DataSheetWiki


RMPA1963 fiches techniques PDF

Fairchild Semiconductor - CDMA2000-1X and WCDMA Power Amplifier Module

Numéro de référence RMPA1963
Description CDMA2000-1X and WCDMA Power Amplifier Module
Fabricant Fairchild Semiconductor 
Logo Fairchild Semiconductor 





1 Page

No Preview Available !





RMPA1963 fiche technique
www.DataSheet4U.com
PRELIMINARY
May 2005
RMPA1963 i-Lo™
US-PCS CDMA, CDMA2000-1X and WCDMA
Power Amplifier Module
Features
38% CDMA/WCDMA efficiency at +28 dBm Pout
14% CDMA/WCDMA efficiency (85 mA total current) at
+16 dBm Pout
Meets HSDPA performance requirements
Linear operation in low-power mode up to +19 dBm
Low quiescent current (Iccq): 25 mA in low-power mode
Single positive-supply operation with low power and shut-
down modes
• 3.4V typical Vcc operation
• Low Vref (2.85V) compatible with advanced handset
chipsets
Compact Lead-free compliant LCC package –
(4.0 X 4.0 x 1.5 mm nominal)
Industry standard pinout
Internally matched to 50 Ohms and DC blocked RF
input/output
Meets IS-95/CDMA2000-1XRTT/WCDMA performance
requirements
General Description
The RMPA1963 Power Amplifier Module (PAM) is Fairchild’s lat-
est innovation in 50 Ohm matched, surface mount modules tar-
geting US-PCS CDMA/WCDMA/HSDPA and Wireless Local
Loop (WLL) applications. Answering the call for ultra-low DC
power consumption and extended battery life in portable elec-
tronics, the RMPA1963 uses novel proprietary circuitry to dra-
matically reduce amplifier current at low to medium RF output
power levels (< +16 dBm), where the handset most often oper-
ates. A simple two-state Vmode control is all that is needed to
reduce operating current by more than 50% at 16 dBm output
power, and quiescent current (Iccq) by as much as 70% com-
pared to traditional power-saving methods. No additional cir-
cuitry, such as DC-to-DC converters, are required to achieve
this remarkable improvement in amplifier efficiency. Further, the
4x4x1.5 mm LCC package is pin-compatible and a drop-in
replacement for last generation 4x4 mm PAMs widely used
today, minimizing the design time to apply this performance-
enhancing technology. The multi-stage GaAs Microwave Mono-
lithic Integrated Circuit (MMIC) is manufactured using Fairchild
RF’s InGaP Heterojunction Bipolar Transistor (HBT) process.
Device
i-L
o
Functional Block Diagram
(Top View)
Vcc1 1
RF IN 2
GND 3
Vmode 4
Vref 5
MMIC
INPUT
MATCH
BIAS/MODE SWITCH
10 Vcc2
OUTPUT
MATCH
9 GND
8 RF OUT
7 GND
6 GND
11 (paddle ground on package bottom)
©2005 Fairchild Semiconductor Corporation
RMPA1963 i-Lo™ Rev. H
1
www.fairchildsemi.com

PagesPages 7
Télécharger [ RMPA1963 ]


Fiche technique recommandé

No Description détaillée Fabricant
RMPA1963 CDMA2000-1X and WCDMA Power Amplifier Module Fairchild Semiconductor
Fairchild Semiconductor
RMPA1965 CDMA2000-1X and WCDMA PowerEdge Power Amplifier Module Fairchild Semiconductor
Fairchild Semiconductor
RMPA1966 RMPA1966 I-Lo TM WCDMA Band II Power Amplifier Module Fairchild Semiconductor
Fairchild Semiconductor
RMPA1967 CDMA2000-1X and WDCMA Power Edge Power Amplifier Module Fairchild Semiconductor
Fairchild Semiconductor

US18650VTC5A

Lithium-Ion Battery

Sony
Sony
TSPC106

PCI Bus Bridge Memory Controller

ATMEL
ATMEL
TP9380

NPN SILICON RF POWER TRANSISTOR

Advanced Semiconductor
Advanced Semiconductor


www.DataSheetWiki.com    |   2020   |   Contactez-nous  |   Recherche