DataSheetWiki


AH116 fiches techniques PDF

WJ Communication - High Linearity InGaP HBT Amplifier

Numéro de référence AH116
Description High Linearity InGaP HBT Amplifier
Fabricant WJ Communication 
Logo WJ Communication 





1 Page

No Preview Available !





AH116 fiche technique
www.DataSheet4U.com
AH116
½ Watt, High Linearity InGaP HBT Amplifier
The Communications Edge TM
Product Information
Product Features
x 800 – 1000 MHz
x +28 dBm P1dB
x +43 dBm Output IP3
x 17.5 dB Gain @ 900 MHz
x +5V Single Positive Supply
x MTTF > 100 Years
x Lead-free/green/RoHS-compliant
SOIC-8 SMT Pkg.
Applications
x Final stage amplifiers for Repeaters
x Mobile Infrastructure
Product Description
Functional Diagram
The AH116 is a high dynamic range driver amplifier in a
low-cost surface mount package. The InGaP/GaAs HBT
is able to achieve high performance for various narrow-
band tuned application circuits with up to +43 dBm OIP3
and +28 dBm of compressed 1-dB power and is housed
in a lead-free/green/RoHS-compliant SOIC-8 package. All
devices are 100% RF and DC tested.
The product is targeted for use as driver amplifiers for
wireless infrastructure where high linearity and medium
power is required. The internal active bias allows the
AH116 to maintain high linearity over temperature and
operate directly off a +5 V supply. This combination
makes the device an excellent fit for transceiver line
cards and power amplifiers in current and next generation
multi-carrier 3G base stations.
18
27
36
45
Function
Vref
Input
Output
Vbias
GND
N/C or GND
Pin No.
1
3
6, 7
8
Backside Paddle
2, 4, 5
Specifications (1)
Parameters
Frequency Range
Gain
Input R.L.
Output R.L.
Output P1dB
Output IP3 (2)
IS-95A Channel Power
@ -45 dBc ACPR
Noise Figure
Operating Current Range (3)
Device Voltage
Units
MHz
dB
dB
dB
dBm
dBm
dBm
dB
mA
V
Min
15
+27
+42
200
Typ
900
17.5
18
7
+28.7
+43
+23
7
250
+5
Max
300
1. Test conditions unless otherwise noted: 25 ºC, +5V Vsupply, 900 MHz, in tuned application circuit.
2. 3OIP measured with two tones at an output power of +13 dBm/tone separated by 1 MHz. The
suppression on the largest IM3 product is used to calculate the 3OIP using a 2:1 rule.
3. This corresponds to the quiescent current or operating current under small-signal conditions. It is
expected that the current can increase up to 300mA at P1dB.
Typical Performance (1)
Parameters
Frequency
Gain
S11
S22
Output P1dB
Output IP3 (2)
IS-95A Channel Power
@ -45 dBc ACPR
Noise Figure
Supply Bias
Units
MHz
dB
dB
dB
dBm
dBm
dBm
dB
Typical
900
17.5
-18
-7
+28.7
+43
+23
7
+5 V @ 250 mA
Absolute Maximum Rating
Parameter
Rating
Operating Case Temperature
-40 to +85 qC
Storage Temperature
-65 to +150 qC
RF Input Power (continuous)
+22 dBm
Device Voltage
+8 V
Device Current
400 mA
Device Power
2W
Junction Temperature
+250 qC
Operation of this device above any of these parameters may cause permanent damage.
Ordering Information
Part No.
AH116-S8G
AH116-S8PCB900
Description
½ Watt, High Linearity InGaP HBT Amplifier
(lead-free/green/RoHS-compliant SOIC-8 Pkg)
900 MHz Evaluation Board
Specifications and information are subject to change without notice
WJ Communications, Inc   Phone 1-800-WJ1-4401   FAX: 408-577-6621   e-mail: [email protected]   Web site: www.wj.com
Page 1 of 4 April 2006

PagesPages 4
Télécharger [ AH116 ]


Fiche technique recommandé

No Description détaillée Fabricant
AH11 High Dynamic Range Dual Amplifier WJ Communication
WJ Communication
AH11 High Dynamic Range Dual Amplifier TriQuint Semiconductor
TriQuint Semiconductor
AH110 High Linearity InGaP HBT Amplifier WJ Communication
WJ Communication
AH114 High Linearity InGaP HBT Amplifier WJ Communication
WJ Communication

US18650VTC5A

Lithium-Ion Battery

Sony
Sony
TSPC106

PCI Bus Bridge Memory Controller

ATMEL
ATMEL
TP9380

NPN SILICON RF POWER TRANSISTOR

Advanced Semiconductor
Advanced Semiconductor


www.DataSheetWiki.com    |   2020   |   Contactez-nous  |   Recherche