DataSheetWiki


AAT3670 fiches techniques PDF

ANALOGICTECH - Dynamic Battery Charger and Power Manager

Numéro de référence AAT3670
Description Dynamic Battery Charger and Power Manager
Fabricant ANALOGICTECH 
Logo ANALOGICTECH 





1 Page

No Preview Available !





AAT3670 fiche technique
www.DataSheet4U.com
AAT3670
1.6A Dynamic Battery Charger
and Power Manager
General Description
The AAT3670 BatteryManager is a highly integrated
single-cell lithium-ion/polymer (Li-ion) battery charger
and system power management IC that enables simul-
taneous battery charging and full system usage without
compromising the battery's charge cycle life. It operates
with low-voltage AC adapter (ADP) and USB inputs and
requires a minimum number of external components.
The AAT3670 selects ADP or USB to power the system
load and charge the battery when ADP/USB power is
available. The AAT3670 precisely regulates battery
charge voltage and current for 4.2V Li-ion cells. Charge
current can be programmed up to 1.6A for ADP charging
and 0.9A or 0.1A for USB charging by resistors on the
ADPSET/ USBSET pins. The charge termination current
threshold is set by an external resistor on the TERM pin.
The AAT3670 has a voltage-sensed charge current
reduction loop that enables system operation without a
power shortage. When the input voltage falls below the
programmable charge reduction threshold, the device
automatically reduces the charge current until the input
voltage returns to the threshold voltage.
Battery temperature and charge state are fully monitored
for fault conditions. In the event of a battery over-volt-
age/short-circuit/over-temperature condition, the charg-
er will automatically shut down, protecting the charging
device, control system, and battery. Two status monitor
output pins (STAT1 and STAT2) are provided to indicate
battery charge status by directly driving external LEDs.
The AAT3670 is available in a Pb-free, thermally-
enhanced, space-saving 24-pin 4x4mm QFN package.
BatteryManager
Features
• ADP, USB, or Battery Powers System Load
Through Internal Current-Limited Switches
• Simultaneous Battery Charging and System
Usage
• Voltage Sensed Charge Reduction Loop
to Minimize Charge Time, Even While the
System Operates
• Digitized Thermal Loop
• Battery Power Enable (ENBAT)
• Battery Charge Timer (CT)
• Battery Temperature Monitoring (TS)
• Battery Charge Status Report (/STATx)
• Automatic Recharge Sequencing
• Battery Under-Voltage, Over-Voltage, and
Over-Current Protection
• System Load Current Limiting
• Thermal Protection
• 24-pin 4x4mm QFN Package
Applications
• Cellular Telephones
• Digital Still Cameras
• Personal Data Assistants (PDAs)
• Hand Held PCs
• MP3 Players and PMP
• Other Li-ion Battery Powered Devices
Typical Application
Adapter Input
USB Input
Enable
Enable Battery to OUT
USB Hi/Lo Select
CADP
10µF
CUSB
10µF
RADPSET RUSBSET
RADPLIM
RUSBLIM
STAT1
OUT
STAT2
ADP
BATS
BAT
AAT3670
USB
VTS
EN TS
ENBAT
USBSEL
CHRADP
ADPSET
CHRUSB
USBSET
CT
ADPLIM
USBLIM
TERM
GND
System Load
CBAT
10µF
RT
Single Cell
Li-Ion/Poly
T Battery
RTERM
CT
3670.2007.02.1.1
1

PagesPages 30
Télécharger [ AAT3670 ]


Fiche technique recommandé

No Description détaillée Fabricant
AAT3670 Dynamic Battery Charger and Power Manager ANALOGICTECH
ANALOGICTECH
AAT3672 1.6A Dynamic Battery Charger and Power Manager Skyworks
Skyworks
AAT3673 1.6A Dynamic Battery Charger and Power Manager Skyworks
Skyworks

US18650VTC5A

Lithium-Ion Battery

Sony
Sony
TSPC106

PCI Bus Bridge Memory Controller

ATMEL
ATMEL
TP9380

NPN SILICON RF POWER TRANSISTOR

Advanced Semiconductor
Advanced Semiconductor


www.DataSheetWiki.com    |   2020   |   Contactez-nous  |   Recherche