DataSheetWiki


IRDCIP2002-C fiches techniques PDF

International Rectifier - 4-phase Synchronous Buck Converter using iP2002

Numéro de référence IRDCIP2002-C
Description 4-phase Synchronous Buck Converter using iP2002
Fabricant International Rectifier 
Logo International Rectifier 





1 Page

No Preview Available !





IRDCIP2002-C fiche technique
R DEFERENCE ESIGN IRDCiP2002-C
International Rectifier 233 Kansas Street, El Segundo, CA 90245 USA
IRDCiP2002-C: 1MHz, 120A, 4-phase Synchronous Buck
Overview
Converter using iP2002
This reference design is capable of delivering up to 120A at an
ambient temperature of 45°C if the enclosed heatsink is attached
and 250LFM of airflow is provided. Performance graphs and
waveforms are provided in figures 1 - 9. The figures and table in
pages 4 - 7 are provided as a reference design to enable engineers
to very quickly and easily design a 4-phase converter. Refer to the
data sheet for the controller listed in the bill of materials in order to
optimize this design to your specific requirements. A variety of other
controllers may also be used, but the design will require layout and
control circuit modifications.
Demoboard Quick Start Guide
www.DataSheet4U.com
Initial Settings:
The output is set to 1.3V, but can be adjusted from 0.8V to 3.3V by changing the values of R3 and R32 according to
the following formula:
R3 = R32 = (24.91k * 0.8) / (VOUT - 0.8)
The switching frequency per phase is set to 1MHz with the frequency set resistor R4. This creates an effective output
frequency of 4MHz. The graph in figure 11 shows the relationship between R4 and the switching frequency per phase.
The frequency may be adjusted by changing R4 as indicated; however, extreme changes from the 1MHz set point may
require redesigning the control loop and adjusting the values of input and output capacitors. Refer to the SOA graph in
the iP2002 datasheet for maximum operating current at different conditions.
Procedure for Connecting and Powering Up Demoboard:
1. Apply input voltage (+12V) across VIN and PGND
2. Apply load across VOUT pads and PGND pads
3. Adjust load to desired level. See recommendations below.
iP2002 Recommended Operating Conditions
(refer to the iP2002 datasheet for maximum operating conditions)
Input voltage:
Output voltage:
Switching Freq:
Output current:
6.5 - 12V
0.8 - 3.3V
1MHz per phase, 4MHz effective output frequency.
The reference design is capable of delivering up to 120A at an ambient temperature of 45°C if the
enclosed heatsink is attached and 250LFM of airflow is provided. With a heatsink and no airflow, the
reference board is capable of delivering 110A at 25°C ambient. With 250LFM and no heatsink, the
reference board is capable of delivering 100A at 25°C ambient.
07/22/03

PagesPages 7
Télécharger [ IRDCIP2002-C ]


Fiche technique recommandé

No Description détaillée Fabricant
IRDCIP2002-C 4-phase Synchronous Buck Converter using iP2002 International Rectifier
International Rectifier

US18650VTC5A

Lithium-Ion Battery

Sony
Sony
TSPC106

PCI Bus Bridge Memory Controller

ATMEL
ATMEL
TP9380

NPN SILICON RF POWER TRANSISTOR

Advanced Semiconductor
Advanced Semiconductor


www.DataSheetWiki.com    |   2020   |   Contactez-nous  |   Recherche