|
|
Número de pieza | FT-1000MP | |
Descripción | Mark-V Transceiver | |
Fabricantes | Yaesu | |
Logotipo | ||
Hay una vista previa y un enlace de descarga de FT-1000MP (archivo pdf) en la parte inferior de esta página. Total 8 Páginas | ||
No Preview Available ! www.DataSheet4U.com
MARK-VHF 200W ALL MODE TRANSCEIVER
FT-1000MP
1 page www.DataSheet4U.com
As the world enters a new millennium,
new chapter in the history books, with
Photo shows optional MD-100A8X Deluxe Desk Microphone
■ Easy-Acce ss "SPLIT" Operation
When seconds count in a DX pile-up, the convenience
of the MARK-V’s "SPLIT" operating mode can’t be
beat! The "RX" (green) and "TX" (red) LEDs above the
Main and Sub VFO tuning dials are actually combination
LED/Switches; pressing the Sub VFO’s "TX" LED
automatically shifts the transmitter to control by the
Sub VFO, with receiver control still on the Main
VFO. Pressing the Sub VFO’s "RX" LED activates
Dual Receive, so you’re listening on both VFOs,
while transmitting on the Sub VFO. It’s easy, it’s
intuitive, and it’s quick!
INDUSTRY-LEADING RF FRONT
END DESIGN
DX-pedition and Contest operators alike have
acclaimed the strong-signal performance
and antenna selection convenience of the
FT-1000D/FT-1000MP. This legacy is
renewed in the MARK-V FT-1000MP!
■ Two TX/RX Antenna Ports plus Receive-only
Antenna Line Jacks
The "A" and "B" antenna jacks allow connection of
different antennas, which may be selected using the
front panel’s A/ B switch. The antenna selected on
a particular VFO/memory and band will be preserved
in that VFO or memory register, and will be automatically
recalled when you return to that VFO or memory. The RX
"In" and "Out" jacks allow connection of a Beverage
or loop receiving antenna, and may also be used to
connect a special receive-line filter, if desired.
■ Three RF Preamplifier Modes plus IPO
(Direct Mixer Feed)
The wide variations in noise and signal levels on the
HF bands demand a customized approach to receiver
front end gain. The MARK-V provides separate, optimized
preamplifiers for the Low (7 MHz and below), Mid
(10 ~ 21 MHz), and High (24.89 MHz and up) HF
bands. If front end preamplification is not needed,
pressing the IPO (Intercept Point Optimization)
button will bypass the RF preamp stage, routing the
RF energy directly to the first mixer, and increasing
the 3rd-order
Intercept Point
accordingly.
ANT A ANT B
RX ON
RX OFF
ANTENNA SWITCHING
TX
RX ONLY ANTENNA
RX
FIX ANT JACK
IN
OUT
EXT RCVR
FILTER OR
PREAMP
■ Four-Level Input RF Attenuator
For fine-tuning the front-end gain, or for comfortable
listening to extremely strong local signals, the Attenuator
circuit provides 6/12/18 dB of gain reduction (plus "Off").
■ RF GAIN Control
For precise setting of the background noise level, or
for modifying the receiver’ s AGC threshold, the front
panel’ s RF GAIN control is conveniently located on
the same shaft as the main receiver’ s AF GAIN control.
■ AUTO-AGC
For ease in operation, the "AUTO" AGC mode provides
mode-specific selection of the receiver recovery time
for the Automatic Gain Control system. Manual selections
of FAST, SLOW, and OFF are also provided.
5 Page |
Páginas | Total 8 Páginas | |
PDF Descargar | [ Datasheet FT-1000MP.PDF ] |
Número de pieza | Descripción | Fabricantes |
FT-1000MP | Mark-V Transceiver | Yaesu |
FT-1000MP | Mark-V | Yaesu |
Número de pieza | Descripción | Fabricantes |
SLA6805M | High Voltage 3 phase Motor Driver IC. |
Sanken |
SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
Analog Devices |
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |