|
|
PDF N1500 Data sheet ( Hoja de datos )
| Número de pieza | N1500 | |
| Descripción | output 1500 and 2000 Watt AC/DC high wattage power supplies | |
| Fabricantes | Artesyn Technologies | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de N1500 (archivo pdf) en la parte inferior de esta página. Total 4 Páginas | ||
|
No Preview Available !
www.DataSheet4U.com
N1500 and N2000 SERIES
Single, and dual output
[ 2 YEAR WARRANTY ]
• Active harmonic correction to EN61000-3-2
• 180VAC to 264VAC input voltage range
• Flexible output voltage configuration
• Two output power ratings
• Forced current sharing, all outputs
• DC OK (including LED)
• UL, CSA and TÜV safety approvals
• Industry standard 5 x 8 x 11 inch footprint
The N1500 and N2000 series are a range of system-orientated, single or dual output
power supplies with output powers of 1500W and 2000W. Harmonically corrected, they
operate from 180VAC to 264VAC. World wide safety approvals are standard. Fan
cooled and enclosed in the industry standard 5 x 8 x 11 inch form, the N1500 and N2000
series are an ideal choice when the economy and predictable performance of a
centralized system power supply are desired. By utilizing dual high current converters,
operating independently or together, a wide variety of output voltage and current
combinations can be factory configured. The N1500 and N2000 extend the range of the
N1000 family. Forced current share provides higher current to satisfy needs in large
systems, or to power expansion chassis. Dual output models at 5VDC/12VDC are
perfect to power mass storage systems. Other applications might use 5VDC/3.3VDC,
both operating at high currents. Single output versions, operating alone or in redundant
mode provide an economic power source for distributed systems. System interface
signals include AC and DC good, current monitor (V1). OVP, OCP, overtemperature
protection, remote enable, margin check inhibit as standard. By combining robust
performance and broad range, the N1500 and N2000 series sets the standard for
centralized system power supplies.
SPECIFICATION All specifications are typical at nominal input, full load at 25°C unless otherwise stated
OUTPUT SPECIFICATIONS (2)
EMC CHARACTERISTICS
Voltage adjustability
Remote sense
Regulation, line or load
Accessible at front panel
±10%
Radiated emissions
Conducted emissions
Open/reverse sense lead protDecattioanSheet4UH.acrommonic distortion
Compensates for voltage drop of up to
Electrostatic discharge
0.5V to the load
RF field susceptibility
All outputs, NL-FL
at nominal line or all
line variations at FL
±0.2%;
10mV min.
Electrical fast
transients/bursts
Surge susceptibility
EN55022/11, FCC part 15
EN55022/11, FCC part 15
EN61000-3-2
EN61000-4-2
EN61000-4-3
EN61000-4-4
EN61000-4-5
Cross regulation
0.2% max. or 10mV between outputs
GENERAL SPECIFICATIONS
Level A
Level A
Conforms
Level 3
Level 3
Level 3
DataShee
Level 3
Overshoot/undershoot
None at turn-on/off
Hold-up time
180VAC, 2kW load
15ms min.
Transient response
Main output
25% step load
change at 1A/µs
Temperature coefficient
≤2.0% max. dev.,
≤200µs recovery
to 1.0%
±0.02%/°C
Efficiency
Isolation voltage
230VAC, full load
Input/output
Input/chassis
Output/output
73%
3000VAC
1500VAC
500VAC
Ripple and noise
0Hz to 20MHz 50mV pk-pk or 1.0%
Switching frequency
100kHz
Overvoltage protection Reset by cycling AC
115 to 130%
of nominal
Approvals and
standards
EN60950, UL1950,
CSA C22.2 No. 950
Overload protection
105-115% full load
Short circuit protection All outputs
Auto recovery
Thermal protection
Auto shutdown, AC reset
Current sharing
±5.0%
50% to 100% load
Current monitor (V1) 5VDC at full load
±0.5V
Weight
6.9kg (15Ibs)
Size 5 x 8 x 11 inches
127 x 203.2 x 279.4 mm
MTBF
per MIL-HDBK-217E 100,000 hours
ENVIRONMENTAL SPECIFICATIONS
INPUT SPECIFICATIONS
Input voltage range
180 to 264VAC
Input frequency range
47Hz to 63Hz
Input surge current
Meets IEEE std. 587.1980;
3KV ring wave
Input current
DataSheet4PUow.ceor mfactor
230VAC, 2000W
230VAC, 2kW load
13A
0.98 min.
Thermal performance
Cooling
Relative humidity
Altitude
Vibration
Operating ambient
Non-operating
0°C to +50°C
-15°C to +85°C
60CFM Internal DC ball bearing fan
Non-condensing
0% to 95% RH
Operating
Non-operating
6,000 feet max.
55,000 feet max.
5Hz to 500Hz
2.4G rms peak
Power up time
Full load
1.0s max.
PAGE 1
DataSheet4 U .com
1 page | ||
| Páginas | Total 4 Páginas | |
| PDF Descargar | [ Datasheet N1500.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| N1500 | output 1500 and 2000 Watt AC/DC high wattage power supplies | Artesyn Technologies |
| N150P2-L04 | LCD Module |  ID Tech |
| N150P2-L06 | TFT LCD Module |  CMI MEI |
| N150P3-L01 | TFT LCD Module | CMI MEI |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |