|
|
Número de pieza | IN74HC123A | |
Descripción | Dual Monostable Multivibrator with Reset | |
Fabricantes | IK Semiconductor | |
Logotipo | ||
Hay una vista previa y un enlace de descarga de IN74HC123A (archivo pdf) en la parte inferior de esta página. Total 7 Páginas | ||
No Preview Available ! TECHNICAL DATA
IN74HC123A
Dual Retriggerable Monostable
Multivibrator
The IN74HC123A is identical in pinout to the LS/ALS123. The
device inputs are compatible with standard CMOS outputs; with pullup
resistors, they are compatible with LS/ALSTTL outputs.
There are two trigger inputs, A INPUT (negative edge) and
B INPUT (positive edge). These inputs are valid for rising/falling signals.
The device may also be triggered by using the CLR input (positive-
edge) because of the Schmitt-trigger input; after triggering the output
maintains the MONOSTABLE state for the time period determined by the
external resistor RX and capacitor CX. Taking CLR low breaks this
MONOSTABLE STATE. If the next trigger pulse occurs during the
MONOSTABLE period it makes the MONOSTABLE period longer.
• Outputs Directly Interface to CMOS, NMOS, and TTL
• Operating Voltage Range: 3.0 to 6.0 V
• Low Input Current: 1.0 µA
• High Noise Immunity Characteristic of CMOS Devices
ORDERING INFORMATION
IN74HC123AN Plastic
IN74HC123AD SOIC
TA = -55° to 125° C for all packages
PIN ASSIGNMENT
LOGIC DIAGRAM
PIN 16 =VCC
PIN 8 = GND
Note
(1) CX, RX, DX are external components.
(2) DX is a clamping diode.
The external capacitor is charged to VCC in the stand-by
state, i.e. no trigger. When the supply voltage is turned off
CX is discharged mainly through an internal parasitic diode.
If CX is sufficiently large and VCC decreases rapidy, there
mwill be some possibility of damaging the I.C. with a surge
ocurrent or latch-up. If the voltage supply filter capacitor is
.clarge enough and VCC decrease slowly, the surge current is
uautomatically limited and damage the I.C. is avoided. The
t4maximum forward current of the parasitic diode is
www.datasheeapproximately 20 mA.
FUNCTION TABLE
Inputs
A B CLR
HH
Outputs
QQ
X L H L* H*
H X H L* H*
LH
LH
XX L L H
X = don’t care
* - except for monostable period
Note
Output
Enable
Inhibit
Inhibit
Output
Enable
Output
Enable
Inhibit
1
1 page IN74HC123A
Figure 1. Switching Waveforms
Figure 2. Switching Waveforms
Figure 3. Test Circuit
5
5 Page |
Páginas | Total 7 Páginas | |
PDF Descargar | [ Datasheet IN74HC123A.PDF ] |
Número de pieza | Descripción | Fabricantes |
IN74HC123 | DUAL RETRIGGERABLE MONOSTABLE MULTIVIBRATOR | ETC |
IN74HC123A | Dual Monostable Multivibrator with Reset | IK Semiconductor |
Número de pieza | Descripción | Fabricantes |
SLA6805M | High Voltage 3 phase Motor Driver IC. |
Sanken |
SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
Analog Devices |
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |