|
|
Número de pieza | SC91415 | |
Descripción | TONE/PULSE SWITCHABLE DIALER WITH LCD INTERFACE AND DUAL-TONE MELODY | |
Fabricantes | Silan Microelectronics | |
Logotipo | ||
Hay una vista previa y un enlace de descarga de SC91415 (archivo pdf) en la parte inferior de esta página. Total 24 Páginas | ||
No Preview Available ! SC91415
T/P SWITCHABLE DIALER WITH LCD INTERFACE AND DUAL-TONE MELODY
DESCRIPTION
The SC91415 is a series of tone/pulse switchable dialers that is
composed of T/P dialer and T/P dialer with 13 set memories. The
SC91415 series provide necessary functions of telephone set for
application in any environment, such as Pulse dialing, Tone (DTMF)
dialing, Handfree dialing, keying tone and lock functions. The lock
function is designed to inhibit toll dialing operation. Beside this, melody
generator, ring detector and SDO (Serial Data Output) functions are
provided in advance version. Melody generator will output dual-tone
music in line hold duration. Ring detector can prevent illegal dialing from
pocket dialer. The SDO is designed to drive LCD driver and voice
synthesizer.
FEATURES
ORDERING INFORMATION
* Tone/Pulse switchable
* Wide operating voltage from 2.0 V to 5.5 V
* Low operating current, 0.15mA (Pulse) and 0.3mA (Tone) typically
* Adding resistor on keyboard scan pin that can select many tele-
phone specifications, such as: Pulse rate, M/B ratio, Flash time, lock
dialing functions.
* Lock function provides conventionality key lock and password lock
operations
* Ring detector is designed to prevent illegal dialing from pocket dialer
* 13 set one touch or (3 set one touch and 10 set two touch) repertory
memory, each one can hold data up to 16 digits
* A 32-digit LNB (last number) redial memory
* Handfree function provides on-hook dialing and speakerphone
application
* Pause and P-T time are fixed to 3.6 seconds
* Tone duration and inter-tone pause time are fixed to 98 ms
* Using 3.579545 MHz crystal or ceramic resonator
Device
SC91415AP
SC91415BP
SC91415CK
SC91415DK
Package
DIP-18-300-2.54
DIP-20-300-2.54
SDIP-22-300-2.54
SDIP-24-300-2.54
* SDO function supports LCD driver
and voice synthesizer to indicate
dialing numbers.
* Line hold function is designed for
stopping conversation temporality
* Melody generator provides music
on hold function
* Keytone function provides rapidly
keying recognition
VERSIONS LIST AND FUNCTION OUTLINE
Version
LNB
KT
HOLD
(music)
LOCK
HF
SDO
(LCD)
PDP
SC91415A
SC91415B
SC91415C
SC91415D
Note: PDP = Pocket Dialer Prevented
HANGZHOU SILAN MICROELECTRONICS CO.,LTD
Http: www.silan.com.cn
REV:2.0 2004.08.03
Page 1 of 24
1 page SC91415
(Continued)
Characteristics
Pulse Rate
Make/Break Ratio
Inter-digit Pause Time
DTMF pin: Sink Current
DTMF signal DC level
AC Level
DTMF Pre-emphase
signal Distortion
Load Resistance
Minimum tone duration Time
Minimum Intertone Pause Time
Symbol
Test Conditions
Row1=R-VDD
PSR
Row1=R-VSS
Row2=NR
MBR
Row2=R-VSS
PSR=10pps
Tidp
PSR=20pps
IoL Vdtmf=0.5V
Vdc VDD=2.0V~5.5V
Vdtmf Row group
Twist Column –Row
THD RL=5kΩ
ZL THD<-23db
Tp --
tITP Memory dialing
Melody
Output
Signal
Main Tone AC Level
Sub-tone
Vmtac VDD=2.0V~5.5V
Vstac VDD=2.0V~5.5V
HD key release hold function
debounce time
SDO every bit time
Off-Hook delay time
Thdrdb --
Tbit --
Tdly --
Min.
--
--
--
--
--
--
-0.2
0.5
142
1
--
5
96
96
--
48
--
37
Typ.
20
10
40:60
33:66
800
500
--
--
160
2
-30
--
98
98
-23.3
53
-25.3
42
Max.
--
--
--
--
--
--
--
0.75
180
3
-23
--
100
100
--
58
--
47
Unit
pps
%
ms
mA
V
mV
dB
dB
kΩ
ms
ms
(dBm)
mV
(dBm)
mV
-- 280 -- ms
3.8 3.9 4.1 ms
-- 300 -- ms
DTMF FREQUENCY OUTPUT (fosc=3.579545MHz)
Keyboard Scanning Pin
ROW1 (f1)
ROW2 (f2)
ROW3 (f3)
ROW4 (f4)
COL1 (f5)
COL2 (f6)
COL3 (f7)
CCITT Standard(Hz)
697
770
852
941
1209
1336
1477
Actual Output
699.1
766.2
847.4
947.9
1215.8
1331.6
1471.8
Deviation(%)
+0.30
-0.49
-0.53
+0.73
+0.56
-0.32
-0.35
HANGZHOU SILAN MICROELECTRONICS CO.,LTD
Http: www.silan.com.cn
REV:2.0 2004.08.03
Page 5 of 24
5 Page SC91415
The dummy number “3”is not detected by the centered office or PABX ,but the following numbers “0”,1,2,3...
long distance call can be dialed out normally since the leading number “3”is not the Lock-number defined in
SC91415 series. To prevent the unavoidable long distance call, then SC91415 inhibits the key entry during Tdly.
F) Operating flow chart
Note : HF= Handfree,HD = Hold
Truth table
Operating State
HKS
Input / Output pin level
PO
XMUTE
HFO
(0) on-hook, idle state
H
F
F
L
(1) Off-hook line
LFFL
(2) Off-hook, HF line L F F H
(3) On-hook, HF line H F F H
(4) Off-hook, HD line L F L L
(5) On-hook, HD line H F L L
Note : F = floating (high impedance); H = logic “High”; L = logic “Low”level.
HDO
L
L
L
L
H
H
G) Music on Hold
SC91415 series built-in a melody generator to generate dual-tone music on DTMF output pin. The music is
designed for telephone line at line holding.
H) SDO (Serial Data Output) function
The SDO is serial data output which format is same as UART protocol. SDO function is designed to drive LCD
driver and voice synthesizer. So the dialing numbers can be display on LCD screen with SC32100 (or SC32116).
The SDO signal consists of two start bits, six data bits and two stop bits. Each bit time is about 3.9 ms (256 Hz)
and output sequences are following by start bits, data bits (LSB to MSB) and stop bits.
ready
01
start bits
bit0 bit1 bit2 bit3 bit4 bit5
data bits
01
stop bits
HANGZHOU SILAN MICROELECTRONICS CO.,LTD
Http: www.silan.com.cn
REV:2.0 2004.08.03
Page 11 of 24
11 Page |
Páginas | Total 24 Páginas | |
PDF Descargar | [ Datasheet SC91415.PDF ] |
Número de pieza | Descripción | Fabricantes |
SC91415 | TONE/PULSE SWITCHABLE DIALER WITH LCD INTERFACE AND DUAL-TONE MELODY | Silan Microelectronics |
Número de pieza | Descripción | Fabricantes |
SLA6805M | High Voltage 3 phase Motor Driver IC. |
Sanken |
SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
Analog Devices |
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |