection using N-channel Power MOSFETs
  Suitable for both input ORing (for carrier class
telecom equipment) as well as output ORing for
redundant DC-DC and AC-DC power supplies
  130ns Typical Turn-Off delay time
  3A Peak Turn-Off gate drive current
  Asymmetrical offset voltage of the internal high-speed
comparator prevents potential oscillations at light load
  Ability to withstand continuous gate short conditions
  Integrated voltage clamps on both comparator inputs
allow continuous application of up to 100V
  Option to be powered either directly from 36-75V
universal telecom bus (100V max), or from an
external bias supply and bias resistor
  Input/Output pins to determine the state of the Active
ORing circuit and power system redundancy
APPLICATIONS
  -48V/-24V Input Active ORing for carrier class communication equipment
  Reverse input polarity protection for DC-DC power supplies
  24V/48V output active ORing for redundant AC-DC rectifiers
  Low output voltage (12V, 5V, 3.3V...) active ORing for redundant DC-DC and AC-DC power supplies
  Active ORing of multiple voltage regulators for redundant processor power
TYPICAL APPLICATION
+48V input A
B
FET Check Pulse
FET A Status
IR5001
Vline Vout
Vcc Gnd
FETch INN
FETst INP
-48V input A
Fet B Status
IR5001
Vline Vout
Vcc Gnd
FETch INN
FETst INP
DC
DC
-48V input B
Figure 1 - Typical application of the IR5001 in - 48V input,
carrier class telecommunications equipment.
www.irf.com
PACKAGE / ORDERING
INFORMATION
Top View
Vline 1
Vcc 2
FETch 3
FETst 4
8 Vout
7 Gnd
6 INN
5 INP
θJA=128°C/W
Ordering P/N Package
IR5001S 8 - Pin SOIC
1

PagesPages 13
Télécharger [ IR5001 ]


Fiche technique recommandé

No Description détaillée Fabricant
IR5001 UNIVERSAL ACTIVE ORING CONTROLLER International Rectifier
International Rectifier

US18650VTC5A

Lithium-Ion Battery

Sony
Sony
TSPC106

PCI Bus Bridge Memory Controller

ATMEL
ATMEL
TP9380

NPN SILICON RF POWER TRANSISTOR

Advanced Semiconductor
Advanced Semiconductor


www.DataSheetWiki.com    |   2020   |   Contactez-nous  |   Recherche