|
|
Número de pieza | LA7852 | |
Descripción | CRT Display Synchronization Deflection Circuit | |
Fabricantes | Sanyo | |
Logotipo | ||
Hay una vista previa y un enlace de descarga de LA7852 (archivo pdf) en la parte inferior de esta página. Total 5 Páginas | ||
No Preview Available ! Ordering number: EN2781B
Monolithic Linear IC
LA7852
CRT Display Synchronization Deflection Circuit
Overview
The LA7852 is a sync-deflection circuit IC dedicated to CRT
display use. It can be connected to the LA7832/7833, 7837/
7838 (for vertical output use) to form a sync-deflection circuit
that meets every requirement for CRT display use.
So far, ICs for color TV use have been applied to the sync-
deflection circuit for CRT display use, and general-purpose ICs
such as one-shot multivibrator, inverter and a lot of transistors
have been used to form the peripherals such as sync input
interface, horizontal phase shifter. The LA7852 contains these
peripherals on chip and adopts a stable circuit for horizontal
oscillation from 15 kHz to 100 kHz aiming at improving the
characteristics required for CRT display use.
The LA7852 has independent GND pins for the horizontal
block and vertical block, thus facilitating pattern layout for
applications where the LA7852 is used at high frequencies.
Package Dimensions
unit : mm
3059-DIP22S
[LA7852]
SANYO : DIP22S
Features
. The vertical pull-in range is approximately 10 Hz at
. fv = 60 Hz.
The horizontal oscillation frequency can be adjusted stably
from 15 kHz to 100 kHz.
. The horizontal display can be shifted right/left.
. The horizontal/vertical sync input can be used intact
. regardless of the difference in pulse polarity and pulse width.
The AFC feedback sawtooth wave can be obtained by
simply applying a flyback pulse to the IC as a trigger pulse.
. Any duty of the horizontal pulse can be set.
. Good vertical linearity because DC bias at vertical output
. stage is subjected to sampling control within retrace time.
Excellent interlace and vertical jitter characteristics on the
high-definition display because of independent GND pins for
the horizontal block and vertical block.
Pd max – Ta
Built-in Functions
Ambient temperature, Ta – °C
[Horizontal Block]
. AFC
. Horizontal OSC
. X-ray protector
. Horizontal phase shift
. AFC sawtooth wave generator
. Horizontal pulse duty setting
[Vertical Block]
. Vertical OSC
. Vertical sawtooth wave generator
. Sampling type DC voltage control
SANYO Electric Co.,Ltd. Semiconductor Bussiness Headquarters
TOKYO OFFICE Tokyo Bldg., 1-10, 1 Chome, Ueno, Taito-ku, TOKYO, 110 JAPAN
81096HA(II)/9138YT/8228YT,TS No.2781-1/5
1 page Sample Application Circuit
14’’ Color Monitor / fv = 60 Hz, fH = 15.734 kHz
LA7852
( ): Negative pulse mode
VR2 is fixed after adjustment
LA7850 Family
Type Number
Package
Differences in
characteristics
Vertical
pull-in range
(fv = 60 Hz)
Ground pin
A05903
LA7850
DIP-20S
(Slim Type)
10 Hz
LA7851
DIP-20S
(Slim Type)
20 Hz
LA7852
DIP-22S
(Shrink Type)
10 Hz
LA7853
DIP-22S
(Shrink Type)
20 Hz
Horizontal/vertical
common
horizontal/vertical
common
Horizontal/vertical
separated
Horizontal/vertical
separated
No products described or contained herein are intended for use in surgical implants, life-support systems, aerospace equipment,
nuclear power control systems, vehicles, disaster/crime-prevention equipment and the like, the failure of which may directly or
indirectly cause injury, death or property loss.
Anyone purchasing any products described or contained herein for an above-mentioned use shall:
1 Accept full responsibility and indemnify and defend SANYO ELECTRIC CO., LTD., its affiliates, subsidiaries and distributors
and all their officers and employees, jointly and severally, against any and all claims and litigation and all damages, cost and
expenses associated with such use:
2 Not impose any responsibility for any fault or negligence which may be cited in any such claim or litigation on SANYO
ELECTRIC CO., LTD., its affiliates, subsidiaries and distributors or any of their officers and employees jointly or severally.
Information (including circuit diagrams and circuit parameters) herein is for example only; it is not guaranteed for volume
production. SANYO believes information herein is accurate and reliable, but no guarantees are made or implied regarding its use
or any infringements of intellectual property rights or other rights of third parties.
This catalog provides information as of August, 1996. Specifications and information herein are subject to change without notice.
No.2781-5/5
5 Page |
Páginas | Total 5 Páginas | |
PDF Descargar | [ Datasheet LA7852.PDF ] |
Número de pieza | Descripción | Fabricantes |
LA7850 | Monolithic Linear IC | Sanyo |
LA7851 | Monolithic Linear IC | Sanyo |
LA7852 | CRT Display Synchronization Deflection Circuit | Sanyo |
LA7853 | Monolithic Linear IC | Sanyo |
Número de pieza | Descripción | Fabricantes |
SLA6805M | High Voltage 3 phase Motor Driver IC. |
Sanken |
SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
Analog Devices |
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |