|
|
Número de pieza | DMF-5001ny-ly-aie | |
Descripción | LCD_Module | |
Fabricantes | OPTREX | |
Logotipo | ||
Hay una vista previa y un enlace de descarga de DMF-5001ny-ly-aie (archivo pdf) en la parte inferior de esta página. Total 17 Páginas | ||
No Preview Available ! .
LCD aMtodauSle hSpeeceifitc4atiUon
First Edition
Jul 13, 1999
Final Revision
*******
Approved by
Checked by
Checked by
Prepared by
Production Div.
Quality Assurance Div.
Design Engineering Div.
Production Div.
Type No. DMF5001NY-LY-AIE
w w . D o mTable of Contents
w c1. General Specifications .............................................................................2
.2. Electrical Specifications...........................................................................3
3. Optical Specifications ..............................................................................7
U4. I/O Terminal.............................................................................................9
5. Test..........................................................................................................11
46. Appearance Standards............................................................................12
t7. Code System of Production Lot ..........................................................15
8. Type Number..........................................................................................15
e9. Applying Precautions .............................................................................15
10. Precautions Relating Product Handling................................................16
e11. Warranty..................................................................................................17
hRevision History
w w w . D a t a S h e e t 4 URev. Date
Page
Comment
ataS
.D
w
w
DMF5001NY-LY-AIE (AT) No.99-0198
wOPTREX CORPORATION
OPTREX
Page 1/17
1 page 2.4.Power Supply ON/OFF Sequence
2.4.1.ON Sequence
SIGNAL
VDD
SIGNAL
(Without RESET and
HALT Signal)
VCONT
VEE
0≦t
0≦t
2.4.2.OFF Sequence
LEVEL
VDD
VSS
VDD
VSS
VDD
VSS
VCONT
VEE
0≦t
0≦t
LEVEL
VDD
VSS
VDD
VSS
VDD
VSS
VCONT
VEE
SIGNAL
VDD
SIGNAL
(Without RESET and
HALT Signal)
VCONT
VEE
2.4.3.Reset Sequence
SIGNAL
RESET T>250μs
HALT
T≧10 ms
T≧0
VDD
VCONT
T≧50ms
T≧0
T≧50ms
T≧0
Power On
Reset
Reset Cancellation
Power Off
LEVEL
H Level
L Level
VDD
VSS
VDD
VCONT
Please maintain the above sequence when turning on and off the power supply of the module.
If VEE and/or VCONT is supplied to the module while internal alternate signal for LCD driving
(M) is unstable or RESET and HALT is active, DC component will be supplied to the LCD
panel. This may cause damage to the LCD module.
DMF5001NY-LY-AIE (AT) No.99-0198
OPTREX CORPORATION
OPTREX
Page 5/17
5 Page 5 . Te s t
No change on display and in operation under the following test condition.
No. Parameter
1 High Temperature Operating
2 Low Temperature Operating
3 High Temperature Storage
4 Low Temperature Storage
5 Damp Proof Test
6 Vibration Test
7 Shock Test
Conditions
50℃±2℃, 96hrs (operation state)
0℃±2℃, 96hrs (operation state)
60℃±2℃, 96hrs
-20℃±2℃, 96hrs
40℃±2℃, 90~95%RH, 96hrs
Total fixed amplitude : 1.5mm
Vibration Frequency : 10~55Hz
One cycle 60 seconds to 3 directions of X, Y, Z for
each 15 minutes
To be measured after dropping from 60cm high on
the concrete surface in packing state.
Notes
3
4
3, 4
3, 4
5
E
B
Dropping method corner dropping
F A corner : once
GD C
Edge dropping
B,C,D edge : once
A
60cm
Face dropping
E,F,G face : once
Concrete Surface
Note 1 : Unless otherwise specified, tests will be conducted under the following condition.
Temperature : 20±5℃
Humidity : 65±5%
Note 2 : Unless otherwise specified, tests will be not conducted under functioning state.
Note 3 : No dew condensation to be observed.
Note 4 : The function test shall be conducted after 4 hours storage at the normal temperature and humidity
after removed from the test chamber.
Note 5 : Vibration test will be conducted to the product itself without putting it in a container.
DMF5001NY-LY-AIE (AT) No.99-0198
OPTREX CORPORATION
OPTREX
Page 11/17
11 Page |
Páginas | Total 17 Páginas | |
PDF Descargar | [ Datasheet DMF-5001ny-ly-aie.PDF ] |
Número de pieza | Descripción | Fabricantes |
DMF-5001ny-ly-aie | LCD_Module | OPTREX |
Número de pieza | Descripción | Fabricantes |
SLA6805M | High Voltage 3 phase Motor Driver IC. |
Sanken |
SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
Analog Devices |
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |