DataSheetWiki


ICS9148-10 fiches techniques PDF

Integrated Circuit Systems - Pentium/ProTM System Clock Chip

Numéro de référence ICS9148-10
Description Pentium/ProTM System Clock Chip
Fabricant Integrated Circuit Systems 
Logo Integrated Circuit Systems 





1 Page

No Preview Available !





ICS9148-10 fiche technique
Integrated
Circuit
Systems, Inc.
ICS9148-10
Pentium/ProTM System Clock Chip
General Description
The ICS9148-10 is a Clock Synthesizer chip for Pentium and
PentiumPro CPU based Desktop/Notebook systems that will
provide all necessary clock timing.
Features include four CPU and eight PCI clocks. Three
reference outputs are available equal to the crystal frequency.
Additionally, the device meets the Pentium power-up
stabilization requirement, assuring that CPU and PCI clocks
are stable within 2ms after power-up.
PD# pin enables low power mode by stopping crystal OSC
and PLL stages. Other power management features include
CPU_STOP#, which stops CPU (0:3) clocks, and PCI_STOP#,
which stops PCICLK (0:6) clocks.
High drive CPUCLK outputs typically provide greater than 1
V/ns slew rate into 20pF loads. PCICLK outputs typically
provide better than 1V/ns slew rate into 30pF loads while
maintaining 50±5% duty cycle. The REF clock outputs
typically provide better than 0.5V/ns slew rates.
The ICS9148-10 accepts a 14.318MHz reference crystal or
clock as its input and runs on a 3.3V core supply.
Block Diagram
Features
• Generates system clocks for CPU, IOAPIC, PCI, plus
14.314 MHz REF (0:2), USB, and Super I/O
• Supports single or dual processor systems
• Supports Spread Spectrum modulation for CPU & PCI
clocks, down spread -1%
• Skew from CPU (earlier) to PCI clock (rising edges for
100/33.3MHz) 1.5 to 4ns
• Two fixed outputs at 48MHz.
• Separate 2.5V and 3.3V supply pins
• 2.5V or 3.3V output: CPU, IOAPIC
• 3.3V outputs: PCI, REF, 48MHz
• No power supply sequence requirements
• Uses external 14.318MHz crystal, no external load cap
required for CL=18pF crystal
• 48 pin 300 mil SSOP
Pin Configuration
48-Pin SSOP
Power Groups
VDD = Supply for PLL core
VDD1 = REF (0:2), X1, X2
VDD2 = PCICLK_F, PCICLK (0:6)
VDD3 = 48MHz0, 48MHz1
VDDL1 = IOAPIC (0:1)
VDDL2 = CPUCLK (0:3)
9148-10 Rev D 9/27/99
Ground Groups
GND = Ground for PLL core
GND1 = REF (0:2), X1, X2
GND2 = PCICLK_F, PCICLK (0:6)
GND3 = 48MHz0, 48MHz1
GNDL1=IOAPIC(0:1)
GNDL2 = CPUCLK (0:3)
Pentium is a trademark on Intel Corporation.
ICS reserves the right to make changes in the device data identified in this
publication without further notice. ICS advises its customers to obtain the latest
version of all device data to verify that any information being relied upon by the
customer is current and accurate.

PagesPages 12
Télécharger [ ICS9148-10 ]


Fiche technique recommandé

No Description détaillée Fabricant
ICS9148-10 Pentium/ProTM System Clock Chip Integrated Circuit Systems
Integrated Circuit Systems
ICS9148-11 Frequency Generator & Integrated Buffers Integrated Circuit Systems
Integrated Circuit Systems
ICS9148-111 Frequency Generator & Integrated Buffers Integrated Circuit Systems
Integrated Circuit Systems
ICS9148-12 Pentium/ProTM System Clock Chip Integrated Circuit Systems
Integrated Circuit Systems

US18650VTC5A

Lithium-Ion Battery

Sony
Sony
TSPC106

PCI Bus Bridge Memory Controller

ATMEL
ATMEL
TP9380

NPN SILICON RF POWER TRANSISTOR

Advanced Semiconductor
Advanced Semiconductor


www.DataSheetWiki.com    |   2020   |   Contactez-nous  |   Recherche