DataSheet.es    


PDF 80C198 Data sheet ( Hoja de datos )

Número de pieza 80C198
Descripción COMMERCIAL/EXPRESS CHMOS MICROCONTROLLER
Fabricantes Intel Corporation 
Logotipo Intel Corporation Logotipo



Hay una vista previa y un enlace de descarga de 80C198 (archivo pdf) en la parte inferior de esta página.


Total 19 Páginas

No Preview Available ! 80C198 Hoja de datos, Descripción, Manual

www.DataSheet4U.com
8XC198
COMMERCIAL EXPRESS CHMOS MICROCONTROLLER
8 Kbytes of OTPROM
Y 8 Kbytes of On-Chip OTPROM or ROM
Y 232 Byte Register File
Y Register-to-Register Architecture
Y 28 Interrupt Sources 16 Vectors
Y 1 75 ms 16 x 16 Multiply (16 MHz)
Y 3 0 ms 32 16 Divide (16 MHz)
Y Powerdown and Idle Modes
Y 16-Bit Watchdog Timer
Y 8-Bit External Bus
Y 16 MHz Standard
Y Full Duplex Serial Port
Y High Speed I O Subsystem
Y 16-Bit Timer
Y 16-Bit Counter
Y Pulse-Width-Modulated Output
Y Four 16-Bit Software Timers
Y 10-Bit A D Converter with Sample Hold
Y Extended Temperature Available
The 8XC198 family offers low-cost entry into Intel’s powerful MCS -96 16-bit microcontroller architecture
Intel’s CHMOS process provides a high performance processor along with low power consumption To further
reduce power requirements the processor can be placed into Idle or Powerdown Mode
The 8XC198 is the 8-bit bus version of the 8XC196KB The prefixes mean 80 (ROMless) 83 (ROM) 87 (OTP)
One Time Programmable The ROM and OTP are available in 8 Kbytes
Bit byte word and some 32-bit operations are available on the 8XC198 With a 16 MHz oscillator a 16-bit
addition takes 0 50 ms and the instruction times average 0 37 ms to 1 1 ms in typical applications
Four high-speed capture inputs are provided to record times when events occur Six high-speed outputs are
available for pulse or waveform generation The high-speed output can also generate four software timers or
start an A D conversion Events can be based on the timer or counter Also provided on-chip are an A D
converter serial port watchdog timer and a pulse-width-modulated output signal
With the commercial (standard) temperature option operational characteristics are guaranteed over the tem-
perature range of 0 C to a70 C Wth the extended temperature range option operational characteristics are
guaranteed over the temperature range of b40 C to a85 C
MCS -96 is a registered trademark of Intel Corporation
Other brands and names are the property of their respective owners
Information in this document is provided in connection with Intel products Intel assumes no liability whatsoever including infringement of any patent or
copyright for sale and use of Intel products except as provided in Intel’s Terms and Conditions of Sale for such products Intel retains the right to make
changes to these specifications at any time without notice Microcomputer Products may have minor variations to this specification known as errata
COPYRIGHT INTEL CORPORATION 1995
October 1992
Order Number 272034-003

1 page




80C198 pdf
8XC198
PIN DESCRIPTIONS
Symbol
Name and Function
VCC Main supply voltage (5V)
VSS The PLCC package has 5 VSS pins and the QFP package has 12 VSS pins All must be
connected to digital ground
VREF
Reference voltage for the A D converter (5V) VREF is also the supply voltage to the
analog portion of the A D converter and the logic used to read Port 0 Must be
connected for A D and Port 0 to function
ANGND
VPP
XTAL1
Reference ground for the A D converter Must be held at nominally the same potential
as VSS
Programming Voltage Also timing pin for the return from powerdown circuit
Input of the oscillator inverter and of the internal clock generator
XTAL2
Output of the oscillator inverter
RESET
Reset input to and open-drain output from the chip Input low for at least 4 state times to
reset the chip The subsequent low-to-high transition commences the 10-state Reset
Sequence
INST
Output high during an external memory read indicates the read is an instruction fetch
INST is valid throughout the bus cycle INST is activated only during external memory
accesses and output low for a data fetch
EA Input for memory select (External Access) EA equal to a TTL-high causes memory
accesses to locations 2000H through 3FFFH to be directed to on-chip ROM EPROM
EA equal to a TTL-low causes accesses to these locations to be directed to off-chip
memory
ALE ADV
Address Latch Enable or Address Valid output as selected by CCR Both pin options
provide a latch to demultiplex the address from the address data bus When the pin is
ADV it goes inactive high at the end of the bus cycle ALE ADV is activated only during
external memory accesses
RD Read signal output to external memory RD is activated only during external memory
reads
WR Write output to external memory WR will go low for every external write
READY
Ready input to lengthen external memory cycles When the external memory is not
being used READY has no effect Internal control of the number of wait states inserted
into a bus cycle held not ready is available through configuration of CCR
HSI Inputs to High Speed Input Unit Four HSI pins are available HSI 0 HSI 1 HSI 2 and
HSI 3 Two of them (HSI 2 and HSI 3) are shared with the HSO Unit
HSO
Outputs from High Speed Output Unit Six HSO pins are available HSO 0 HSO 1
HSO 2 HSO 3 HSO 4 and HSO 5 Two of them (HSO 4 and HSO 5) are shared with the
HSI Unit
Port 0
4-bit high impedance input-only port These pins can be used as digital inputs and or as
analog inputs to the on-chip A D converter These pins set the Programming Mode on
the EPROM device
5

5 Page





80C198 arduino
System Bus Timings
8XC198
272034 – 23
11

11 Page







PáginasTotal 19 Páginas
PDF Descargar[ Datasheet 80C198.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
80C196EACHMOS 16-BIT MICROCONTROLLERIntel Corporation
Intel Corporation
80C196JQ(80C196KR/KQ/JR/JQ) COMMERCIAL/EXPRESS CHMOS MICROCONTROLLERIntel Corporation
Intel Corporation
80C196JR(80C196KR/KQ/JR/JQ) COMMERCIAL/EXPRESS CHMOS MICROCONTROLLERIntel Corporation
Intel Corporation
80C196KBCOMMERCIAL/EXPRESS CHMOS MICROCONTROLLERIntel Corporation
Intel Corporation

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar