|
|
Número de pieza | LM309 | |
Descripción | 5-Volt Regulator | |
Fabricantes | National Semiconductor | |
Logotipo | ||
Hay una vista previa y un enlace de descarga de LM309 (archivo pdf) en la parte inferior de esta página. Total 8 Páginas | ||
No Preview Available ! April 1998
LM109/LM309
5-Volt Regulator
General Description
The LM109 series are complete 5V regulators fabricated on
a single silicon chip. They are designed for local regulation
on digital logic cards, eliminating the distribution problems
association with single-point regulation. The devices are
available in two standard transistor packages. In the
solid-kovar TO-5 header, it can deliver output currents in ex-
cess of 200 mA, if adequate heat sinking is provided. With
the TO-3 power package, the available output current is
greater than 1A.
The regulators are essentially blowout proof. Current limiting
is included to limit the peak output current to a safe value. In
addition, thermal shutdown is provided to keep the IC from
overheating. If internal dissipation becomes too great, the
regulator will shut down to prevent excessive heating.
Considerable effort was expended to make these devices
easy to use and to minimize the number of external compo-
nents. It is not necessary to bypass the output, although this
does improve transient response somewhat. Input bypass-
ing is needed, however, if the regulator is located very far
from the filter capacitor of the power supply. Stability is also
achieved by methods that provide very good rejection of load
or line transients as are usually seen with TTL logic.
Although designed primarily as a fixed-voltage regulator, the
output of the LM109 series can be set to voltages above 5V,
as shown. It is also possible to use the circuits as the control
element in precision regulators, taking advantage of the
good current-handling capability and the thermal overload
protection.
Features
n Specified to be compatible, worst case, with TTL and
DTL
n Output current in excess of 1A
n Internal thermal overload protection
n No external components required
Schematic Diagram
© 1999 National Semiconductor Corporation DS007138
DS007138-1
www.national.com
1 page Typical Performance Characteristics (Continued)
Quiescent Current
Quiescent Current
Output Voltage Noise
DS007138-28
Line Transient Response
DS007138-29
Load Transient Response
DS007138-30
DS007138-31
Typical Applications
Fixed 5V Regulator
DS007138-32
Adjustable Output Regulator
DS007138-2
*Required if regulator is located more than 4" from power supply filter
capacitor.
†Although no output capacitor is needed for stability, it does improve
transient response.
C2 should be used whenever long wires are used to connect to the load,
or when transient response is critical.
Note: Pin 3 electrically connected to case.
DS007138-4
5 www.national.com
5 Page |
Páginas | Total 8 Páginas | |
PDF Descargar | [ Datasheet LM309.PDF ] |
Número de pieza | Descripción | Fabricantes |
LM30 | Diode (spec sheet) | American Microsemiconductor |
LM30-3015PC | Sensors | Greegoo |
LM30-3015PC | Sensors | ETC |
LM30-xxxxx | Sensors | Greegoo |
Número de pieza | Descripción | Fabricantes |
SLA6805M | High Voltage 3 phase Motor Driver IC. |
Sanken |
SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
Analog Devices |
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |