DataSheetWiki


ENH057Q1-600 fiches techniques PDF

WEDC - (ENH057Q1-xxx) Color TFT-LCD Module Features GENERAL DESCRIPTION

Numéro de référence ENH057Q1-600
Description (ENH057Q1-xxx) Color TFT-LCD Module Features GENERAL DESCRIPTION
Fabricant WEDC 
Logo WEDC 





1 Page

No Preview Available !





ENH057Q1-600 fiche technique
www.DataSheet4U.com
White Electronic Designs
Display Systems Division
ENH057Q1-350/450/600
ENH057Q1-350/450/600 Color TFT-LCD Module Features
GENERAL DESCRIPTION
Panelview provides optically enhanced solutions to the
standard Sharp LQ057Q3DC02 color active matrix LCD
module. The first enhancement is an index matching (IM)
film lamination to the front surface of the display polarizer.
The IM film is available in two surface treatments - IM/Clear
and IM/110 (a 10% diffusion).The second enhancement is
the incorporation of a reflective polarizer (RP) to improve
brightness by up to 40%. The third enhancement is
the addition of prism films (RPp) further increasing the
brightness of the display. The module is composed of a
color TFT-LCD panel, driver ICs, control circuit, power
supply circuit and a backlight unit. Graphics and text can
be displayed on a 320 X 3 X 240 dot panel with 262,
144 color by supplying 18 bit data signal (6bit/color), four
timing signals.
The TFT-LCD panel used for this module is a low-reflection
and higher-color-saturation type. Therefore, this module
is also suitable for multimedia use. Viewing angle is 12
o'clock direction. This module is the type of wide viewing
angle and high brightness 350cd/m2. It has horizontal
display mode and vertical display mode.
Backlight-driving DC/AC inverter is not built in this
module.
Panelview assumes no responsibility for any damage
resulting from the use of the device which does not
comply with the instructions and the precautions specified
in these specification sheets. Panelview does assume the
responsibility for the warranty of the enhanced product.
Parameter
Display size
Active area
Pixel format
Pixel pitch
Pixel configuration
Display mode
Unit outline dimensions (1)
Mass
Surface treatment
Note:
1. Excluding backlight cables.
MECHANICAL SPECIFICATIONS
Specifications
14.4 (5.7") Diagonal
115.2 (H) x 86.4 (V)
320 (H) x 240 (V)
(1 pixel=R+G+B dots)
0.360 (H) x 0.360 (V)
R,G,B vertical stripe
Normally white
144.0 (W) x 104.6 (H) x 13.0(D)
220 ± 20
IM/Clear (glossy) or IM/110 and hardcoat 3H
Units
cm
mm
pixel
-
mm
-
-
mm
g
-
Note: This measurement is typical, and see Fig. 3 for details.
White Electronic Designs Corp. reserves the right to change products or specifications without notice.
Original specifications created by Sharp.
September 2003
Rev. 0
1 Display Systems Division • Hillsboro, OR • (503) 690-2460 • www.wedc.com

PagesPages 16
Télécharger [ ENH057Q1-600 ]


Fiche technique recommandé

No Description détaillée Fabricant
ENH057Q1-600 (ENH057Q1-xxx) Color TFT-LCD Module Features GENERAL DESCRIPTION WEDC
WEDC

US18650VTC5A

Lithium-Ion Battery

Sony
Sony
TSPC106

PCI Bus Bridge Memory Controller

ATMEL
ATMEL
TP9380

NPN SILICON RF POWER TRANSISTOR

Advanced Semiconductor
Advanced Semiconductor


www.DataSheetWiki.com    |   2020   |   Contactez-nous  |   Recherche