DataSheet39.com

What is LM27965?

This electronic component, produced by the manufacturer "National Semiconductor", performs the same function as "Dual Display White LED Driver with I2C Compatible Brightness Control".


LM27965 Datasheet PDF - National Semiconductor

Part Number LM27965
Description Dual Display White LED Driver with I2C Compatible Brightness Control
Manufacturers National Semiconductor 
Logo National Semiconductor Logo 


There is a preview and LM27965 download ( pdf file ) link at the bottom of this page.





Total 13 Pages



Preview 1 page

No Preview Available ! LM27965 datasheet, circuit

www.DataSheet4U.com
May 2006
LM27965
Dual Display White LED Driver with I2C Compatible
Brightness Control
General Description
Features
The LM27965 is a highly integrated charge-pump-based
dual-display LED driver. The device can drive up to 9 LEDs
in parallel with a total output current of 180mA. Regulated
internal current sinks deliver excellent current and brightness
matching in all LEDs.
The LED driver current sinks are split into three indepen-
dently controlled groups. The primary group can beconfig-
urabled with 4 or 5 LEDs, for backlighting a larger main
display and the second group can be configured with 2 or 3
LEDs, for backlighing a smaller secondary display. An addi-
tional, independently controlled led driver is provided for
driving an indicator or general purpose LED. The LM27965
has an I2C compatible interface that allows the user to
independently control the brightness on each bank of LEDs.
n 91% Peak LED Drive Efficiency
n No Inductor Required
n 0.3% Current Matching
n Drives LEDs with up to 30mA per LED
n 180mA of total drive current
n I2C Compatible Brightness Control Interface
n Adaptive 1x - 3/2x Charge Pump
n Resistor-Programmable Current Settings
n External Chip RESET Pin
n Extended Li-Ion Input: 2.7V to 5.5V
n Small low profile industry standard leadless package,
LLP 24 : (4mm x 4mm x 0.8mm)
n 25mm2 total solution size
The device provides excellent efficiency without the use of
an inductor by operating the charge pump in a gain of 3/2, or Applications
in Pass-Mode. The proper gain for maintaining current regu-
lation is chosen based on LED forward voltage, so that
efficiency is maximized over the input voltage range.
The LM27965 is available in National’s small 24-pin Lead-
n Mobile Phone Display Lighting
n PDA Backlighting
n General LED Lighting
less Leadframe Package (LLP-24).
DataSheet4U.com
Typical Application Circuit
DataShee
DataSheet4U.com
© 2006 National Semiconductor Corporation
DS201550
20155001
www.national.com

line_dark_gray
LM27965 equivalent
www.DataSheet4U.com
Electrical Characteristics (Notes 2, 8) (Continued)
Note 11: For the two groups of current sinks on a part (BankA and BankB), the following are determined: the maximum sink current in the group (MAX), the minimum
sink current in the group (MIN), and the average sink current of the group (AVG). For each group, two matching numbers are calculated: (MAX-AVG)/AVG and
(AVG-MIN)/AVG. The largest number of the two (worst case) is considered the matching figure for the bank. The matching figure for a given part is considered to
be the highest matching figure of the two banks. The typical specification provided is the most likely norm of the matching figure for all parts.
Note 12: For each Dxx pin, headroom voltage is the voltage across the internal current sink connected to that pin. For Group A, B, and C current sinks, VHRx = VOUT
-VLED. If headroom voltage requirement is not met, LED current regulation will be compromised.
Note 13: SCL and SDIO signals are referenced to VIO and GND for minimum VIO voltage testing.
Note 14: SCL and SDIO should be glitch-free in order for proper brightness control to be realized.
Block Diagram
et4U.com
DataSheet4U.com
DataShee
20155003
DataSheet4U.com
5 www.national.com


line_dark_gray

Preview 5 Page


Part Details

On this page, you can learn information such as the schematic, equivalent, pinout, replacement, circuit, and manual for LM27965 electronic component.


Information Total 13 Pages
Link URL [ Copy URL to Clipboard ]
Download [ LM27965.PDF Datasheet ]

Share Link :

Electronic Components Distributor


An electronic components distributor is a company that sources, stocks, and sells electronic components to manufacturers, engineers, and hobbyists.


SparkFun Electronics Allied Electronics DigiKey Electronics Arrow Electronics
Mouser Electronics Adafruit Newark Chip One Stop


Featured Datasheets

Part NumberDescriptionMFRS
LM2796The function is Dual-Display White LED Driver with 3/2x Switched Capacitor Boost. National SemiconductorNational Semiconductor
LM2796The function is LM2796 Dual-Display White LED Driver with 3/2x Switched Capacitor Boost (Rev. A). Texas InstrumentsTexas Instruments
LM27961The function is LM27961 Dual-Display White LED Driver with 3/2x Switched Capacitor Boost (Rev. A). Texas InstrumentsTexas Instruments

Semiconductors commonly used in industry:

1N4148   |   BAW56   |   1N5400   |   NE555   |  

LM324   |   BC327   |   IRF840  |   2N3904   |  



Quick jump to:

LM27     1N4     2N2     2SA     2SC     74H     BC     HCF     IRF     KA    

LA     LM     MC     NE     ST     STK     TDA     TL     UA    



Privacy Policy   |    Contact Us     |    New    |    Search