DataSheetWiki


OPL530-OC fiches techniques PDF

ETC - Photologic Sensors

Numéro de référence OPL530-OC
Description Photologic Sensors
Fabricant ETC 
Logo ETC 





1 Page

No Preview Available !





OPL530-OC fiche technique
Product Bulletin OPL530
December 1997
Photologic® Sensors
Types OPL530, OPL530-OC, OPL531, OPL531-OC
Features
Four output options
High noise immunity
Direct TTL/LSTTL CMOS interface
Low cost plastic side-looking package
Mechanically and spectrally matched
to the OP140 and OP240 series LED's
Data rates to 250 kBaud
Low power consumption
Description
The OPL530, OPL530-OC, OPL531,
OPL531-OC contain a monolithic
integrated circuit which incorporates a
photodiode, amplifier, voltage regulator,
Schmitt trigger and an NPN output
transistor on a single silicon chip.
The OPL530 and OPL531 includes a 10
Kpull-up resistor (RL) from output to
VCC. The OPL530-OC and OPL531-OC
have an open-collector output.
These devices exhibit very stable
performance over supply voltages
ranging from 4.5 V to 16 V and a wide
range of irradiance levels.
The Photologic® chip is encapsulated in
a molded plastic package which has an
integral lens for enhanced optical
coupling and minimal optical spacing.
Absolute Maximum Ratings (TA = 25o C unless otherwise noted)
Supply Voltage, VCC . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 18 V
Storage Temperature Range . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -40o C to +100o C
Operating Temperature Range . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -40o C to +85o C
Lead Soldering Temperature Range [1/16 inch (1.6 mm) from case for 5 sec. with
soldering iron] . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 240o C
Power Dissipation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 90 mW
Voltage at Output Lead(4) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 35 V
Sinking Current . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 50 mA
Notes:
(1) Derate linearly 2.67 mW/o C above 70o C.
(2) RMA flux is recommended. Duration can be extended to 10 sec. maximum when flow
soldering. Max 20 grams force may be applied to the leads when soldering.
(3) Irradiance measurements are made with λi = 935 nm.
(4) OC versions only. For ICC on pull-up versions add VCC/10 k.
Schematics
OPL530 Buffer/Pull-up Resistor
VCC
OUT
GND
Light On - Output High
OPL530-OC Buffer/OC
VCC
OPL531 Inverter/Pull-up Resistor
VCC
OUT
GND
Light On - Output Low
OPL531-OC Inverter/OC
VCC
OUT
OUT
Optek Technology, Inc.
1215 W. Crosby Road
GND
Light On - Output High
GND
Light On - Output Low
Carrollton, Texas 75006 (972) 323-2200
Fax (972) 323-2396
4-4

PagesPages 2
Télécharger [ OPL530-OC ]


Fiche technique recommandé

No Description détaillée Fabricant
OPL530-OC Photologic Sensors ETC
ETC

US18650VTC5A

Lithium-Ion Battery

Sony
Sony
TSPC106

PCI Bus Bridge Memory Controller

ATMEL
ATMEL
TP9380

NPN SILICON RF POWER TRANSISTOR

Advanced Semiconductor
Advanced Semiconductor


www.DataSheetWiki.com    |   2020   |   Contactez-nous  |   Recherche